19-42 A long 8-cm-diameter steam pipe whose external surface temperature is 90°C passes through some open area that is not protected against the winds. Determine the rate of heat loss from the pipe per unit of its length when the air is at 1 atm pressure and 7°C and the wind is blowing across the pipe at a velocity of 50 km/h.

19-42 A long 8-cm-diameter steam pipe whose external surface temperature is 90°C passes through some open area that is not protected against the winds. Determine the rate of heat loss from the pipe per unit of its length when the air is at 1 atm pressure and 7°C and the wind is blowing across the pipe at a velocity of 50 km/h.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter7: Forced Convection Inside Tubes And Ducts

Section: Chapter Questions

Problem 7.38P

See similar textbooks

Similar questions

What regime favors heat transfer and why?Laminar, Turbulent or Transitional
Consider laminar flow of air across a hot circular cylinder. At what point on the cylinder will the heat transfer be highest? What would your answer be if the flow were turbulent?
....A journal bearing is to be used for a centrifugal pump where the shaft diameter is 50 mm and the bearing length is 80 mm. The ambient and bearing surface temperatures are 20°C and 45°C, respectively. Which of the following is the heat dissipated by the bearing if the heat dissipation coefficient is 280 W/m2-°C? Group of answer choices 56 W 14 W 73 W 28 W
Consider turbulent forced convection in a circular tube. Will the heat flux be higher near the inlet of the tube or near the exit? Why?
How is the Reynolds number related to Darcy-Weisbach?
A long 8-cm-diameter steam pipe whose external surface temperature is 90°C passes through some open area that is not protected against the winds. Determine the rate of heat loss from the pipe per unit of its length when the air is at 1 atm pressure and 7°C and the wind is blowing across the pipe at a velocity of 50 km/h.
Air at 60°F flows over a 10-ft-long flat plate at 7 ft/s. Determine the local friction and heat transfer coefficients at intervals of 1 ft, and plot the results against the distance from the leading edge.
A long 10-cm-diameter steam pipe whose external surface temperature is 110°C passes through some open area that is not protected against the winds . Determine the rate of heat loss from the pipe per unit of its length when the air is at 1 atm pressure and 10°C and the wind is blowing across the pipe at a velocity of 8 m/s.
Question No. 3: During a cold winter day, wind at 55 km/h is blowing parallel to a 4-m-high and 10-m-long wall of a house. If the air outside is at 5°C and the surface temperature of the wall is12°C, determine the rate of heat loss from that wall by convection. What would your answer be if the wind velocity was doubled
Four power transistors, each dissipating 12 W, are mounted on a thin vertical aluminum plate (k = 237 W/m?K) 22 cm * 22 cm in size. The heat generated by the transistors is to be dissipated by both surfaces of the plate to the surrounding air at 20°C, which is blown over the plate by a fan at a velocity of 250 m/min. The entire plate can be assumed to be nearly isothermal, and the exposed surface area of the transistor can be taken to be equal to its base area. Determine the temperature of the aluminum plate. Evaluate the air properties at a film temperature of 40°C and 1 atm.
The effective surface temperature of the coil is 5°C. The surface area of the coil is such as would give 4.6 TR with the given entering air state of 40 m¾/min of a mixture of re- circulated room air and outdoor air enters cooling coil at 27°C dry bulb temperature and 15°C wet bulb temperature.. Determine the conditions of the air leaving the coil and the by-pass factor.
The effective surface temperature of the coil is 5°C. The surface area of the coil is such as would give 4.6 TR with the given entering air state of 40 m3/min of a mixture of recirculated room air and outdoor air enters cooling coil at 27°C dry bulb temperature and 15°C wet bulb temperature.. Determine the conditions of the air leaving the coil and the by-pass factor.