The square plate is confined within the slots at A and B. When0 = 25°, point A is moving at v₁ = 9 m/s as shown in (Figure 1).Figure0.3 m.VA0.3 m1 of 1 >Part ADetermine the magnitude of the velocity of point D at this instant.Express your answer to three significant figures and include the appropriate units.vd =SubmitPart BOD=SubmitμAValueRequest AnswerProvide FeedbackDetermine the direction angle of the velocity of point D at this instant measured clockwise from the negative à axis.Express your answer in degrees to three significant figures.UnitsVAΣ vecΑΣΦRequest Answerwww?www ?O

Part (A): Write the given data. vA=9 m/sθ=25° Draw the I-center of the square plate.

The square plate is confined within the slots at A and B. When 0 = 25°, point A is moving at V₁ = 9 m/s as shown in (Figure 1). Figure 0.3 m VA D 0.3 m 1 of 1 > ▼ Part A Determine the magnitude of the velocity of point D at this instant. Express your answer to three significant figures and include the appropriate units. vd = UD Part B Submit Request Answer OD= μÀ Value Submit Provide Feedback Determine the direction angle of the velocity of point D at this instant measured clockwise from the negative axis. Express your answer in degrees to three significant figures. V | ΑΣΦ | | | vec | 5 Units Request Answer 2 ? 999 ?

The square plate is confined within the slots at A and B. When 0 = 25°, point A is moving at V₁ = 9 m/s as shown in (Figure 1). Figure 0.3 m VA D 0.3 m 1 of 1 > ▼ Part A Determine the magnitude of the velocity of point D at this instant. Express your answer to three significant figures and include the appropriate units. vd = UD Part B Submit Request Answer OD= μÀ Value Submit Provide Feedback Determine the direction angle of the velocity of point D at this instant measured clockwise from the negative axis. Express your answer in degrees to three significant figures. V | ΑΣΦ | | | vec | 5 Units Request Answer 2 ? 999 ?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Determine the angular velocity, in rpm, of the rotating drum which results in loss of contact between the clothes and the drum at 1.0239 rad. Assume that the small vanes prevent slipping until loss of contact. Round your answer to 2 decimal places
The rod OA rotates in the horizontal plane such that 0.44t3 radian, and collar B is sliding outward along OA so that r=79t2 mm. If in both cases t is in seconds, determine the transverse component of velocity (mm/s) of the collar when the collar is 117 mm from O. Round off only on the final answer expressed in 3 decimal places.
Question 1 The velocity of a particle which moves along the s-axis is given by s˙ = 53 - 8t2 m/s where t is in seconds. Calculate the displacement Δs of the particle during the interval from t = 0.7 s to t = 3.3 s.
A boat is traveling along a circular curve having a radius of 120 ft . Its speed at t = 0 is 16 ft/s and is increasing at v˙=(0.8t)ft/s^2. Determine the magnitude of the boat's acceleration at the instant tt = 5 ss. Express your answer to three significant figures and include the appropriate units
The velocity of aparticle which moves along the x-axis is given by x = 40-3t² (m/s) where t is in seconds. Calculate the displacement Ax of the particle during the interval from t=2sec to = 4 sec.
Q1. A driver enters a curved car at 72 km/h, slows down, causing the speed to drop at a steady rate of 4.5 km/h every second. If the radius of curvature is 16.7 m. Find the acceleration of the car after 4 seconds from the driver starting to slow down.
The rod OA rotates in the horizontal plane such that 0.42t3 radian, and collar B is sliding outward along OA so that r=24t2 mm. If in both cases t is in seconds, determine the magnitude of velocity (mm/s) of the collar when the collar is 94 mm from O. Round off only on the final answer expressed in 3 decimal places.
The horizontal motion of the plunger and shaft is arrested by the resistance of the attached disk which moves through the oil bath. The velocity of the plunger is v0 = 3.8 m/s in the position A where x = 0 and t = 0, and the deceleration is proportional to v so that a = -kv where k = 0.61 s-1. Find (a) the velocity when t = 5.5 s, (b) the position x when t = 5.5 s, (c) the velocity when x = 3.5 m.
If a vehicle is traveling at 51 ft/s and a tire has a circumferential rotating velocity of 54 ft/s, what is the longitudinal slip? Express the percentage in decimal form
The position of a particle in millimeters is given by s = 70 - 17t + t2 where t is in seconds. Plot the s-t and v-t relationships for the first 10 seconds. Determine the net displacement Δs during that interval and the total distance D traveled. By inspection of the s-t relationship, what conclusion can you reach regarding the acceleration?
The cone falling with a speed v0 = 2 m/s strikes and penetrates the block of packing material. The acceleration of the cone after impact is a = g − cy2 where g is acceleration of gravity, c is a positive constant and y is the penetration distance. If the maximum penetration depth is observed to be ym = 0.10 m determine the constant c in 1/ms2.
The velocity of a particle along the s-axis is given by v = 8s9/8 where s is in millimeters and v is in millimeters per second. Determine the acceleration when s is 3.9 millimeters.