SOLVE -1 Na₂ Coz + ? Call₂ -> ? CaCO3 (3) + ² Nallmassoffilter paper0.0008 gofСасоз =2.1547Volume of Call used = 25.04 mL at 0-40MVolume of Na₂CO3 used = 40.00mL at 0.60Mto do is -●massAll you need.Calculate.Limiting reactant%/ yield?mass of CaCo3 madex 100%mass CaCO3 should have made소Ⓒ% yield1(detailed stepssolving limiting reactants).on=baseduponLRthank you

Answered: Image /qna-images/answer/63fd3224-da2d-40d0-afc7-22c6503ceb24.jpg

:. 2 in Au ● Na₂ Coz + 2 Call₂ -> ? Cal 03 (s) + ? mass 0.0008 g mass of of Сасоз 2.1547 Volume of Call used = 25.04 mL at 0.40M Volume of Na₂ CO₂ used = 40.00 mL at 0.60M to do is - ( you meed Calculate 2 filter paper : Limiting reactant %/ yield ? mass of CaCo3 madex 100% mass CaCO3 should have made ↑ based upon % yield = ² Nall - -? LR

:. 2 in Au ● Na₂ Coz + 2 Call₂ -> ? Cal 03 (s) + ? mass 0.0008 g mass of of Сасоз 2.1547 Volume of Call used = 25.04 mL at 0.40M Volume of Na₂ CO₂ used = 40.00 mL at 0.60M to do is - ( you meed Calculate 2 filter paper : Limiting reactant %/ yield ? mass of CaCo3 madex 100% mass CaCO3 should have made ↑ based upon % yield = ² Nall - -? LR

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

PS. Further values required for the solvings are give in the various situations below. (ANSWER) Situation: A community in a mountainous area of Bohol uses water collected from a nearby natural spring. A sample was submitted to a laboratory for the analysis of its total hardness. Required: SHOW YOUR COMPLETE CALCULATIONS. BASED ON THE IMAGE PROVIDED BELOW FOR THIS QUESTION: Calculate the amount of titrant used in each trial to reach endpoint. Report total hardness of the sample as mean ±sd. a. 250.0 mL of 500.0 ppm of CaCO3 solution from a primary standard (assume solvent is distilled water only). Answer : Mass of CaCO3 = 0.125 g b, The EDTA solution was standardized by titrating it with a 25.0 mL aliquot of the CaCO3 solution. How much of the titrant was consumed. Answer: Volume of EDTA consumed = 12.405 g c. Calculate the average titer (mg CaCO3/mL EDTA). Mass of CaCO3 in 25 mL CaCO3 solution: 0.0125 g Answer: 1.008 mg CaCO3/ mL EDTA
Pls do fast and i will rate instantly for sure Solution must be in typed form A 25.0 mL volume of 0.0106 M KIO3 is pipetted into a 250-mL Erlenmeyer flask. The solution is titrated to the stoichiometric point with 16.25 mL of a sodium thiosulfate solution. What is the molar concentration of the sodium thiosulfate solution?
KNO3 (aq) added to CaC2O4 (Ksp = 1.3 x 10-8) in solution will lead to __________ in solubility of the solid no effect then decrease increase no effect
Fast pls i will give u like for sure solve this question correctly in 5 min pls A student analyzed a CaCO3 antacid tablet by neutralizing the base with an excess of .60 M HCL and back-titrating the excess with .50M NaOH. He recorded the following data: mass of tablet = 1.3g amount of active ingredient CaCO3 per label = 500 mg volume of HCl added: 25 mL initial buret reading : 34 mL final buret reading : 47.4 mL If the concentration of the provided HCl is actually higher than .60M, would the determined mass of CaCO3 in the antacid tablet be too high or too low?
Solid cobalt (II) acetate is slowly added to 125 mL of 0.0945 M ammonium chromate solution. What is the concentration of cobalt required to just initiate precipitation? The Ksp of CoCrO4 is 7.1 * 10 -4. Report answer in scientific notation to two sig figs.
In which situation(s) is it necessary to use a volumetric flask for maximum accuracy? to prepare a 0.150M solution of sodium chloride to measure ~25mL of water to prepare 0.1M HCI from 36-38% HCI a and c all of the above (Please type answer no write by hend)
Based on the analysis of a vinegar solution via titration with 0.1 M NaOH. Results are as follows: Trial 1 Volume of vinegar solution used (mL) 5.00 Final burette reading (mL) 44.20 Initial burette reading (mL) 0.00 Determine the percentage mass of acetic acid in vinegar for Trial 1. The density of vinegar is 1.01 g/mL and molecular mass for acetic acid is 60 g/mol.
It is known that acid content has a major effect on theflavor of vinegars, but most cheaper vinegars are diluted similarly to 5% acidity Wt./vol. % is equivalent to gsolute per 100mL solution (so 5% is equivalent to 5 g acid/100 mL solution). a.) First, calculate the approximate molar concentration of acetic acid in the 5% wt./vol vinegar. b.) Next, calculate the expected molarity of acetic acid in the solution upon dilution by a factor of 5. Thank you!
QUESTION What is the average weight percent of acetic acid in the vinegar sample? Data Trial 1 Initial – 0.6 Final – 29.8 Trial 2 Initial – 8.5 Final - 38 Trial 3 Initial – 9.1 Final – 38.5 What is the volume, in mL, of vinegar used in this titration? 5 ML What is the molarity, M, of NaOH added to vinegar? 0.1113 What volume of NaOH was added in trial 3 of the titration? Final – initial 38.50-9.10 = 29.40 How many moles of acetic acid were neutralized in trial 1 of the titrations? - (0.1113*0.0292) = 0.0032 What is the average molarity of acetic acid in the vinegar sample?Average Molarity = 0.16 + 0.165 + 0.165 / 3 = 0.163
Trial 1: Initial pH= 3.92mL Mass of KHP and Paper= 0.868g Mass of paper= 0.357g Mass of KHP= 0.511g Trial 2: Initial pH= 4.09ml Mass of KHP and Paper= 0.870g Mass of paper= 0.359g Mass of KHP= 0.511g 1) find the volume at equivalence point of both trial 2) find the pH at equivalence point of both trial and calculate the molarity of the NaOH solution from each result and calculate the mean.
Was wondering how to solve this hw problem? Calcium Flouride (dissociation) K@25 C = 3.94 *10^-11 Calcium fluoride is not very soluble in water. ** Its dissociation is: CaF2 (s) Ca²+ (aq) + 2 F¯ (aq) a. At 25°C, how many milligrams of CaF2 would dissolve in 2.0 L of water? b. What were your initial and final values of Q?
Volume vinegar used (mL)= 5.00 mL % from labe= l5 % Molarity of NaOH = 0.0976 M Titration volume measurements Trial 1 Trial 2 Trial 3 Inital volume NaOH (mL) 0.69 0.86 0.16 Final volume NaOH (mL) 43.47 43.36 43.03 Volume NaOH used (mL) Average volume NaOH used (mL) Average volume NaOH used (L) Moles NaOH used (from avg volume) Moles CH3COOH Molarity CH3COOH (mol/L) Mass CH3COOH (g) % (m/v) CH3COOH in vinegar