Sustainable Energy
1st Edition
ISBN: 9781133108689
Author: Richard A. Dunlap
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
error_outline
This textbook solution is under construction.
Students have asked these similar questions
A turbine is rated at 600hp when the flow of water through it is 82cu.m/sec. Assuming an efficiency of 92%, what is the head acting on the turbine?
How much Megawatts can a motor generate if a 14 kN-m torque transmitted at 5.3 Hz is applied to the 10 mm diameter shaft attached to the motor?
2. Consider the system described in the news: at night, when there is energy left, water is pumped from a large lake to a reservoir at 80 m above the lake level. During the day, this water is used to generate energy in a turbine located 80 m below the elevated reservoir. Considering that the water flow is always 5000 liters/s (both at the inlet of the reservoir and at the outlet) and that the pump and turbine efficiencies are 70%, what is the power (in kW) required by the pump and the power (in kW) recovered in the turbine. Data: The pipe diameter is always the same along the system (d = 0.5 m); g = 10 m/s2; γ = 9810 N/m3.
Matter transport phenomena;
Please make it typeable as handwriting interferes with understanding
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.Similar questions
- What is the cost to pump 1000 liters of water to the top of a 30 m high water tank? Assume a pumping efficiency of 50% and an electrical cost of $0.15 per KW-h. P(h2O) = 1000 ?g/m^3 . 1 m^3 = 1000 litersarrow_forwardDesign head at China’s Three Gorges Dam, the largest hydropower project in the world, is 80.6 m, and rated power output of each of the 32 turbine generator units is 700 MW. If the efficiency of each of the turbine generator units at full power output is 93.2%, what is the design flow through each turbine?arrow_forwardWater flows from the ground floor to the third floor in a 4-storey building through a pipe 50 mm in diameter at a rate of 2 L/s and according to the diagram below. The water flows out from the system through a tap with an opening diameter of 15 mm. Q. Calculate the total energy loss due to friction through the systemarrow_forward
- b) Water flows from a large reservoir through a pipe system which consists of 200 mm diameter ofpipe and 50 mm diameter of nozzle as shown in Figure 3. By neglecting all energy losses, calculate;(ii) Velocity and pressure at Aarrow_forwardb) Water flows from a large reservoir through a pipe system which consists of 200 mm diameter ofpipe and 50 mm diameter of nozzle as shown in Figure 3. By neglecting all energy losses, calculate;(iii) Total energy at Aarrow_forwardA hydroelectric power station is supplied from a reservoir having an area of 50 km2and a head of 50 m.If overall efficiency of the plant is 60%, find the rate at which the water level will fall when the stationis generating 30,000 kWarrow_forward
- Q_3/Figure shows a pump employed for lifting water from a sump. If it is required to pump (60 liters/sec.) of water through a (0.1 m) diameter pipe from the sump to a point (10 m) above, Determine the power required. Also determine pressure intensities at Land M. Assume an overall efficiency of (70 %). Neglect All Lossesarrow_forwardWater leaving the nozzle at a velocity of 4350 m/min with a volume flow rate of 0.736 m³ . if the density of water is 0.000997 kg/cm³ . How will you determine the potential for power generation in a hydraulic turbine .arrow_forwardDiscuss the benefits of pumped storage hydropower (PSH).arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
Sustainable EnergyCivil EngineeringISBN:9781133108689Author:Richard A. DunlapPublisher:Cengage Learning
Sustainable Energy
Civil Engineering
ISBN:9781133108689
Author:Richard A. Dunlap
Publisher:Cengage Learning