Three coils connected in series across a 100 V, 50 Hz supply have the following parameters: R1 = 18 Ω, L1 = 0.012 H; R2 = 12 Ω, L2 = 0.036 H; R3 = 3.6 Ω, L3 = 0.072 H Determine the potential drop and phase angle for each coil. USE SERIES AC CIRCUITS METHOD NOT KIRCHOFF LAWS. PLS SHOW COMPLETE SOLUTION AND ROUND OFF TO FOUR DECIMAL PLACES , WRITE LEGIBLY PLS INLUDE ALSO THE CIRCUIT DIAGRAM:

Three coils connected in series across a 100 V, 50 Hz supply have the following parameters: R1 = 18 Ω, L1 = 0.012 H; R2 = 12 Ω, L2 = 0.036 H; R3 = 3.6 Ω, L3 = 0.072 H Determine the potential drop and phase angle for each coil. USE SERIES AC CIRCUITS METHOD NOT KIRCHOFF LAWS. PLS SHOW COMPLETE SOLUTION AND ROUND OFF TO FOUR DECIMAL PLACES , WRITE LEGIBLY PLS INLUDE ALSO THE CIRCUIT DIAGRAM:

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.17MCQ: Consider the load convention that is used for the RLC elements shown in Figure 2.2 of the text. A....

See similar textbooks

Similar questions

Consider the load convention that is used for the RLC elements shown in Figure 2.2 of the text. A. If one says that an inductor absorbs zero real power and positive reactive power. is it (a) True (b) False B. If one says that a capacitor absorbs zero real power and negative reactive power (or delivers positive reactive power), is it (a) False (b) True C. If one says that a (positive-valued) resistor absorbs (positive) real power and zero reactive power, is it (a) True (b) False
The resistance and inductance of a coil can be obtained by connecting the coil in series with a known resistance R and measuring the coil voltage Vcoil, the resistor voltage Vr and the total voltage V. The frequency must also be known, but the phase angles of the voltages are not known. Given that f = 60 Hz, R = 10 ohms, Vcoil = 22.4 V, Vr = 20 V and V = 36V. Calculate Xl and Xc
A resistor R and an impedance coil Z are connected in series. The combination is supplied bya 120-volt, 60 Hz AC source. The voltage across R and Z are 70 volts and 80 volts,respectively. The entire circuit consumes 1,153.12 inductive vars. Determine the following: a. Power factor of the impedance coilb. Total currentc. Impedance of the coild. Resistance of the impedance coil
1.A coil when connected across 40 V DC draws 640 W. When connected across (104 + j78) V AC, the coil draws 1000 W. Solve for the coil’s resistance and reactance and the current passing through in rectangular form. 2.An impedance coil having a 0.2 lagging pf is connected in series with a 300 W lamp in order to supply the lamp with 120 volt from a 208 volt, 60 Hz source. What is the voltage across the terminals of the impedance coil?
A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a capacitor. At 60Hz, the resistance is 5 ohms, the inductive reactance is 3 ohms, and the capacitive reactance is 4 ohms. Compute: (a)load impedance at 60Hz (b) value of the capacitance and inductance Explain each step. Please recheck
50. In AC circuit, Ohm's law proves that the phasor current though an element is equal to the ratio of the phasor voltage across the element with respect to the impedance of an element ." True False "In a R-C parallel circuit, R=10 ohms and Xc=10 ohms, the circuit total current is lagging to the applied voltage by 45 degrees (assumed applied voltage is the reference)." True False In a R-C series circuit, total current is out of phase with the applied voltage." True False
An AC series circuit has a load of 100 ohms, 0.5 henry and 10 millifarad and being supplied by a sine wave voltage of 100sin(10t). Calculate the total impedance, total current, voltage drop of the resistor, inductor and capacitor. also the plot phasor of the current and voltages
A 200V, 50 Hz supply is connected across a coil of negligible resistance and inductance 0.15 H connected in series with a 32 ohm resistor. Deter[1]mine (a) the impedance of the circuit, (b) the current and circuit phase angle, (c) the p.d. across the 32 ohm resistor, and (d) the p.d. across the coil.
41. Ideal inductors and capacitors are in phase with each other. True False "By the convention we are using in this course, if the reactance (X) is positive, it is inductive in nature." True False In series-connected ac circuit, the total current though the circuit is always equal to the phasor sum of the individual current though each element." True False "In a R-L series circuit, R=10 ohms and X=10 ohms, the applied voltage is in phase to the circuit total current (assumed applied voltage is the reference)." True False
an R-L circuit takes a current of 7amp that lags behind the 231-volt source by 35elec deg. calculate the power factor, power, impedance, resistance, and inductive reactance of the circuit.
A machine shop is fed by a 250 kVA 480 V three-phase electrical service. On one of thebranches leading away from the service, the shop runs several manufacturing machines,giving the branch a load profile of 175 kW with a 0.85 lagging PF.Determine the minimum allowed gauge of the branch conductors. Branch conductors arealuminum, THW, contained within a raceway with an ambient temperature of 40 ºC
A coil of wire having a value of (5 + j8) ohms is connected in series with acapacitive reactance Xc, and this series combination is then connected in parallel with a resistor R. If the equivalent impedance of the circuit is 4 /0 o ohms, calculate the values of Xc and R.