You will run a TLC plate after the CC placing in one spot the original sample of pigments, one spot from the yellow band and one from the green band. Draw a picture of what you expect to observe after running the TLC plate. Explain.

You will run a TLC plate after the CC placing in one spot the original sample of pigments, one spot from the yellow band and one from the green band. Draw a picture of what you expect to observe after running the TLC plate. Explain.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter10: Tlc Analysis Of Analgesic Drugs

Section: Chapter Questions

Problem 2Q

See similar textbooks

Related questions

Q: A student spots an unknown sample on a TLC plate and develops it in pentane solvent. Only one spot,…

A: The retardation factor (Rf) provides the interaction of the substance with the thin layer of the…

Q: 3. Consider a sample that is a mixture composed of biphenyl, benzoic acid and benzyl alcohol. The…

A: On a normal TLC plate, the Rf values solely depend on two factors: (i) the polarity of the…

Q: If you were to monitor the reaction mechanism for the hydroboration by TLC (Thin Layer…

A: Principle of TLC is based on adsorption phenomenon. Based on the polarity of the substrate the rate…

Q: 9) If after drying, the TLC plate showed spot A showed a Rf of 0.20 and spot B showed a Rf of 0.22.…

A: During the detection and separation of components in a compound using TLC, the solvent front is kept…

Q: If the TLC plates had been developed in a more polar solvent, would retention factors on the whole…

Q: An ideal RF value for a compound on a developed TLC plate is 0.30. How could you adjust the TLC…

Q: In an experiment that uses TLC, like the one performed in this course, which of the following…

A: Thin layer chromatography (TLC) is used to isolate and separate non-volatile mixtures based on their…

Q: Calculate the Rf value for a spot in a TLC experiment if the solvent moved 14.9 cm and the spot…

A: Given values, Distance travelled by solvent = 14.9 cm Distance travelled by solute= 9.5 cm

Q: Do you expect benzaldehyde or stilbene to travel farther on a TLC plate? Please explain, being sure…

A: "Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: What happens if the spots are made too large when preparing a TLC plate for development?

A: This question is related to chromatography.

Q: A student has a green dye mixture on which she performs a TLC experiment with a silica gel plate and…

A: Rf value is the retention factor which is defined as the ratio of distance travelled by the solute…

Q: Why mixture of solvents such as ethyl acetate with 5% acetic acid is used as a solvent/mobile phase…

A: TLC (Thin layer chromatography) is a technique to separate the components of mixture. TLC uses a…

Q: I had having trouble understanding the TLC labs. Could someone help explain how to tell which…

Q: cyclopentane pyrrolidine tetrahydrofuran area A = 100 intensity area B = 70 area C= 180 retention…

A: Gas chromatogram a mixture of three compounds pyrrolidine, tetrahydrofuran and cyclopentane.

Q: A student has a purple dye mixture on which she performs a TLC experiment with a silica gel plate…

A: TLC experiment is performed on the mixture of purple dye with the help of silica gel plate and…

Q: In what order would the following compounds be eluted on a silica gel TLC plate if they are spotted…

A: Rf value is the ratio of the distance travelled by the analyte and the distance travelled by the…

Q: Which is the more reliable technique for identifying an unknown compound and why? IR spectrum…

A: Every technique is important to identify a new compound. But the answer of the question is IR…

Q: Calculate the Rf value for a spot in a TLC experiment if the solvent moved 13.8 cm and the spot…

A: In the given TLC experiment the movent of the solvent is = 13.8 cm The movement of the spot is = 6.5…

Q: How would you discuss method of separation and identification of compounds in TLC?

A: The laboratory technique used to separate components of a mixture is called chromatography. It…

Q: Find the Rf value from given data. Thank you

A: In Thin Layer Chromatography, the compounds can be separated by the solvents in the TLC plate. The…

Q: Thin Layer Chromatography why the non-polar compounds move up the plate most rapidly (higher Rf…

A: TLC is most useful technique to know the extent of the reaction .And the no of compound present in…

Q: What are the TLC values (R) for (a) Starting Materials:_ _(b) Products: Show your calculation for…

A: Retention factor = distance traveled by the spot from the baseline/distance traveled by the solvent…

Q: On the blank TLC provided to the right, please draw where you would expect to see the spots for…

A: We are given with 3 compounds:- Compound C(lane 1) Compound A(lane 2) Compound B(lane 3) We have to…

Q: Which statement about TLC analyses is not true? * A- The line at the base of the TLC plate…

A: TLC is thin layer chromatography. It is a chromatographic technique to separate the components of…

Q: How would the Rf values change if you used pure dichloromethane (no methanol) as the mobile phase…

A: The dielectric constant for methanol is 30 and that of Dichloromethane is 8.3

Q: For the TLCS shown below, both plates have the exact same materials spotted on each lane (that is,…

A: Thin layer chromatography.

Q: Arrange the following compounds from highest Rț to lowest Rf on a TLC plate after elution with 50%…

A: In TLC, distance travelled by analyte species divided by distance travelled by solvent front is…

Q: You can perform a TLC experiment even if the solvent level is above the level of the initial spots.…

A: Here I have solved the question

Q: I need to get the rf valuse from a made up value and draw a tlc plate of 30% ethyl actate and 70%…

A: TLC can easily tell whether a reaction is complete or not. On a TLC plate, a polar compound takes…

Q: An unknown mixture was analyzed with TLC on a silica gel plate. Development gave two spots with Rf…

A: During the organic synthesis, the target compound will accompany by other side products that exist…

Q: Substance C is made up of components A and B. A sample of C was dotted on the TLC plate below. Using…

Q: What is the order in which the following compounds would he eluted from an HPLC column containing a…

A: To find: The order of elution of the given compounds in HPLC

Q: A student spots an unknown sample on a TLC plate. A single spot with an Rf of 0.55 showed up on the…

Q: For the TLCS shown below, both plates have the exact same materials spotted on each lane (that is,…

A: Distance Travelled by the Sample depends upon the type of Polar mobile phase used . IF THE mobile…

Q: You can perform a TLC experiment even if the solvent level is above the level of the initial spots.…

A: The spots would dissolve into the reservoir of eluting solvent and wrong result obtained.

Q: Solvent front Isolated product Reagent B Reagent A

A: From the TLC plate we can see that for reagent B two spots are observed. So the reagent B is not…

Q: What is the result of applying too much sample to the TLC plate? Select one: Some of the sample…

Q: Chromatography

A: Ascorbic acid is present in vitamin C Mass spectroscopy method can not be used because it's will…

Q: Put all steps (below) of a TLC analysis in a correct order. Write the two main visualization methods…

A: TLC analysis in correct order is as follows.

Q: What happens if the spots are made too small when preparing a TLC plate for development?

Q: As1...If a TLC plate shows only one spot with an Rf value of 0.98, does this mean the sample is…

A: In TLC plate , impure mixture spot is marked at ground horizontal line on stationery phase i.e. on…

Q: You are treating the TLC plate with 5% of sulfuric acid in ethanol. Briefly describe how this works.

A: Given that : We have to describe how treating the TLC plate with 5% of sulfuric acid in ethanol…

Q: Two compounds A and B from GC on two open tubular columns contains a XY-1 (100% methyl) and a XY-2…

A: In gas chromatography, a more polar group interacts more with the stationary phase (usually silica…

Q: Use a suitable model to explain how separation and identification of a mixture of organic compounds…

A: The mixture indicates the presence of two or more components of a substance in nonspecified molar…

Q: Among a mixture of compounds, the one that travels highest on the TLC plate has O the highest Rf…

A: This can be explained as follows

Q: A student spots an unknown sample on a TLC plate and develops it in dichloromethane solvent. Only…

A: TLC is thin-layer chromatography which involves distribution of a solid sample by solid-liquid…

Q: When would using Thin Layer Chromotography (TLC) NOT be useful in conducting an oxidation reaction?…

A: Although it is a very simple and convenient technique, one of its limitations is that it cannot tell…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

What will be the result of applying too much compound to a TLC plate?
what is more polar, pyrrole or benzaldehyde? I need to know for a TLC test/ which one should be further up?
How does increasing the polarity of the developing solvent affect the Rf of a compound on a silica gel TLC plate?
If a TLC was run in a solvent system that caused all the spots to show up at the baseline, how could the system be adjusted so that Rf values could be determined?
On the blank TLC provided to the right, please draw where you would expect to see the spots for B-carotene (lane 1), compound A (lane 2) and compound B (lane 3). This is SiO2 plate and the appropriate developing solvent is used.
You are treating the TLC plate with 5% of sulfuric acid in ethanol. Briefly describe how this works.
Pretending that you got the following TLCC result, is the extraction that gave the TLC plate in the picture successful or not? Explain
I need help darwing a TLC plate and figuring out the Rf values is the retention factor values We estimate our own TLC plate of Anthracene, Maleic Anhydride, and the Diels-Alder Adduct and determine the Rf values for the three materials
What is the purpose of chemically staining a TLC plate using iodine vapor? To increase the Rf values of all compounds on the plate To decrease the Rf values of all compounds on the plate To visualize colorless compounds that react with iodine on the plate To spread out the Rf values of all compounds on the plate more
Demonstrate how to make TLC, and analyze the sample for any purpose, which deemed suitable for you
An unknown mixture was analyzed with TLC on a silica gel plate. Development gave two spots with Rf values of 1.0 and 0.0 respectively.a) Can you say for sure how many compounds are present in the mixture? If so, how many are there? Explain. b) If not, what additional TLC experiment(s) might be performed to determine how many components are present? Explain.
If a column was run on the sample shown in lane 3, what would be the first compound to elute off of the column? (assume the same solvent and stationary phase are used) Which of the lanes on this TLC plate show pure compounds? Select all that apply.