The tetraethyl lead, Pb(C2H5)4 in a 25.00 mL sample of gasoline was shaken with 15.00 mL of  0.02095 M I2. The reaction is Pb(C2H5)4 + I2 → Pb(C2H5)3I + C2H5I  After the reaction was complete, the unused I2 was titrated with 6.09 mL of 0.03465 M Na2S2O3.  I2 + 2Na2S2O3 → 2NaI + Na2S4O6  Calculate the weight in milligrams of Pb(C2H5)4 (323.4 g/mol) in each milliliter of the gasoline. A. 8.100 mg/ml B. 5.400 mg/ml C. 2.700 mg/ml D.10.80 mg/ml

Q: A second analyst was attempting to determine the percent KHP in an unknown sample, similar to that…

A: From the given molarity of NaOH, number of moles of NaOH can be calculated followed by the…

Q: Manganese is derived from pyrolusite ore, an impure manganese dioxide. In the procedure used to…

A: Here , Oxalic acid is back titrated with KMnO4 , so concept of back Titration will be used here as…

Q: A standard solution of FeCl3 was prepared and its molar concentration was determined to be 2.000 M.…

A: Initial moles of FeCl3 = 2.00M × 10.00mL = 20mmoles FeCl3 dissociates into Fe3+ and 3Cl- ions. Thus,…

Q: The KCIO3 in a 0.1862-g sample of an explosive was determined by reaction with 50.00 mL of 0.01162 M…

A:

Q: The amount of protein in a sample of cheese is determined by a Kjeldahl analysis for nitrogen. After…

A: Here we have to determine the mass percentage of protein present in sample of cheese in the…

Q: A student weighs out 1.215 g of an impure KHP, dissolves the sample in 100. mL DI water and titrates…

A: kindly find the answer attached

Q: 25 mL of a bleach (NaOCl) sample is diluted to 500 mL. An excessive amount of KI is added to the 20…

A: The question is based on the concept of quantitative analysis . we have to calculate percentage of…

Q: You are going to standardize your sodium hydroxide by titrating with potassium hydrogen phthalate.…

A:

Q: 7. The tetraethyl lead, Pb(C2H5)4 in a 25.00 mL sample of gasoline was shaken with 15.00 mL of…

A:

Q: If the copper standard solution has a concentration of 25 μg/mL, what is the concentration of a…

A: Given Concentration of copper standard solution = 25 μg/ml

Q: What volume of 0.145 MM HClO4HClO4 solution is needed to neutralize 49.00 mLmL of 8.55×10−2 MM…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 4pts) 2.80g of a mixture of Barium Nitrate, Ba(NO3)2 (MM = 261.35 g/mol) and Potassium Bromide, KBr…

A: Here by gravimetric analysis, we have to determine the percentage of KBr in the mixture of Ba(NO3)2…

Q: Mass of H2C2O4•2H2O = 1.3245 grams  Molar Mass of H2C2O4•2H2O = 126.07 Volume of H2C2O4•2H2O…

A:

Q: In standardizing a solution of NaOH (40 g/mol) against 1.431 g of KHP (204.22 g/mol) the analyst…

A: Volumetric analysis is a method in which the volume of a substance is determined by measuring its…

Q: A solution of hydrogen peroxide,H2O2, is titrated with a solution of potassium permanganate, KMnO4.…

A: Number of moles of KMnO4​=MV/1000 ​=0.145×51.7/1000=7.4×10−3

Q: An unknown amount of acid can often be determined by adding an excess of base and then back-…

A: The excess of NaOH is treated with HCl. The neutralization reaction between the…

Q: The analyst wanted to measure the zinc oxide content of a 1.25-g sample. The sample was treated…

A: As per rules, only three questions can be answered: Titrimetric analysis method: Back titration…

Q: The zinc content of a 1.42 g ore sample was determined by dissolving the ore in HCI, which reacts…

A: Given, mass of ore sample = 1.42 g.   The ore was dissolved in 150 mL of 0.600 M HCl, and the…

Q: A student weighs out 1.051 g of impure KHP, dissolves the sample in deionized water and titrates it…

A: Given data Mass of impure KHP = 1.051 g Molarity of NaOH  solution = 0.1101 M Volume of NaOH…

Q: An impure sample of barium hydroxide of mass 1.6524g was allowed to react with 100mL of 0.200M…

A: Molar mass of Ba(OH)2= 171.34 g/mol Mass of impure sample of Ba(OH)2=1.6524g Volume of HCl=100ml…

Q: It takes 50.0 ml of 0.0500 M NazS203 solution to completely react with the iodine present in a 125.0…

A: Molarity of Na2S2O3 solution = 0.0500 M Volume of Na2S2O3 solution = 50.0 mL Volume of iodine =…

Q: To determine the amount of magnetite, Fe3O4, in an impure ore, a 1.5419-g sample is dissolved in…

A:

Q: What volume (mL) of 0.0.214 M (NH4)2HPO4 is necessary to precipitate the calcium as Ca3(PO4)2 from…

A:

Q: All arsenic in the mineral containing 20 g of arsenic is dissolved by converting it into As3+.…

A: Working formula Decinormal = one tenth of normality = 0.1 N Normality = Molarity*no of equivalents…

Q: Consider the reaction between ammonium dichromate and iron (III) acetate which occurs by the…

A: Molarity is the unit of concentration of a solution, and its unit is mol/L. It is defined by the…

Q: van Donder, a technician at Mahlakaneng laboratory, is required to remove chromium from chromium…

A: The question is based on the concept of chemical equilibrium. we have to calculate concentration of…

Q: the calcium in a 5.00ml serum sample is precipitated as CaC2O4 with ammonium oxalate. the filtered…

A: Number of moles of KMnO4 , n = Molarity x volume in L                                              =…

Q: In one trial of the standardization of a Na2S2O3 solution, a 10.00 mL volume of 5.00×10-3 M KIO3 is…

A:

Q: A quantitative analysis for ethanol, C2H60, is accomplished by a redox back titration. Ethanol is…

A: The explanation is given below-

Q: A sample of solid Mg(OH)2 was stirred in water at a certain temperature until the solution contained…

A: HClO4 is a strong acid, it reacts with magnesium hydroxide Mg(OH)2 , this is an acid base reaction.…

Q: You are preparing standard acid and base solutions for the laboratory, using potassium hydrogen…

A: When solutions are prepared for particular for titrations, it order to confirm the concentration of…

Q: What is the percentage purity of sodium hydroxide pellets, 1.0056 g of which was titrated with 21.5…

A: Solution The mole construct may be a convenient methodology of expressing the quantity of a…

Q: A quantitative analysis for ethanol, C2H6O, can be accomplished by a redox back titration. Ethanol…

A: When it comes to back titration, the stoichiometry between Cr2O72- and the analyte C2H6O and between…

Q: Exactly 0.2220 g of pure Na2CO3 was dissolved in 100.0 mL of 0.0731 M HCl.   (a) What mass in grams…

A: First of all we need to find the limiting reagent by considering the balanced reaction. When we…

Q: Suppose a student needs to standardize a sodium thiosulfate, Na, S,03, solution for a titration…

A: Concentration = 0.024 M

Q: A 2.2004 g of primary standard oxalic acid, H2C2O4 (90.04 g/mol), was dissolved in water to form a…

A:

Q: 4. A solution of 2.5 x 104M NazS2O3 was used for the iodometric titration of an ozone- containing…

A:

Q: A stock solution containing Mn2+ ions was prepared by dissolving 1.584 g pure manganese metal in…

A: Given that, Mass of Mn= 1.584 g Volume of stock solution = 1.00 L Now, 10.00 mL of this stock…

Q: **. n standardizing a solution of NaOH (40 g/mol) against 1.431 g of KHP (204.22 g/mol), the analyst…

A: Hello. Since your question has multiple subparts, we will solve only the first question for you. If…

Q: Many chemical compounds contain impurities. Crude potassium carbonate (K2CO3) obtained from the…

A:

Q: To determine the amount of magnetite, Fe3O4, in an impure ore, a 1.5419 g sample is dissolved in…

A:

Q: In the titration of 10.00 mL sample of vinegar solution with 0.35 M NaOH as titrant, the initial…

A: Given: The volume of the vinegar solution taken for titration = 10.00 mL Molarity of the NaOH…

Q: NEUTRALIZATION From the previous lesson, you have learned that the Arrhenius theory defines…

A:

Q: A mixture containing only KCl (74.55 g/mol) & NaBr (102.89 g/mol) was analyzed by the Mohr method. A…

A: Chloride ion concentration of an unknown sample can be calculated using Mohr method.  In Mohr…

Q: In the titration of 10.00 mL sample of vinegar solution with 0.35 M NaOH as titrant, the initial…

A:

Q: A mixture containing only KCl (74.55 g/mol) & NaBr (102.89 g/mol) was analyzed by the Mohr method. A…

A: Chloride ion concentration of an unknown sample can be calculated using Mohr method.  Mohr method is…

Q: A chemist needs to determine the concentration of a sulfuric acid solution by titration with a…

A: Given, The molarity of NaOH solution is---0.1585M. The volume of NaOH required for the titration…

Q: You performed a titration to determine the concentration of a solution of NaOH using solid KHP…

A: Molarity of a solution is equal to the number of moles of solute divided by volume of solution.…

Q: In the gravimetric determination of barium (FW=137.33 g/mol) as BaCrO4 (FW=253.32 g/mol), what…

A: The ratio of mass of particular component to the mass of sample multiply by 100 is known as…