The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 ml volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? NA Solution A: 0.123 Solution B: 0.463 O B. Solution A: 0.463 Solution B: 0.234 OC. Solution A: 0.123 Solution B: 0.234 OD. Solution A: 0.234 Solution B: 0.463

The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 ml volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? NA Solution A: 0.123 Solution B: 0.463 O B. Solution A: 0.463 Solution B: 0.234 OC. Solution A: 0.123 Solution B: 0.234 OD. Solution A: 0.234 Solution B: 0.463

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter17: Electrochemistry

Section: Chapter Questions

Problem 80AP

See similar textbooks

Similar questions

Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray contrast agent that aids with the radiologic imaging of the anatomy. One such contrast agent is sodium diatrizoate, a nonvolatile water-soluble compound. A 0.378-m solution is prepared by dissolving 38.4 g sodium diatrizoate (NaDTZ) in.l.60 102 mL water at 3 1.2C (the density of water at 31.2C is 0.995 g/cm3). What is the molar mass of sodium diatrizoate? What is the vapor pressure of this solution if the vapor pressure of pure water at 31.2C is 34.1 torr?
The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 mL volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? A. Solution A: 0.123 Solution B: 0.463 B. Solution A: 0.463 Solution B: 0.234 C. Solution A: 0.123 Solution B: 0.234 D. Solution A: 0.234 Solution B: 0.463
A 25.00mL wastewater sample was analyzed for its Mg2+ content using a standard gravimetric method. the sample was diluted to 3.00L and an 11.00mL aliquot was treated to precipitate magnesium as MgNH4PO4.6H2O using (NH4)2HPO4 as the precipitating agent. the precipitate was then filtered, washed, dried, and ignited resulting in a 0.1325mg Mg2P2O7 residue. How much Mg (in ppm) is present in the original sample
Six 50.0 ml volumetric flask 1 through 6 are labeled. 10.00 ml of 2.00 x 10-1 M Fe(NO3)3 solution was then pipet into each volumetric flask. A 1.00,2.00,3.00,4.00 and 5.00ml of 2.00 x 10-3M NaSCN solution was then pipetted to flask 2 through 6 respectively. A sufficient amount of 0.10 M nitric acid was then added to each flask to make each a total volume of 50.00ml. Hint M1V1=M2V2 a)what would be the concentration of Fe(NO3)3 in 0.10M HNO3? b)what would be the concentration of NaSCN in 0.10M HNO3?
Six 50.0 ml volumetric flask 1-6 are labeled. 10.00 ml of 2.00 x 101 M Fe(NO3)3 solution was then pipet into each volumetric flask. A 1.00,2.00,3.00,4.00 and 5.00ml of 2.00 x 10-3M NaSCN solution was then pipetted to flask 2 through 6 respectively. A sufficient 0.10 M nitric acid was then added to each flask to make them total volume of 50.00ml. 1.a)Calculate the final Fe(NO3)3 concentrations for each. 1.b)Also how would you find the initial concentration of SCN- for each flask? Please show calculations to solutions.Thanks
A concentration of toxic metals in plant tissue is often found by combusting the material in a furnace and then dissolving the ash in concentrated acid. A 0.5124-gram sample of leaves was combusted to ash and transferred to a 150-mL beaker. A 25-mL portion of concentrated HCl was added and the mixture was heated on a hot plate. Three 5-mL portions of concentration HCl were added over approximately 10 minutes with continued heating in between additions. The resulting mixture was cooled to room temperature and filtered into a 50-mL volumetric flask, which was brought to volume using distilled water and mixed well. From this stock solution, a 10-mL portion was pipetted into a clean 50-mL volumetric flask, brought to volume with distilled water, and mixed. This final solution was analyzed and found to contain 12.1 ppm lead. What are the mass percent of lead in the original plant tissue?
Prepare 50ml of approximately 1000ppm Mn stock solution from MnCl2*4H2)
. The total cation content of natural water is often determined by exchanging the cations for hydrogen ions on an ion exchange resin. The cations are adsorbed to the resin which releases H+ (1:1 exchange) which can then be titrated with a base. A 25.0 mL sample of a natural water is diluted to 100 mL with distilled water and 2.0 g of a cation-exchange resin was added. After stirring, the mixture was filtered and the solid remaining on the filter paper was washed with three 15.0 mL portions of distilled water. The filtrate and washing required 15.3 mL of 0.0202 M NaOH to reach the equivalence pt. Calculate the number of moles of cation present in 1.00 L of sample.
Prepare the following solutions: 100.0 mL 0.0500 M stock Ca2+ solution 50.0 mL 0.0050 M working standard Ca2+ solution from 0.0500 M Ca2+
Although other solvents are available, dichloromethane(CH₂Cl₂) is still often used to “decaffeinate” drinks because thesolubility of caffeine in CH₂Cl₂ is 8.35 times that in water.(a) A 100.0-mL sample of cola containing 10.0 mg of caffeine is extracted with 60.0 mL of CH₂Cl₂. What mass of caffeine re-mains in the aqueous phase? (b) A second identical cola sampleis extracted with two successive 30.0-mL portions of CH₂Cl₂.What mass of caffeine remains in the aqueous phase after each extraction? (c) Which approach extracts more caffeine?
Gravimetric analysis of Fe3O4 (MW = 232 g/mole) may be undertaken with the following reactions: Fe3O4 → Fe2O3 → Fe (OH)3. Weight of sample containing 8.00% Fe3O4 that must be taken to obtain a precipitate of Fe(OH)3 (MW = 107 g/mole) that weighs 150 mg is . a. 0.108 g b. 0.325 g c. 1.355 g d. 4.065 g Amount of Fe2O3 (MW = 160 g/mole) from which 150 mg of Fe(OH)3 (MW = 107 g/mole) may be obtained is . a. 0.112 g b. 0.224 g c. 0.448 g d. none of the other choices
An sample of eggshell that weighs 1.0014g and is 51μm thick is titrated with disodium EDTA. A solution of the 1.0014g sample and 30 mL of HCl is vacuum filtered after being mixed. The product of the filtration is added to a 250mL volumetric flask and is diluted by being filled to the 250 mL mark with deionized water. 10 mL of this diluted mixture is mixed with EBT indicator and titrated with 0.05 M disodium EDTA. It takes 12.3 mL of disodium EDTA to notice a change in color. What percent mass of calcium is in the eggshell?