4. Sketch a heating curve of water from solid ice to steam. Please don't use the curve generated by the simulation. You can use a piece of paper and pencil for sketching. Label both axes, start with a random negative temperature in °C and end with a random temperature above 100 °C. Label the physical state of each of the five sections of the heating curve. Label the melting point and boiling point of water. Once you are done sketching, take a picture of it, upload the picture .

4. Sketch a heating curve of water from solid ice to steam. Please don't use the curve generated by the simulation. You can use a piece of paper and pencil for sketching. Label both axes, start with a random negative temperature in °C and end with a random temperature above 100 °C. Label the physical state of each of the five sections of the heating curve. Label the melting point and boiling point of water. Once you are done sketching, take a picture of it, upload the picture .

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter3: Matter-properties And Changes

Section: Chapter Questions

Problem 41A

See similar textbooks

Similar questions

A representation of liquid water is shown below. Which of the three representations that follow best describes the water after it has boiled into steam?
A burning match and a bonfire may have the same temperature, yet you would not sit around a burning match on a fall evening to stay warm. Why not?
Suppose that you are closing a cabin in the north woods for the winter and you do not want the water in the toilet tank to freeze. You know that the temperature might get as low as 30. C, and you want to protect about 4.0 L water in the toilet tank from freezing. Calculate the volume of ethylene glycol (density = 1.113 g/mL; molar mass = 62.1 g/mol) you should add to the 4.0 L water.
Assume you have 1 cup of ice (237 g) at 0.0 C. Calculate how much heating is required to melt the ice, warm the resulting water to 100.0 C, and then boil the water to vapor at 100.0 C. (Hint: Do three separate calculations and then add the results.)
solution is a homogeneous mixture. Can you give an example of a gaseous homogeneous mixture? A liquid homogeneous mixture? A solid homogeneous mixture?
7.The word pour is commonly used in reference to liquids but not to solids or gases. Can you pour a solid or a gas? Why or why not? If either answer is yes, can you give an example?
If 14.5 kJ of heat were added to 485 g of liquid water, how much would its temperature increase?
9.81 A substance has the following properties: Hfusion = 10.0 kJ/mol Hvaporiztion = 20.0 kJ/mol Cp(solid) = 30 J/mol/K Cp(liquid) = 60 J/mol/K Cp(gas) = 30 J/mol/K Which of the four graphs below would he most consistent with these data? Explain how you are able to identify the correct graph.