Write a program in assembly language using the MIPS instruction set to calculate the nth Fibonacci number. This must be done in an iterative loop. Your program will read from input the value of n. Be sure to validate user input and report errors when necessary. n must be a natural number that can not be too large that the value of f(n) cannot be expressed with a 32-bit unsigned integer and can be output to the console in SPIM. While iterating through this loop, store the value of f(n) in an array. Ths array should be large enough to contain N values (where N is the largest permissible value of n.) Your program should then output the nth Fibonacci number then output the portion of the sequence stored in the array.

A processor uses a serial link to communicate with a keyboard for word processing. A typist using this keyboard can type at rates peaking at 120 words per minute, where a word is 6 characters (including spaces and punctuation). The characters will be transmitted from the keyboard in 8-bit ASCII with one stop bit and no parity. Only consider these and no special characters. The programmer writes setup and polling service routines based on a minimum baud rate, but then finds that the keyboard will only interface at 19.2 Kbaud. Will the polling service routine have to change? Why or why not? Baud Rates 300 600 1200 2400 4800 9600 19200

Implement a program to do a bitwise complement (NOT) of an integer number entered by the user. You should use the XOR operator to implement the NOT, do not use the NOT operator. Your program should include a proper and useful prompt for input, and print the results in a meaningful manner. use assembly language to code

You must complete this in Python and the programs should not take any command-line arguments. You also need to make sure your programs will compile and run in at least a Linux environment. In this problem, you need to implement operation bit encoding for Assembly instructions. Given a line of text, your program should check whether it is a valid Assembly instruction type. If it is, your program should print out the opcode and optype of that instruction type; if the line of text is not exactly a valid Assembly instruction, your program should skip it and move to the next line of input without printing anything. Input Format The input to the program will consist of some number of lines. Each line contains some text, either a valid Assembly instruction type (with no extra whitespace or other characters, e.g. READ on a line by itself) or some other text. Constraints There are no specific constraints on the length or number of lines. They will be in a reasonable limit, as demonstrated by…

Write a MIPS assembly program to find the maximum number among three integers. Ask the user to enter the numbers, save the numbers, and perform the operations. Output the max and min numbers. Your solution should work for all input orders (3, 12, 9) or (3, 9, 12), or (12, 3, 9), etc. Example Enter the first number: 3 Enter the second number: 12 Enter the third number: 9 Output (should be exact) The maximum number is 12 and the minimum number is 3.