The minimum value of magnitude of v → such that the cube tip over and falls off the table.

Question

A solid cube of side 2a and mass M is sliding on a frictionless surface with uniform velocity → v as shown in Figure . It hits a small obstacle at the end of the table that causes the cube to tilt as shown in Figure P11.50b. Find the minimum value of the magnitude of → v such that the cube tips over and falls off the table. Note: The cube undergoes an inelastic collision at the edge.

Answer 1

Question

Chapter 11, Problem 50CP

To determine

The minimum value of magnitude of v→ such that the cube tip over and falls off the table.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

A solid cube of side 2a and mass M is sliding on a frictionless surface with uniform velocity → v as shown in Figure . It hits a small obstacle at the end of the table that causes the cube to tilt as shown in Figure P11.50b. Find the minimum value of the magnitude of → v such that the cube tips over and falls off the table. Note: The cube undergoes an inelastic collision at the edge.

A stick is resting on a concrete step with 2727 of its total length ?L hanging over the edge. A single ladybug lands on the end of the stick hanging over the edge, and the stick begins to tip. A moment later, a second, identical ladybug lands on the other end of the stick, which results in the stick coming momentarily to rest at ?=51.7∘θ=51.7∘ with respect to the horizontal, as shown in the figure. If the mass of each bug is 2.752.75 times the mass of the stick and the stick is 18.7 cm18.7 cm long, what is the magnitude ?α of the angular acceleration of the stick at the instant shown? Use ?=9.81 m/s2.

A 2.4 m long rod of mass m1 = 17.0 kg, is supported on a knife edge at its midpoint. A ball of clay of mass m2 = 4.8 kg is dropped from rest from a height of h = 1.4 m and makes a perfectly inelastic collision with the rod 0.9 m from the point of support. Find the angular momentum of the rod and clay system about the point of support immediately after the inelastic collision.