Three immiscible fluids sit in a storage tank open to atmosphere. The densities of the fluids in the storage tank are pi = 3.6 lbm/ft³, P2 (P1), state 2 (P2) and state 3 (P3). 12.5 lbm/ft', and p3= 11 lbm/ft. Calculate the absolute pressures at state 1 %3D

Three immiscible fluids sit in a storage tank open to atmosphere. The densities of the fluids in the storage tank are pi = 3.6 lbm/ft³, P2 (P1), state 2 (P2) and state 3 (P3). 12.5 lbm/ft', and p3= 11 lbm/ft. Calculate the absolute pressures at state 1 %3D

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A stream of oxygen enters a compressor at 298 K and 1.00 atm at a rate of 127 m 3/h and is compressed to 358 K and 1000 atm. Estimate the volumetric flow rate of compressed O 2, using the compressibility-factor equation of state
Carbon dioxide gas with a mass of 88 g is isothermally compressed at a fixed external pressure of 15 bar, with a speed of 298 K and a final pressure of 10 bar from 1 bar. Interpret the results by finding the quantities Δu, Δh, w, Q, Δs, Δa, g and Δsaverage, Δssystem in the event.
A mixture of 87.3 mole % methanol and 12.7 mole % isopropyl alcohol is vaporized at 101.325 kPa (absolute) until 900 moles of vapor and 100 moles of liquid in equilibrium with each other are produced. This occurs in a single-stage system and the vapor and liquid are kept in contact until equilibrium is achieved. Calculate the composition of the vapor and liquid. Note: Assume the system exhibits ideal behavior (which it mostly does), e.g. Raoult’s Law applies and an Antoine’s Vapor Pressure correlation is a sufficiently accurate model of component vapor pressure.
Ethane in a closed system is compressed without friction from 95 to 190 kPa in such a manner that pV=constant. Initially, the density is 1.11 kg/m3 and the volume is 0.045 m3. During the compression, 2.96 kJ of heat is removed from the ethane. Determine the change in internal energy of the ethane.
Sulfur dioxide (SO2) with a volumetric flow rate of 5000 cm3/s at 1 bar and 100°C is mixed with a second SO2 stream flowing at 2500 cm3/s at 2 bar and 20°C. The process occurs at steady-state. You may assume ideal gas behavior and that the process is adiabatic. For SO2, take the heat capacity at constant pressure to be
A constant-volume tank initially contains 1 kmol of carbon monoxide CO and 3 kmol of oxygen O2 (no nitrogen) at 25°C and 2 atm. Now the mixture is ignited and the CO burns completely to carbon dioxide CO2. If the final temperature in the tank is 500 K, determine the final pressure in the tank and the amount of heat transfer. Is it realistic to assume that there will be no CO in the tank when chemical equilibrium is reached?
A tank containing carbon dioxide at 400K and 50 bar is vented until the temperature in the tank falls to 300K. Assuming there is no heat transfer between the gas and the tank, find the pressure in the tank at the end of the venting process and the fraction of the initial mass of gas remaining in the tank for each of the following cases. a) the equation of state of carbon dioxide is P(V_mol-b)=R*T. b) Carbon dioxide obeys the law of corresponding states. c) Carbon dioxide obeys the Peng-Robinson equation of state.
Liquid nitrogen is stored in 0.5-m3 metal tanks that are thoroughly insulated. Consider the process of filling an evacuated tank, initially at 295 K. It is attached to a line containing liquid nitrogen at its normal boiling point of 77.3 K and at a pressure of several bars. At this condition, its enthalpy is -120.8 kJ kg-1. When a valve in the line is opened, the nitrogen flowing into the tank at first evaporates in the process of cooling the tank. If the tank has a mass of 30 kg and the metal has a specific heat capacity of0.43 kJ kg-1 K-1, what mass of nitrogen must flow into the tank just to cool it to a temperature such that liquid nitrogen begins to accumulate in the tank? Assume that the nitrogen and the tank are always at the same temperature. The properties of saturated nitrogen vapor at several temperatures are given as follows:
1. 0.1m3 of an ideal gas at 300 K and 1 bar is compressed adiabatically to 8 bar. It is then cooled at constant volume and further expanded isothermally so as to reach the condition from where it started. Determine the following with aid of a NEAT DIAGRAM a. Pressure at the end of constant volume cooling b. Change in internal energy during the constant volume process c. Net work done and heat transferred during the cycle. Assume, Cp = 14.3 kJ/kgK and Cv = 10.2 kJ/kgK.
Q1) A constant volume tank contain 1 mole ofC7H14and 12 mole of O2 gas at a temperature of 25 °C and 1 bar. The contents of the tank is ignited and C7H14 is burned completely and final products temperature is found to be 1700 K. Determine the heat transfer during this process. ( take daltaHo = -47800 kJ/kg).
A gas mixture at 300K and 1 bar analyzing by volume 20% N2 and 80% CH4 is subjected to liquefaction at the rate of 1500 kg/hr. It is found that only 30% (weight) of the entering gas is liquefied and the concentration of N2 in the liquid is 60% by weight. The unliquefied gas leaves the unit at 273K and 1 bar. Determine (a) the volume of the unliquefied gas, m3/hr (b) the composition of the gas leaving expressed as volume %.
An open vessel containing liquid water stands in a sealed room measuring 5.0m wide x 4.0m long x 3m high. The temperature of the room is 320K and, over time, some of the liquid water evaporates. Eventually, the liquid water level in the vessel stops changing. a) How many grams of water will be in the humid air within the sealed room? b)A contact lens cleaning system on the market uses an aqueous hydrogen peroxide solution to disinfect the contact lenses. In a few hours, the hydrogen peroxide decomposes to liquid water and oxygen gas in a catalyzed reaction. The vessel in which the reaction occurs has a hole in the top. Use chemical potential to explain how the equilibrium concentration of hydrogen peroxide would be affected if the hole was not present.