To determine the density of a liquid experimentally in a laboratory, you have 0.078 kg empty graduated cylinder. A liquid was poured in the graduated cylinder. The mass of the graduated cylinder with 250 cm of the liquid is found to be 0.2755 kg. Find the density of the liquid in (kg/m³). O 1.26 O 1000 Hani Ban O 790 O1260 O 0.79 Next pad

To determine the density of a liquid experimentally in a laboratory, you have 0.078 kg empty graduated cylinder. A liquid was poured in the graduated cylinder. The mass of the graduated cylinder with 250 cm of the liquid is found to be 0.2755 kg. Find the density of the liquid in (kg/m³). O 1.26 O 1000 Hani Ban O 790 O1260 O 0.79 Next pad

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter9: Mass And Mass-related Variables In Engineering

Section: Chapter Questions

Problem 45P

See similar textbooks

Similar questions

A jet plane taking off creates a noise with a magnitude of approximately 125 dB. What is the magnitude of the pressure disturbance (in Pa)?
Water flows through a pipe 25 mm in diameter at a velocity of 6 m/s. Determine whether the flow will be laminar or turbulent assuming that the dynamic viscosity of water is taken as1.30 × 10−3 kg/ms and its mass density as 1000 kg/m3. If oil of specific gravity 0.9 and dynamic viscosity 9.6 × 10−2 kg/ms is pumped through the same pipe, what type of flow will occur?
A tank initially contains 100 gallons of water. A salt solution containing 2lbs of salt per gallon flows in at the rate of 3 gallons per minute and the well stirred mixture flows cut at the same rate. When will the tank have 100 lbs of salt?a. 23.6 minutesb. 24.5 minutesc.23.1 minutes d. 20.5 minutessolve using the application of differential equation
From point A to point B of the system shown in the figure, oil flows (specific gravity of 8.64 kN/m3). A) Calculate the volumetric flow of the oil. ( WORK LIKE NEW PLEASE)
A liquid discharged from a container through a circular orifice having a diameter of 10 mm that is located 5 m. from the liquid surface to the center of the orifice. Evaluate the theoretical discharge through the orifice in liters per second if the container is moving upward at an acceleration half that of gravity.A.0.80liters/secC.0.90liters/secB.0.85liters/secD.0.95 liters/sec
An open cylindrical tank 800mm in diameter and 2000mm high contains water to a depth of 1.6m. It is rotated about its vertical axis at 13 rad/s. How many liters of water are spilled? Use density of water as 1000kg/m3 and specific weight as 9.81kN/m3
The venture meter shown carries oil (sg=0.80). Calculate the volume flow rate of the system
A liquid is flow throw Rotameter to a tank of size ( L x W x H ) and it is required to full the tank to level of H as shown in Figure . What time is required to full the tank by this liquid ? What time is required to drop the liquid in the tank to from level H to D by rectangular notch ?
What’s the specific gravity of the fluid with density 3.09 slugs per cubic foot
A sylo can contain 3.75*10^4 lb of liquid. The volume of water it would take is 552.885 ft3 if the weight of liquid contained by the sylo is 1,575,000 lb, what is the weight density of the fluid?
The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. If the tank is 30 cm. deep, and is contaminated with 3.05 cm. of water at the bottom, how many meters of air remains at the top when the gage indicates "FULL"? Use Unit weight of: gasoline = 6.24 kN/m3; air = 12.6 N/m3. The tank is closed. ANSWER : 0.017
The flow into a reservoir over a one hour period is shown in the following table. tt (minutes) 0 10 20 30 40 50 60 dVdtdVdt (gallons/minute) 258 332 370 447 436 435 320 Estimate the total volume entering the reservoir in 60 minute using the flow rate at the beginning of each interval. gallonsEstimate the total volume entering the reservoir in 60 minute using the flow rate at the end of each interval. gallons