Chapter 4, Problem 4.29P

no need for help in the graphical approach just the scalar

ENTROIDS AND CENTER OF GRAVITY: The following problems are to locate centroids of areas and lines. PROBLEM 2 ONLY PROVIDE THE SAME PROCESS OF SOLUTION IN THE GIVEN EXAMPLE ? THANK YOU.

Show the step by step procedure by constructing it using solidworks

Don't answer the given problem, just give me the schematic diagram and t-s diagram of the given problem

show the FBD and complete solution

analytical and graphical solution of the forces

The steel cylinder with a cylindrical hole is connected to the copper cone. Find the center of gravity of the assembly. The weight densities of steel and copper are 489lb/ft3 and 556lb/ft3, respectively.

The tank depicted in in the diagram is located at an oil refinery. There is rectangular hatch locatedon one side that gives access for maintenance. The company will be replacing the hatch door andhas hired you to assist with the design requirements.II. (M1) The client is procuring a new hydraulic lifting jack. The jack is rated to lift 2000kg. Given thatthe diameter of the pumping piston is 25 mm and the lifting piston is 40 mm, calculate for theclient:a) The force needed on the pumping piston to raise the max load.b) The pressure in the oil.c) If the pumping piston moves 1cm with every pump, what distance does the lifting piston move

The object shown below is stable and floating in the water.   (1) Please match center distance MB and MG  with correct distance options for Figure (a).