PhysicsLab_MiaMartinez

Do all questions

1. 1-5 K 30v a. what is tue T CTime constant) ? b. How long will it take for the capacutor TO rtach s0% op charge? C. What is tne voltage of capa citor apter 1 seconds? d. How many tíme constants will it take for the soltage to reach 23 v? C. Gweng that the capacitor is fully changed, how will it take por it to be 20% ? long 120v + BF what is the. T ? b. what is the voltage capacitor apter 10 sec? a. C. How many time constants will it take for Tue Vo Itage to reach 80 v.? d. Given that the capaator is Fully charged, how time constants will it be to reau many GOV!

1. Which of the following answers best describes discontinuous conduction mode? A. The inductor voltage ripple goes negative B. The inductor current ripple stays positive C. The inductor current ripple falls to zero D. The output current ripple falls to zero

Describe the behavior of the voltage across the resistor with time as thecapacitor charges. Explain the reason for this behavior.

Pls. write solution neatly

write down the measure capacitance on your bench figure.1

please please please solve it fast

Explain the exponential relationship between the charge on capacitor and time during charging or discharign with the use of natural log

What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?

quick please

If values are not given than write sufficient formula with explanation.........

give definition and explanation about Capacitance meter

Explain the charging characteristics of a capacitor with ac voltage.

Consider the diagram of the following figure: Determine the charge voltage and energy of each of the capacitors. Make and complete your data table, if the voltage is 300 V C UF C₁= 30 C₂=60 C₁=22 C=74 Cs=32 Co=45 q μC V V W E 300 60μF 22HF C2 C3 30MF C1 CA 74 MF C5 32AF :C6 45MF

Given that the zener diode has a valaue of Vz = 35 V. Find the maximum current flowing through the zener diode.  **Please show your correct and complete solution for this circuit problem. ASAP! Thank you!**

A thin metallic foil is placed between the plates of a flat capacitor parallel to them. How does this affect capacity? What if you join a plate with a wire?

can you solve this question handwritten solution step by step how did we obtain the v0 graph? my question is not a part of a graded assignment

Find the current through the inductor shown in Figure lb. (i/p is AC, consider results upto one decimal place). 1. 100 V 100 Hz 500 L=60H Figure lb

Please respond to question in attached image.  Please.

1

In the circuit shown in the figure, the switch is operated at a duty cycle of 0.5. A large capacitor is connected across the load. The inductor current is assumed to be continuous. The average voltage across the load and the average current through the diode will respectively be =4A L L=t A 20 V'

Qno.3 If the equivalent capacitance between a and b is 10„F for the combination of capacitors shown in Figure 2. Calculate the value of capacitance "x" All capaci- tances shown in figure are in pico farads. 4.0 10.0 X 2.0 Figure 2

5

The current through the diode in the circuit given in the Figure below when Vy = 0.7 V is? ww 8092 12V Select one a. 24.26 mA b. 13.09 mA c. 58.23 mA d. 40.13 mA 40-52 ww 3092 ID

What do you think will happen to the current if the frequency is adjusted higher in the pure inductance experiment? and what will happen to the current if the frequency is adjusted lower in pure inductance experiment? explain why please

Q1 (a) (b) (c) State the meaning of primary cells. What is the 3 factors affecting capacitance value? State the formula of capacitance in part (b).