wt happens to brake fluid as it absorbs moisture

Q: Road test Report is Overhaul all four-wheel brakes and the Universal joints After the maintenance…

A: Option - B , D  => After operation is completed the road test report will happen to check the…

Q: The three major types of rubber seals used in automatic transmission are the blank the blank and the…

A: he three major types of rubber seals used in automatic transmission are ;

Q: Discuss why the τbrake value always larger compare to the τnet.

A:

Q: Brake power output of the engine ?

A: Given; The indicated power developed by an engine with compressionratio,r=8It is calculated using an…

Q: An ABS modulates brake pressure. What does this mean

A: In normal braking system when we apply brakes then the wheel gets locked and wheel starts skidding.

Q: Duo-servo drum brakes are also known as what type of brake assembly?

A: Drum brakes are commonly used in automobiles .duo servo drum brake system has a pair of brake shoes…

Q: The types of wear and distortion to look for when inspecting brake drums are

A: Drum Brake The drum brake commonly uses to stop the rotating cylindrical shaped part or wheel by…

Q: During a brake inspection, the inner brake pad is found to be 3mm thick, while the outside pad is…

A: Front and rear brake pads normally wear differently. When your vehicle is moving, the forward…

Q: While discussing how to remove the piston from a brake caliper: Technician A says that the dust boot…

A: Placing the caliper down facing on a workbench, a block of wood is inserted into the caliper…

Q: Name the two methods of attacking brake lining materials to the brake shoes.

A: Given Data : Break lining materials Assumptions made in solution : In solution, it is assumed that…

Q: A brake pad is found to be wearing more on one side than the other. Technician A says this is common…

A: Uneven breakpad means there capiler failure....

Q: Determine the brake power and brake thermal

A: Given data, A large four stroke  cycle diesel engine runs,N= 2000 rpmEngine has a displacement of 25…

Q: Technician A says that a malfunction of the ABS causes the control module to shut off or inhibit the…

A: Automobile

Q: 1.Name type of failures in engine blocks

A: The engine is the most important part of the IC engine. In production, Every company produces an…

Q: Rusted-through brake lines are uncommon. a. True b. False A technician is diagnosing a vehicle…

A: Rusted-through brake lines are uncommon. True              2.A technician is diagnosing a vehicle…

Q: which of the following is not measured when inspecting the brake rotors and pads?     A. Out of…

A: which of the following is not measured when inspecting the brake rotors and pads?

Q: List five common sources for transmission fluid leaks

A: five common sources for transmission fluid leaks are following-

Q: Technician A says that all transmission opening pressure are derived from the regulated output flow…

A: Technician A says that all transmission opening pressure are derived from the regulated output flow…

Q: A brake pad is found to be wearing more on one side than the other. Technician A says this is common…

A: Front and rear brake pads normally wear differently. When your vehicle is moving, the forward…

Q: How can you give the effect of the hydraulic brake

A: Given Data : Effect of hydraulic break

Q: Technician A says it is important to note transmission fluid temperature when checking the fluid…

A: For level checking of transmission fluid its temperature is checked. Transaxle has fluid for…

Q: A. Kineticenergy B. Coefficient of friction C. Bonded linings Linings attached to their backings…

A: Given questions are related to IC engines and braking systems in machine design. A. Kinetic EnergyB.…

Q: what type of radiator pressure cap is found on today's vehicle

A: Solution:

Q: Brake linings should be replaced when __ .a. linings are worn to within 1 /32 inch of a rivet headb.…

A: When brakes are exposed to wet, damp conditions, such as after a rain storm, pads may exhibit a very…

Q: List at least five seperate types of wear and distortion to look for when inspecting brake drums.

A: Wear and Distortion

Q: What are the risks of working with brake fluid?

A: Brake fluid is generally made with glycol or silicone. Bothe material is dangerous for us.

Q: A buildup of brake dust and dirt between the lining and the drum is the most common cause of a.  a.…

A: A buildup of brake dust and dirt between the lining and the drum is the most common cause of a…

Q: fferent parts of the brakes system of an off-road bicycle

A: introduction  In the marine and seaward industry, plan and hardware setups fluctuate from one…

Q: Determine brake power and brake thermal efficiency of the engine

A: Given data: Speed, N =1580 rpm Torque, T = 4 Nm Total fuel consumption, m = 0.48 kg/hr Temperature,…

Q: What are the differences between hydraulic vise and screw vise with

A: A vice features two parallel jaws that operate together to clamp and hold an item securely. The…

Q: Describe the procedure for using compressed air to remove a piston from a brake caliper.

A: Sometimes piston sticks in the bore in a disk brake.

Q: Filler Cap Fluid level sensor AA1 Car.com Secondary Secondary Piston Fluid Reservoir Primary Grommet…

A: The brake pedal applies the brakes when applied, slowing and/or stopping the car. To activate the…

Q: What are the indications that the brakes need adjustment

A: Warning signs that indicates the brakes need adjustment: 1) Noises: If you hear your car's brakes…

Q: Which of the following is not likely to cause a pulsating brake pedal? a. Loose wheel bearings b.…

A: When a load or side thrust is applied to the bearings, loose wheel bearings allow the rotor to tip…

Q: if you read the scan code on the vehicle and u0121 was present what would be the problem in brakes

A: Solution:      Code U1021 generally refers to a communication problem between the ABS brake control…

Q: When reassembling an overhauled brake caliper: Technician A cleans brake components in dena-tured…

A: reassembling an overhauled brake calliper: Technician A cleans brake components in denatured…

Q: Technician A cleans brake components  in denatured alcohol. Technician B cleans brake components in…

A: Technician A cleans brake components in denatured alcohol. Technician B cleans brake components in…

Q: Hydraulic lifters or hydraulic lash adjusters (HLA) may not bleed down properly and cause an engine…

A: Using an engine oil too thick can cause the hydraulic lash or hydraulic lifters to not bleed as fast…

Q: andard efficiency & brake thermal efficiency of engin

A: given:brake thermal efficiency=24.4%air thermal efficiency=53.4%

Q: The functions of a splash shield are being dis-cussed: Technician A says that disc brakes will…

A:

Q: iscuss the mechanism of each type of Brake systems.

A: Brakes are classified into different types. 1.According to the applications Running / foot brake…

Q: Technician A says that an out-of-round drum can cause a pulsating brake pedal. Technician B says…

A: Technician A says that an out-of-round drum can cause a pulsating brake pedal. Technician B says…

Q: Name the two methods of attaching brake lining materials to the brake shoes.

A: The two methods of attaching brake lining materials to the brake shoes are: 1.Riveting(Using riveted…

Q: After resurfacing a brake drum: Technician A cleansit using hot water and a lint-free cloth. He then…

A: A drum brake is a brake where the shoe press is on the inner surface of the drum. It uses friction…

Q: why is brake fluid removed from the master cylinder prior to working on disc brakes

A: A disc brake has a master cylinder that contains brake fluid in it. The braking force is first…

Q: What is the purpose of bleeding the hydraulic brake system?

A: The purpose of bleeding in the hydraulic brake system is to remove the air bubbles present in…

Q: Which type of brake requires greater application forceand is commonly used with power-boost units?a.…

A: Given Data : Brake

Q: Technician A says that the throttle position is an input to the PCM. Technician B says that the…

A: When brake pedal switch is pressed it sends an input to the PCM to maintain idle speed of a…

Q: Draw and label a diagram of a Brake system.(bond

A:

Q: Describe how to test the parking brake system in late model vehicles.

A: Parking brakes sometimes known as emergency brakes and these brakes are applied whenever a vehicle…

Clutches, Brakes, Couplings, and Flywheels

The clutch is described as a machine element used to connect or disconnect two shafts together to transmit torque or power. The clutch works on the principles of friction. The clutch is commonly used in automobiles to transfer power from the driving shaft to the driven shaft.