Chapter 6.5, Problem 1E

(Practice) a. To convert inches (in) to feet (ft), the number of inches should be multiplied by which of the following conversion factors? i. 12 in/1 ft ii. 1 ft/12 in b. To convert feet (ft) to meters (m), the number of feet should be multiplied by which of the following conversion factors? i. 1 m/3.28 ft ii. 3.28 ft/1 m c. To convert sq.yd to sq.ft, the number of sq.yd should be multiplied by which of the following conversion factors? i. 1 sq.yd/9 sq.ft ii. 9 sq.ft/1 sq.yd d. To convert meters (m) to kilometers (km), the number of meters should be multiplied by which of the following conversion factors? i. 1000 m/1 km ii. 1 km/1000 m e. To convert sq.in to sq.ft, the number of sq.in should be multiplied by which of the following conversion factors? i. 144 sq.in/1 sq.ft ii. 1 sq.ft/144 sq.in f. To convert minutes (min) to seconds (sec), the number of minutes should be multiplied by which of the following conversion factors? i. 60 sec/1 min ii. 1 min/60 sec g. To convert seconds (sec) to minutes (min), the number of seconds should be multiplied by which of the following conversion factors? i. 60 sec/1 min ii. 1 min/60 sec

(General math) The volume of oil stored in an underground 200-foot deep cylindrical tank is determined by measuring the distance from the top of the tank to the surface of the oil. Knowing this distance and the radius of the tank, the volume of oil in the tank can be determined by using this formula: volume=radius2(200distance) Using this information, write, compile, and run a C++ program that accepts the radius and distance measurements, calculates the volume of oil in the tank, and displays the two input values and the calculated volume. Verify the results of your program by doing a hand calculation using the following test data: radius=10feetanddistance=12feet.

(Oceanography) The pressure, P, exerted on an underwater object can be determined by this formula: P=gh is the density of water, which is 1.94slug/ft3 . g is the acceleration caused by Earth’s gravity, which is 32.2ft/sec2. h is the object’s depth in the water in feet. a. Determine the units of P by calculating the units resulting from the right side of the formula. Check that your answer corresponds to the units for pressure listed in Table 1.1. b. Determine the pressure on a submarine operating at a depth of 2500 feet.