I'm confused on these questions about how the percentage of hydrate in a sample could be affected, could you help? Would the calculated percentage of the hydrate in a sample be too high, too low, or unaffected by the follou

The percentage of water in the hydrate can be calculated by: % water =Mass of water lostOriginal…

Answered: Would the calculated percentage of the…

Science

Chemistry

Would the calculated percentage of the hydrate in a sample be too high, too low, or unaffected by the follou

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter9: The Gaseous State

Section: Chapter Questions

Problem 38P

See similar textbooks

Related questions

Q: Enter the coefficients directly from the balanced chemical equation. Do not reduce to lowest terms.…

A: The balanced reaction taking place is given as, =>

Q: 11. Using the following reaction Zn + 2HCI→ ZnCl2 + H2 If 8 moles of HCI were added, how many moles…

Q: Determination of the Amount of water, mass of crucible + dehydrated Sample is 16.2265g, mass of…

A: Mole concept: The number of molecules or atoms present in the one mole of the substance is equal to…

Q: The following may be needed: 1 mol=6.022x1023. 4) How many moles of Pare in 25 moles of calcium…

A: Given Number of moles of calcium phosphate = 25 moles

Q: Would the calculated percentage of the hydrate in a sample be too high, too low, or unaffected by…

A: The mass of water lost/the original mass of hydrate used is equal to the fraction of water in the…

Q: amount of

Q: How many moles of sodium chloride can be produced from 2.50 moles hydrochloric acid?

Q: limiting reactant= HCI 525g. HCI moles:

A: Number of moles = Mass of the substanceMolar mass of the substance

Q: How much moles of precipitate was formed? * Probable atomic weights: Ca = 40; C = 12; 0 = 16 Your…

Q: If the percent yeild is larger than 100%, what is a possible impurity in the final product? How does…

A: If the percent yield is larger than 100%, what is a possible impurity in the final product and How…

Q: Could you explain how 111 would be the answer? (Limiting Factor in Stoichiometry)

A: Reaction:- Al(s) + Br2(g) ----> AlBr3 Balanced Reaction:- 2Al(s) + 3Br2(g) ----> 2AlBr3

Q: Find the percentage oxygen by weight in KMnO4.

A: Percentage by mass – Formula is, This is formula for liquids. But for certain element present in a…

Q: determine the quantity of moles in 4.21 x 1023 molecules of CaCl2. List the steps clearly. Use…

A: Given, molecules of CaCl2 = 4.21 x 1023 molecules

Q: 2. Calculate the theoretical yield of Benzil given the quantities specified in the lab. 4.8g of…

Q: 3.02 grams of salicylic acid 0.02moles of salicylic acid 6.5 grams of acetic anhydride 0.6 moles…

A: Given, the weight of salicyclic acid (C7H6O3) - 3.02 grams the weight of acetic anhydride (C4H6O3) -…

Q: Theoretically, should the experimental mass percent water values for everyone who used the same…

A: Answer is yes If everyone is calculating the percent mass of water in the same hydrate the answers…

Q: e percentage yield of the

Q: Why are coefficients used in mole ratios instead ofsubscripts?

A: Mole ratio It is the ratio between the number of moles of any two compounds in a balanced equation…

Q: b) Mass of N2 produced when moles of K2O is produced. blank-blank-blank-conversion factor 1 blank -…

Q: ny moles of HI will be formed?

Q: i…

A: Given moles of Sodium = 0.0850 moles

Q: greatest percentage by mass of

Q: molarit

Q: A student uses gravimetric determination to find the water of hydration of a hydrated sample of…

A: The compound in which water molecule is present along with salt molecule is categorized as hydrous…

Q: would the reported mass percent of excess reactant be greater than, less than, or equal to the true…

A: If the precipitate is not completely dried when the mass is determined, then the water mass is also…

Q: Enter the coefficients directly from the balanced chemical equation. Do not reduce to lowest terms.…

A: The balanced reaction taking place is given as,

Q: Treatment of Data Mole amount of Na2Cl3 - Moles Na2CO3 = Mole amount of CaCl2- Moles of CaCl2 =…

A: All the details are explained in handwritten solution. Molarity = moles / Volume (L) Moles = mass /…

Q: Excess HCl reacts with Be to produce 50cm3 of hydrogen gas at 20 °C and 1.08x104 Pa. The equation…

Q: The proportion of sodium hydroxide in a mixture can be determined by

A: Sodium hydroxide in a mixture can be determined by various ways. Formula of sodium hydroxide is…

Q: if 1.095 g of unknown is found to be 0.00575 moles of solute, what is the molar mass of the unknown.…

A: Given data : Mass of the unknown = 1.095 gms Number of moles = 0.00575 We can apply the formula for…

Q: Trial 1 Trial 2 Trial 3 Moles HCI (mols) (Use the balanced equation to 7. create a mole ratio to…

A: We know, molarity of solution (here HCl ) = moles of HCl / volume of HCl solution…

Q: An analytical chemist has determined bg measurement that there are 0.011 moles of carbor in a sample…

A: Acetic acid is CH3COOH

Q: please help find d. Molarity of sodium hydroxide e. Volume of sodium chloride f. Mass of final…

A: In this question, Experimental data for the preparation of soap is given From the given data , we…

Q: how to convert mass of 4.6 grams of sucrose to moles?

A: The formula to calculate the number of moles from the mass:

Q: Use the References to access important values if neede The illustration to the left represents a…

A: According to the balanced equation N2 + 3 H2 --> 2 NH3 Thus Molar ratio of the reactants is -…

Q: B3b. MOLES OF SALT Set 1 Set 2 Half mass Set 1 Half mass Set 2 Salt moles (mol) 3 3 3 3 (Unrounded)…

A: Given that : We have to calculate the moles of the salt used for the given data :

Q: Enter the coefficients directly from the balanced chemical equation. Do not reduce to lowest terms.…

Q: A hydrated salt is heated to determine the mole ratio of water to salt (n). A student heated the…

A: Number of calculated hydration likely to be high, or low can be determined by checking the effect on…

Q: What is the Molecule weight of sarin gas?

A: Given -> Sarin gas

Q: What might be a reason you obtained a percent yield of less than/greater than 100% for the mixture

A: The formula used to calculate the percent yield is,If the obtained percentage yield is less than…

Q: Moles are the fundamental unit of chemistry. Why are moles so important? Please comment on molecular…

A: The amount of any substance is measured in a unit known as a mole which is equal to 6.023 x 10^23…

Q: In the conservation of the mass experiment we observed the conservation of masses by comparing the…

A: In the above question, the law of conservation of mass stated that the masses of a system should…

Q: Mass Salicylic Acid used 0.1498 g Mass Acetic Anhydride used 0.3417 g Mass filter…

A: Theoretical yield of aspirin can be obtained by determining the limiting reagent of the reaction.

Q: S STOICHIOMETRY we the following: w many grams of CC ess air? 1. Balanced Equatic 2. Molar Mass 3.…

A: Balanced chemical reaction, A) 2C8H18 + 25O2 ---> 16CO2 + 18H2O B) molar mass =8×12×18×1=114…

Q: Balancing and The Mole Ratio For each of the following balance the equation and then find the mole…

A: Balanced chemical equation: the balance chemical equation is the reaction which number of atoms of…

Q: What is the a.) Mass to Mass Stoichiometry Calculation b.) Limiting Reagent C.) Excess Reagent

A: Since you have posted multiple subparts, we are doing first 3 for you. To do the rest repost the…

Q: Use the References to access important values if needed for this question. A sample of a gaseous…

A: The mass of the sample is = 0.792 g The mass of carbon present in the sample is = 0.190 g The mass…

Q: A residue of potassium chloride will be left in the "container" after the heating is completed. Do…

A: Here we have told that a residue of potassium chloride will be left in the container after the…

Q: How to to solve a problem in solution stoichiometry.

A: Solution stoichiometry involves the calculation of concentration of solutions in the given…

Question

I'm confused on these questions about how the percentage of hydrate in a sample could be affected, could you help?

Would the calculated percentage of the hydrate in a sample be too high, too low, or unaffected by the follou

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Trending now

This is a popular solution!

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

How would I find a mole fraction from mixture using the total pressure of a mixture? Ex- 315 torr N2 272torr O2 285torr Ar Total - 872torr mixture Find O2 mole fraction
For the Ksp determination, the stoichiometric endpoint should not be passed. If an experiment surpassed its endpoint, will the Ksp, be too high, too low, or no change? Explain.
Please solve with a simple explanation involving Avogadro’s Constant.
Pure potassium hydrogen phthalate is used for the standardization of the sodium hydroxide solution. Suppose that the potassium hydrogen phthalate is not completely dry. Will the reported molar concentration of the sodium hydroxide solution be too high, too low, or unaffected because of the moistness of the potassium hydrogen phthalate? Explain.
If an insufficient amount of liquid unknown had been used how would this have affected the value of the experimental molar mass?
Estimate the number of moles of A in the mixture after 30 s.
I am conducting an experiment to figure out how the temperature of the solvent affects the rate of solution formation. I am using water at different temperatures and using salt or sugar for the experiment. How do i find my my independent variable be and dependent variable?
Estimate the number of moles of oxygen and the limiting oxygen concentration (LOC), for a mixture containing 300 moles of 60% ethane and 40% ethylene?
I don’t understand how to get the mole fraction
DON’T ROUND OFF ANY COMPUTATIO UNTIL TO THE FINAL ASWER. (OR AT LEAST USE 4 DECIMAL PLACES) USE: GIVE, REQUIRED, SOLUTION FORMAT) Determine the percentages of each element in benzoic acid in terms of: 1. percent by weight b. the mole percentage.
Derive a formula to transform from mole fraction to mass fraction.
In a 15-cm. evaporating dish is placed 15.4 g. (0.10 mole) of finely powdered biphenyl (Note 1). The dish is set on a porcelain rack in a 30-cm. desiccator with a 10-cm. evaporating dish under the rack containing 39 g. (12 ml., 0.24 mole) of bromine. The desiccator is closed, but a very small opening is provided for the escape of hydrogen bromide (Note 2). The biphenyl is left in contact with the bromine vapor for 8 hours (or overnight). The orange solid is then removed from the desiccator and allowed to stand in the air under a hood for at least 4 hours (Note 3). At this point, the product weighs about 30 g. and has a melting point in the neighborhood of 152°. The crude 4,4'-dibromobiphenyl is dissolved in 75 ml. of benzene, filtered, and cooled to 15°. The resulting crystals are filtered, giving a yield of 23.4– 24.0 g. (75–77%) of 4,4'-dibromobiphenyl, m.p. 162–163° (Note 4). How large of a scale can this reaction be run safely? Is it expensive?