The student collected the following data he prepared solutions ranging from 0.000 to 0.500 ppm and measured the instrumental readingcorresponding to each of the solutions prepared:Yi0.0000.000.10012.360.20024.830.30035.910.40048.790.50060.42Use the method of least squares to calculate the equation of the best straight line going through these pointsii)Calculate the amount of unknown in your sample if the unknown reading is 40.35ii)If blank standard deviation was 0.014. Calculate:1. LOD,

We have to find first equation for given points and then we have to find amount of unknown using…

The student collected the following data he prepared solutions ranging from 0.000 to 0.500 ppm and measured the instrumental reading corresponding to each of the solutions prepared: yi 0.000 0.00 0.100 12.36 0.200 24.83 0.300 35.91 0.400 48.79 0.500 60.42 i) Use the method of least squares to calculate the equation of the best straight line going through these points ii) Calculate the amount of unknown in your sample if the unknown reading is 40.35

The student collected the following data he prepared solutions ranging from 0.000 to 0.500 ppm and measured the instrumental reading corresponding to each of the solutions prepared: yi 0.000 0.00 0.100 12.36 0.200 24.83 0.300 35.91 0.400 48.79 0.500 60.42 i) Use the method of least squares to calculate the equation of the best straight line going through these points ii) Calculate the amount of unknown in your sample if the unknown reading is 40.35

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

ChapterA1: Evaluation Of Analytical Data

Section: Chapter Questions

Problem A1.22QAP

See similar textbooks

Similar questions

Chemistry An aquifer contaminated with petroleum is found to have the following component concentrations at a particular site: benzene158 ppm toluene124 ppm ethylbenzene91 ppm xylene45 ppm n-heptadecane161 ppm pristane 84 ppm Provide an estimate for the age of the spill at this site using (a) BTEX ratio and (b) nC17:Pr ratio. Show your calculations and use units throughout. Give proper s.f. for the answer.
An aquifer contaminated with petroleum is found to have the following component concentrations at a particular site: benzene 158 ppm toluene 124 ppm ethylbenzene 91 ppm xylene 45 ppm n-heptadecane 161 ppm pristane 84 ppm Provide an estimate for the age of the spill at this site using (a) BTEX ratio and (b) nC17:Pr ratio. Show your calculations and use units throughout. Give proper s.f. for the answer.
From the equivalent conductivities at infinite dilution following at 18°C, find the value of Λ° for NH4OH:Ba(OH)2 Λ° = 228.8BaCl2 Λ° = 120.3NH4Cl Λ° = 129.8
I would need help with these questions. The method referenced above was followed by a student and she got the following results: Caffeine Std. Conc. (ppm) Absorbance 100 1.806 50 0.899 40 0.724 30 0.545 20 0.365 10 0.183 Further, she analyzed an unknown sample and she got the following results: Sample # Absorbance 1 0.398 1. Graphically find the concentration in ppm and then calculate in mol/L of Caffeine in Sample #1? 2. Which solvent was used to extract Caffeine and why? Why is it necessary to do extraction three times? 3. Cuvettes used in this experiment were made from which material and why? 4. At what wavelength the Absorbance was measured?
The homogeneity of the chloride level in a water sample from a lake was tested by analyzing portions drawn from the top and from near the bottom of the lake, with the following results in ppm Cl: Apply the t test at the 95% confidence level to determine if the chloride level from the top of the lake is different from that at the bottom.
A student analysed mercury content on a canned tuna. According to EPA standard, the permissible limit of mercury in fish is 0.1 ppm. In this study, an average of 11.4 ± 2.1 ng/g was obtained based on six sample replicates. Suggest a suitable analytical instrument to be used in this analysis and draw a conclusion on the safety of mercury content of this canned tuna.
Here is a use objective for a chemical analysis to be performed at a drinking water purification plant: “Data and results collected quarterly shall be used to determine whether the concentrations of haloacetates in the treated water demonstrate compliance with the levels set by the Stage 1 Disinfection By-products Rule using Method 552.2” (a specification that sets precision, accuracy, and other requirements). Which one of the following questions best summarizes the meaning of the use objective?(i) Are haloacetate concentrations known within specified precision and accuracy?(ii) Are any haloacetates detectable in the water?(iii) Do any haloacetate concentrations exceed the regulatory limit?
A fly ash aerosol of monodisperse particles with a density of 2.0 g/mL and particle diameter of 10.0 mm has a concentration of 1000.0 mg/m3. Calculate the settling velocity in cm/s and the settling rate in g/m2-s. Please answer very soon will give rating surely
The %purity of a powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. a. How many moles of CO2 were collected? b. What is the percent purity of the sample? Round off to the nearest whole number
The %purity of a powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. What CASE does this experiment satisfy?
100.0 cm3 of a 1.234 mol.dm-3 solution of nickel(II) nitrate was added to 150.0 cm3 of a 1.178 mol.dm-3 solution of sodium carbonate. Determine the limiting reagent
If 5 µM enzyme was used to obtain the data in the summary plot below, V-max = ________________ µM sec-1 and Km = ____________ µM for this enzyme (Enter numeric values to the nearest integer; Do NOT write units.)