Write a Boolean expression for the 4 to 1 digital multiplexer with data input ABCD and address select (control) lines a and b in figure 1

Q: Use quadruple 2-input multiplexer to select one of the 4 bit numbers. Support your answer with logic…

A: We need to use quadruple 2-input multiplexer to select one of the 4-bit numbers.

Q: 4 (а) Draw the logic circuit of a 1 to 2 De-Multiplexer using logic gates.

A:

Q: Construct a logical circuit of 64 × 1 multiplexer using 4 x 1 multiplexer.

A:

Q: Digital Design design 8-to-1 multiplexer using two 4-to-1 multiplexers and any other necessary…

A: The solution can be achieved as follows.

Q: QUESTION 5 A ROM chip with 16 internal address lines will have this number of address pins: Cannot…

A: “ Since you have asked multiple questions, and not mentioned which question do we to have to answer,…

Q: Construct the circuit as shown below. Apply the 4-bit BCD digits through four switches and observe…

A:

Q: A 3-bit quantiser has a dynamic range of ±4 Volts. How many quantisation levels could this system…

A: Given, Number of bit in quantiser, n=3 Dynamic range, ±4 V

Q: Fill-in the tables below with different representations of a number. Decimal Binary Hexadecimal 154…

A: Digital electronics

Q: 1- Explain what happens when PUSH Bx instruction executes. Make sure to show where BH and BL are…

A: The PUSH instruction in the 8085 Instruction Set pushes the contents of register pair rp into two…

Q: Part.5] Manually draw the implementation of the function Q = X+Y as logic circuit using 4xl…

A: A multiplexer is a device with several inputs and one outputs. It will select one input and forward…

Q: Rebuild the following instructions: a) NOT AL b) LDS SI, [BX] Perform the following function in a…

A: 1) Rebuild the instructions a) NOT AL  It is a logical instruction which inverts all the bits of a…

Q: 7- Convert (53BE)16 into a decimal number 8-Convert (37D)16 into an equivalent binary number

A:

Q: Design a Gray-to-Aiken decoder.

A: Truth table is,

Q: Interface a switch to Port A bit 5 using positive logic

A:

Q: Select the statement which is not correct about Bus Interface Ur a. BIU is connected to the /O…

A: Bus interface unit This unit handles all transfer of data and addresses on the buses. This unit…

Q: Results of arithmetic and logic instructions can be stored in one of two places. These are Program…

A:

Q: A multiplexer is a device that selects one among N analog or digital inputs and forwards the…

A:

Q: If the four output lines of a demultiplexer ar YO, Y1, Y2 and Y3, and the two select lines a given…

A:

Q: Perform the following function in a simple program steps a) DX = (07H)² b) Invert bits b1, b4 and…

A: We will write assembly language code to perform following operations   a) to perform square of 07H…

Q: Show how a full adder can be implemented using multiplexers

A: A full adder is used to add 3 binary numbers. In which one bit is carry bit and other two are…

Q: Q2: A) What are the addressing mode and physical address for each instruction if you know .…

A: Given data for the Question is   ES= A100H DS=4200H SS=D000H BX=0200H BP=1000H DI=0300H SI=0400H

Q: System designers use ________ error detection in ROM. Parity Hard Transmission Checksum

A: Read only memory: A ROM is memory device which can store permanent binary information & can use…

Q: Q1 Answer the following questions with 1- (00110101)BCD (-----) o=(--------). 2- Count in Hex. from…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: Assume that a digital system has eight 8-bit registers RO to R7. Assume that initially the register…

A:

Q: If a multiplexor has 4-bit data select lines, then the size of that multiplexer is а. 16:1…

A: No of input and select lines given by following relation  No of input = 2number of select lines

Q: is a logic switch that select ******* information from one of the input line and directs it to a…

A: (1) The logic switch that select information from one of the input line and directs it to a single…

Q: A full adder function is given in Figure 1(a). Implement this function using decoder 74x138 given in…

A:

Q: the diagram on the right is for a register bank circuit that contain 8 registers. Each register is…

A: The following circuit gives the 8 x 16 memory unit

Q: Your task is to implement a Full Adder Using TWO 4:1 Multiplexers but this time connect Cin and Y…

A:

Q: • Create a new relay logic that will simplify the logic below. + A B C HH #HE D # C * A B #F (M) DC…

A:

Q: Explain what the circuit does and how it works. (Hint: This circuit is called a 2-bit synchronous…

A: Concept: A flip flop is an electronic circuit which has two stable states that can be used to store…

Q: Write an 8051 program to exchange the contents of the stack pointer SP and the flag register PSW.

A:

Q: Design a Circuit to perform the following Operation.

A: Break the A+B-C operation in two parts as: A+B=S S-C For First Operation, Take Half adder to…

Q: Write a program in assembly language to toggle PORTB 400 times. Use BNZ instruction.

A: The code can be done by toggling bits of PORTB and sending values to 55H and puting a counter to…

Q: You have used DEBUG to unassemble the following instructions. -U 0100 0108 1369:0100 B84365 MOV AX,…

A: The instruction is loaded at location 0106, the instruction takes two bits when the given code is…

Q: is a finite set of elements which is----- * called symbols symbol alphabet language O closure O In…

A: an alphabet is a finite, non-empty set. The elements of the set are called symbols.

Q: 24(a) Adder is divided into three types which are half adder, full adder, and parallel adder.…

A:

Q: Q1- c) Several ID Automation products support the inclusion of the Application Identifier(Al) with…

A: Application Identifiers (AIs) are numeric prefixes that specify the meaning and syntax of encoded…

Q: a. Construct a 16 x 1 multiplexer with two 8 x 1 and one 2 x 1 multiplexers. Use block diagrams. b.…

A:

Q: Note: Attempt all questions. Any proof of cheating may lead to cacelation of paper. Q.1 Draw the…

A: Solution :    Here first of all we have made the truth table from the given timing diagram.   After…

Q: Write Arduino program that will add two bit binary numbers and calculate the sum of both numbers.…

A: The code for adding two bit binary numbers by using arduino is given as: #define DT_IN 13#define…

Q: logic, shift and rotate instructions: AND, OR, XOR NOT and TEST instruction shift instructions

A:

Q: Define MUX and DEMUX. Where we use mux and demux system? How toc reate a 16:1 MUX by using 4:1 MUX…

A: MUX: MUX is a abbreviation for multiplexer. Multiplexer is the device having multiple input & a…

Q: :What will be the contents of register BL after the last instruction execution? MOV BL, 14H MOV CL,…

A: SHL instruction shift left the bits of BL . The MSB is shifted into carry flag CF and LSB is filled…

Q: Q= (A+B)CDE

A:

Q: Electrical Engineering Draw 2, 1 bit ALUS to create a basic 2 bit ALU. the carry out and carry in…

A:

Q: 1. In Digital, open the "4-bit subtractor" circuit (RCS4.dig) 2. You should see inputs and outputs…

A:

Q: Construct a 16 x 1 multiplexer with two 8 x 1 and one 2 x 1 multiplexers. Use block diagrams.

A:

Q: In a multiplexer with n input bits, how many output bits are there? О а. 1og n of O b. n O c. None O…

A: In this question we will write about multiplexer....

Q: How many data control lines are required if a multiplexer has eight inputs? a. 8 b. 4 c. 2 d. 3

A:

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.