Concept explainers
Interpretation:
The partial pressure of H2 and the number of moles of H2 present in the sample should be determined.
Concept Introduction:
The problem can be solved using
Where, P is the total pressure of the mixture
V is the volume of the mixture
R is the gas constant
T is the absolute temperature and,
n is the total number of moles of hydrogen gas and water vapor.
Now,
Once
Where
Pt o t a l is the total pressure of the mixture.
Trending nowThis is a popular solution!
Chapter 13 Solutions
Introductory Chemistry: A Foundation
- A typical barometric pressure in Redding. California, is about 750 mm Hg. Calculate this pressure in atm and kPa.arrow_forwardA 3.00-L flask containing 2.0 mol of O2 and 1.0 mol of N2 is in a room that is at 22.0C. a How much (what fraction) of the total pressure in the flask is due to the N2? b The flask is cooled and the pressure drops. What happens, if anything, to the mole fraction of the O2 at the lower temperature? c L of liquid water is introduced into the flask containing both gases. The pressure is then measured about 45 minutes later. Would you expect the measured pressure to be higher or lower? d Given the information in this problem and the conditions in part c, would it be possible to calculate the pressure in the flask after the introduction of the water? If it is not possible with the given information, what further information would you need to accomplish this task?arrow_forwardEthanol, C2H5OH, is produced industrially from ethylene, C2H4, by the following sequence of reactions: 3C2H4+2H2SO4C2H5HSO4+( C 2 H 5)2SO4C2H5HSO4+( C 2 H 5)2SO4+3H2O3C2H5OH+2H2SO4 What volume of ethylene at STP is required to produce 1.000 metric ton (1000 kg) of ethanol if the overall yield of ethanol is 90.1%?arrow_forward
- A mixture of cyclopropane and oxygen is sometimes used as a general anesthetic. Consider a balloon with an anesthetic mixture of cyclopropane and oxygen at 170. torr and 570. torr, respectively. Calculate the mole fraction of cyclopropane in the mixture.arrow_forwardIn a typical automobile engine, a gasoline vapor-air mixture is compressed and ignited in the cylinders of the engine. This results in a combustion reaction that produces mainly carbon dioxide and water vapor. For simplicity, assume that the fuel is C8H18 and has a density of 0.760 g/mL. (a) Calculate the partial pressures of N2 and 02 in the air before it goes into the cylinder; assume the atmospheric pressure is 734 mmHg. (b) Consider the case where the air, without any fuel added, is compressed in the cylinder to seven times atmospheric pressure, the compression ratio of many modem automobile engines. Calculate the partial pressures of N2 and O2 at this pressure. (c) Now consider the case where 0.050 mL gasoline is added to the air in the cylinder just before compression and completely vaporized. Assume that the volume of the cylinder is 485 mL and the temperature is 150C. Calculate the partial pressure of the gasoline vapor. (d) Calculate the amount (mol) of oxygen required to bum the gasoline in part (c) completely to CO2 and H2O. (e) The combustion reaction in the cylinder creates temperatures in excess of 1200K. Due to the high temperature, some of the nitrogen and oxygen in the air reacts to form nitrogen monoxide. If 10% of the nitrogen is converted to NO, calculate the mass (g) of NO produced by this combustion. (f) Hot-rod cars use another oxide of nitrogen, dinitrogen monoxide, to create an extra burst in power. When such a power boost is needed, dinitrogen monoxide gas is injected into the cylinders where it reacts with oxygen to form NO. Calculate the mass of dinitrogen monoxide that would have to be injected to form the same quantity of NO as produced in part (e). Assume that sufficient oxygen is present to do so.arrow_forward93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)arrow_forward
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage Learning
- Chemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage LearningChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage Learning