Answered: 2) The number of hydrogen atoms in a…

Science

Chemistry

2) The number of hydrogen atoms in a single stacking unit is: a. 1 b. 20 c. 6.02 x 1023 d. 1.2 x 1025

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter10: The Mole

Section: Chapter Questions

Problem 86A

See similar textbooks

Related questions

Q: What is the product of the following reaction? 2 CH₂CH₂CH₂ OH OH CH3CH₂CH₂CHCH CH3CH₂CHCH OH H…

A: aldol condensation is a condensation reaction in organic chemistry in which two carbonyl moieties…

Q: Draw Intermediate Aqueous workup Draw Product Aqueous workup Draw Product

A: KMnO₄ a oxidizing reagent it reacts with alkene and gives syn diol.

Q: Which of the following does NOT match a condition change to a resulting change in reaction rate? O…

A: Answer:Here:

Q: Write the relative reaction rates for the following reaction: A + 2B C

Q: What is the product of the following reaction? 2 CH3CH₂CH₂ 1. CHỊCHO OCH₂CH3 2. HCI

A: The Claisen reaction or Claisen condensation is a carbon–carbon bond forming reaction. In this…

Q: Select to Draw CH3CO₂Na THF 11 | Br

Q: What is the total number of oxygen atoms on the right-hand side of this chemical equation? 8 Al(s) +…

A: To count the number of atoms in the chemical equation, the coefficient and number of the subscripts…

Q: lodine displays a number of valencies in its compounds. Select from the list below, all the…

A: Answer:When different halogen atoms combine together to form a covalent compound then such compounds…

Q: * Incorrect. The conjugate base of diethyl malonate can serve as a nucleophile to attack a wide…

A: An arrow always depicts from a region of high electron density to low electron density ; that is…

Q: Draw the curved arrow mechanism for the initiation step in cationic polymerization when…

Q: X Incorrect. Modify the given copies of the starting material to draw the two condensation products.…

A: An arrow always depicts from a region of high electron density to low electron density ; that is…

Q: Write down the common (not IUPAC) names of the organic molecules that would be released if this…

A: Triglycerides undergo hydrolysis to give glycerol and 3 fatty acids. Here the hydrolysis of ester…

Q: A chemist adds a chemical to pure water and there is a 100-fold incre approximation of the new pH…

A: The objective of the question is to calculate the new .

Q: Explain why this is the correct spectra for these molecules. Identify a specific absorption band…

A: Given question is related to identifying the correct spectra for the given molecules and specific…

Q: a) to c) show the formulas of rubidium oxides and these are repeated in d) to f). From the options…

A: Answer:

Q: A common alkyne starting material is shown below. Predict the major product for each reaction.…

A: When an alkyne containing a terminal acidic hydrogen reacts with the strong base NaNH2, the acidic…

Q: Macmillan Learning Calculate the cell potential for the galvanic cell in which the given reaction…

Q: 1. Large biomolecules can be crystallized into lattices with the same unit cell features as more…

A: The objective of the question is to calculate the molar mass of the protein.

Q: What is the IUPAC name of the molecule bellow? CH3 H₂C CI

A: The given structure is:It has one carbonyl group attached to an oxygen atom which indicates that the…

Q: 11.- According to geometric isomerism, provide what isomer each molecule is: a) |||| b) FA FA

A: Constitutional isomers : Functional isomers are the constitutional isomers which share the same…

Q: Consider the reaction described by the equation The rate law is C₂H₂Br₂(aq) +31 (aq) → C₂H₂(g) + 2…

A: k=0.00592 M-1s-1rate of formation of C2 = 0.00205 and 0.00102 Ms-1

Q: 10. What is the product of this sequence of reactions? 이요 AICI 3 HNO3 H₂SO4 H₂/Pd NaNO₂ HCI CuBr

A: The given reactant is an ortho-para directing group. This is because, in the resonance structures, a…

Q: CH₂ HCI 1) Li / éter 2) Cul 3) CH₂Cl H₂SO4

A: Given that, the reaction sequence is:We need to identify the product and explain its formation.

Q: The molecule shown can be classified as a malonic ester O acetoacetic ester O aldol O Michael O…

A: The question is based on the concept of organic synthesis.We need to synthesize the product using…

Q: H C 1) CH₂CH₂CH₂CH MgBr 2) Н О², Н2О

A: Given is organic reaction. The given reactant is epoxide.The given reagent is Grignard reagent.

Q: Balance the chemical equation below using the smallest possible whole number stoichiometric…

Q: The following product is classified as a(an) only need to write ONE option. رم product (Michael,…

A: The question is based on the concept of organic retrosynthesis.We need to identify the type of…

Q: Draw the product of the reaction shown below at physiological pH (pH = 7.4). Ignore inorganic…

A: During the synthesis of peptides, sometimes it is necessary to protect the amino group or carboxylic…

Q: The compound below can react rapidly via an SN1 process: X₂ OTS Select the explanation of why this…

A: A unimolecular nucleophilic substitution reaction, often referred to as an SN1 reaction, is a type…

Q: A OH I HCI I

A: An arrow always depicts from a region of high electron density to low electron density ; that is…

Q: Draw the major organic product of the reaction shown. OH HI Select Draw / || |||

A: A nucleophilic substitution reaction is a reaction in which a nucleophile replaces the leaving…

Q: At 27 degrees celsius, the vapor pressure of pure water is 23.76 mmHg and that of an aqueous…

Q: please provide mechanism for the following reaction. Will like response! HO HO Scheme 5. G 26 (94%)…

A: Given reaction is an example of the oxidation reaction.In this reaction oxidation of secondary…

Q: c. In reaction B, a second isomeric product is expected to be formed in roughly equal amounts to the…

A: SN1 reaction mechanism: This reaction path proceeds through formation of a carbocation…

Q: Which of the following compounds, I, II, III, or IV do not have delocalized electrons, i.e. no…

A: Delocalisation of electrons occurs, when electrons are not associated with only one atom or bond,…

Q: Be sure to answer all parts. Find the pH of the equivalence points when 28.9 mL of 0.0850 M H₂SO3 is…

Q: The lone pairs on the oxygen atom in O both localized O both delocalized O one localized and one…

A: The compound belongs to a class of organic compounds called heterocyclic compounds. In this…

Q: The Clausius-Clapeyron Equation provides a relationship between the vapor pressure of a material and…

A: The Clausius-Clapeyron Equation is a fundamental formula in thermodynamics that establishes a…

Q: Balance the chemical equation below using the smallest possible whole number stoichiometric…

Q: What is the major product? heat H 如 Illi Ho d 營業 H 2 HO

Q: Imagine that a chemist puts 5.88 mol each of CH, and O, in a 100 container at constant temperature…

A: The objective of the question is to calculate the equilibrium constant.

Q: 55. Volume of Titram (ml) 24.70 24.80 24.90 25.00 25.10 25.20 25.30 Potential (mV) (A) 24.96 mL (B)…

A: Given is a table of potential vs volume.To find the volume of the titrant needed to reach the…

Q: Be sure to answer all parts. Find the pH of the equivalence points when 28.9 mL of 0.0850 M H₂SO3 is…

A: The Ka values of H2`SO3 are,

Q: Which of the following bond-line structures are of the same compound? Oland II OII and III O III and…

A: It is based on the numbering of the parent chain based on the substituents attached.The numbering of…

Q: Which one is the major product for the shown reaction? OH H₂C-C-CH3 CH3 O А OB C OE Na2Cr2O7 H2SO4 A…

A: In the question asked we need to find the major product out of the given options.To solve this we…

Q: What is the total number of carbon atoms on the right-hand side of this chemical equation?…

A: To answer this question we need to count the total number of atoms of carbon (i.e.- "C") on the…

Q: "rms' The root mean square velocity, expressed u is for a collection of particles and is directly…

A: The formula given is .The root mean square velocity is .The ideal gas constant is .The temperature…

Q: A chemist prepares a solution of barium chloride (BaCl2) by measuring out 1.1x102 mol of barium…

A: The moles of barium chloride given is .The volume of the solution is .To find the concentration of…

Q: What concentration of CIO3 results when 683 mL of 0.777 M AgCIO, is mixed with 827 mL of 0.313 M…

A: For AgClO3 solutionConcentration of AgClO3 solution = 0.777 M = 0.777 mol/LVolume of AgClO3 solution…

Q: Suppose you have prepared a mitochondrial extract that contains all the soluble enzymes of the…

Concept explainers

Stoichiometry

Stoichiometry is a chemical division that evaluates the quantitative content of the chemical process with the help of the reacting molecules or products taking part in the reaction. The term “stoicheion” in “Stoichiometry”, is an old Greek term for "element" whereas “metron” means "measure".

Question

2) The number of hydrogen atoms in a single stacking unit is:
a. 1
b. 20
c. 6.02 x 1023
d.
1.2 x 1025

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: In this step we find the answer.

VIEW

Step 2: In this step we write the explanation.

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

One mole of gallium (61023 atoms) has a mass of 70 grams, as shown in the periodic table on the inside front cover of the textbook. The density of gallium is 5.9 grams/cm3. What is the approximate diameter of a gallium atom (length of a bond) in a solid block of the material? Make the simplifying assumption that the atoms are arranged in a "cubic" array, as shown in the figure. Remember to convert to SI units.
A hydrate initially weighs 5.821 grams and is heated. After heating it weighs 3.331 grams. Assuming that the mass lost is water from the crystal lattice, determine the percent water in the hydrate initially. Answer with a number without a percent sign.
what is barye unit ? What is its definition? what is its history? explain complitly with barye history and physics
Patterson discovered that lead was getting into the environment by
Determine the formula weight of Al₂(SO₄)₃. Provide an answer to two decimal places.
Is there a difference between a homogeneous mixture of hydrogen and oxygen in a 2:1 ratio and a sample of water vapor? Explain.
You have two distinct gaseous compounds made from element X and element Y. The mass percents are as follows: Compound I: 30.43% X, 69.57% Y Compound II: 63.64% X, 36.36% Y In their natural standard states, element X and element Y exist as gases. (Monatomic? Diatomic? Triatomic? That is for you to determine.) When you react gas X with gas Y to make the products, you get the following data (all at the same pressure and temperature): 1 volume gas X + 2 volumes gas Y 2 volumes compound I 2 volumes gas X + 1 volume gas Y 2 volumes compound II Assume the simplest possible formulas for reactants and products in the chemical equations above. Then, determine the relative atomic masses of element X and element Y.
You have two distinct gaseous compounds made from element X and element Y. The mass percents are as follows: Compound I: 30.43% X, 69.57% Y Compound II: 63.64% X, 36.36% Y In their natural standard states, element X and element Y exist as gases. (Monatomic? Diatomic? Triatomic? That is for you to determine.) When you react gas X with gas Y to make the products, you get the following data (all at the same pressure and temperature): 1. volume gas X + 2 volumes gas Y2 volumes compound I 2. volumes gas X + 1 volume gas Y2 volumes compound II Assume the simplest possible formulas for reactants and products in the chemical equations above. Then, determine the relative atomic masses of element X and element Y.
58 Magnesium will burn in air to form both Mg3N2 and MgO. What mass of each product would be found if burning a 3.11-g sample of magnesium to completion produces a combined total of 5.09 g of the two products?
Calculate the average density of a single Al-27 atom by assuming that it is a sphere with a radius of 0.143 nm. The masses of a proton, electron, and neutron are 1.67261024g,9.10941028g, and 1.67491024g, respectively. The volume of a sphere is 4r3/3, where r is its radius. Express the answer in grams per cubic centimeter. The density of aluminum is found experimentally to be 2.70 g/cm3. What does that suggest about the packing of aluminum atoms in the metal?
2.71 Use the web to determine the amount of low-density polyethylene and high-density polyethylene produced annually in the United States. Which uses predominate in the applications of these two materials?
Oil spreads on the water to form a film 110nm thick. How many square kilometers(Km²) of the ocean will be covered by a slick formed from one barrel of oil(126L)