11) The reaction A2 + B2 = 2 AB has an equilibrium constant Kç = 9.0. The following pictures represent reaction mixtures that contain A2 molecules (shaded) and B2 molecules (unshaded), and AB molecules. Which reaction mixture is at equilibrium? 8 c0 8. 8 00 8 00 00 00 (4) A) reaction mixture (1) B) reaction mixture (2) D) reaction mixture (4) C) reaction mixture (3)

11) The reaction A2 + B2 = 2 AB has an equilibrium constant Kç = 9.0. The following pictures represent reaction mixtures that contain A2 molecules (shaded) and B2 molecules (unshaded), and AB molecules. Which reaction mixture is at equilibrium? 8 c0 8. 8 00 8 00 00 00 (4) A) reaction mixture (1) B) reaction mixture (2) D) reaction mixture (4) C) reaction mixture (3)

Introduction to General, Organic and Biochemistry

11th Edition

ISBN:9781285869759

Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Chapter7: Reaction Rates And Chemical Equilibrium

Section: Chapter Questions

Problem 7.53P

See similar textbooks

Similar questions

The following equilibrium is established in a closed container: C(s)+O2(g)CO2(g)H=393kJmol1 How does the equilibrium shift in response to each of the following stresses? (a) The quantity of solid carbon is increased. (b) A small quantity of water is added, and CO2 dissolves in it. (c) The system is cooled. (d) The volume of the container is increased.
Suppose a reaction has the equilibrium constant K = 1.7 108 at a particular temperature. Will there be a large or small amount of unreacted starting material present when this reaction reaches equilibrium? Is this reaction likely to be a good source of products at this temperature?
Consider the system A(g)+2B(g)+C(g)2D(g)at 25C. At zero time, only A, B, and C are present. The reaction reaches equilibrium 10 min after the reaction is initiated. Partial pressures of A, B, and D are written as PA, PB, and PD. Answer the questions below, using LT (for is less than), GT (for is greater than), EQ (for is equal to), or MI (for more information required). (a) PD at 11 min PD at 12 min. (b) PA at 5 min PA at 7 min. (c) K for the forward reaction K for the reverse reaction. (d) At equilibrium, K Q. (e) After the system is at equilibrium, more of gas B is added. After the system returns to equilibrium, K before the addition of B K after the addition of B. (f) The same reaction is initiated, this time with a catalyst K for the system without a catalyst the system with a catalyst. (g) K for the formation of one mole of D K for the formation of two moles of D. (h) The temperature of the system is increased to 35C. PB at equilibrium at 25C PB at equilibrium at 35C. (i) Ten more grams of C are added to the system. PB before the addition of C PB after the addition of C.
Solid ammonium iodide decomposes to ammonia and hydrogen gases at sufficiently high temperatures. NH4I(s)NH3(g)+HI(g)The equilibrium constant for the decomposition at 400C is 0.215. Twenty grams of ammonium iodide are sealed in a 7.50-L flask and heated to 400C. (a) What is the total pressure in the flask at equilibrium? (b) How much solid NH4I is left after the decomposition?
Consider the decomposition equilibrium for dinitrogen pentoxide: 2N2O5(g)4NO2(g)+O2(g) At a certain temperature and a total pressure of 1.00 atm, the N2O5 is 0.50% decomposed (by moles) at equilibrium. a. If the volume is increased by a factor of 10.0. will the mole percent of N2O5 decomposed at equilibrium be greater than, less than. or equal to 0.50%? Explain your answer. b. Calculate the mole percent of N2O5 that will be decomposed at equilibrium if the volume is increased by a factor of 10.0.
Answer the following questions regarding the butane isobutane equilibrium (Kc = 2.50 at 298 K). (a) Is the system at equilibrium when [butane] = 0.00097 M and [isobutane] = 0.00218 M? If not, in which direction will the reaction proceed to achieve equilibrium? (b) Is the system at equilibrium when[butane] = 0.00075 M and [isobutane] = 0.00260M? If not, in which direction will the reaction proceed to achieve equilibrium?
In the contact process, sulfuric acid is manufactured by first oxidizing SO2 to SO3, which is then reacted with water The reaction of SO2 with O2 is 2SO2(g)+O22SO3(g) A 2.000-L flask was filled with 0.0400 mol SO2 and 0.0200 mol O2. At equilibrium at 900 K, the flask contained 0.0296 mol SO3 How many moles of each substance were in the flask at equilibrium?
12.42 The following reaction is in equilibrium in lake water: HCO,_(aq) + H+(aq)«=*H,CO,(aq) Predict the change in the reaction quotient, Q, for each disturbance below and use that prediction to explain how the equilibrium is shifted by the stress. NaHCOj is added to the lake. H,CO}is added. NaOH is added.
For the equilibrium 2 SO2(g) + O2(g) 2 SO3(g) Kc = 245 (at 1000 K) the equilibrium concentrations are [SO2] = 0.102, [O2] = 0.0132, and [SO3] = 0.184. The concentration of SO2 is suddenly doubled. Show that the forward reaction takes place to reach a new equilibrium.
The following reaction occurs when a burner on a gas stove is lit: CH4+2O2(g)CO2(g)+2H2O(g) Is an equilibrium among CH4, O2, CO2, and H2O established under these conditions? Explain your answer.
Many sugars undergo a process called mutarotation, in which the sugar molecules interconvert between two isomeric forms, finally reaching an equilibrium between them. This is true for the simple sugar glucose, C6H12O6, which exists in solution in isomeric forms called alpha-glucose and beta-glucose. If a solution of glucose at a certain temperature is analyzed, and it is found that the concentration of alpha-glucose is twice the concentration of beta-glucose, what is the value of K for the interconversion reaction?
Assume that the change in pressure of H2S is small enough to be neglected in the following problem, (a) Calculate the equilibrium pressures of all species in an equilibrium mixture that results from the decomposition of H2S with an initial pressure of 0.824 atm. 2H2S(g)2H2(g)+S2(g)Kp=2.2106 (b) Show that the change is small enough to be neglected.