A 10 N aqueous sulfuric acid solution (30 degree Tw) is made to react with a 55% aqueous NaOH solution (64 degree Be, heavier than water) to form 135 g of Na2SO4 per 100 mL NaOH solution. The volume ratio of the acid solution to the base solution is 2: 1. Find: a. the Limiting reactant; excess reactant b. % excess reactant c. Degree of completion

A 10 N aqueous sulfuric acid solution (30 degree Tw) is made to react with a 55% aqueous NaOH solution (64 degree Be, heavier than water) to form 135 g of Na2SO4 per 100 mL NaOH solution. The volume ratio of the acid solution to the base solution is 2: 1. Find: a. the Limiting reactant; excess reactant b. % excess reactant c. Degree of completion

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter3: Statistical Tests With Excel

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

It is known that acid content has a major effect on theflavor of vinegars, but most cheaper vinegars are diluted similarly to 5% acidity Wt./vol. % is equivalent to gsolute per 100mL solution (so 5% is equivalent to 5 g acid/100 mL solution). a.) First, calculate the approximate molar concentration of acetic acid in the 5% wt./vol vinegar. b.) Next, calculate the expected molarity of acetic acid in the solution upon dilution by a factor of 5. Thank you!
Stock iron(II) solution (200Ug mL-1 Fe) ferrous ammonium sulfate hexahydrate mass= 0.1437g, transfer it to a 100 ml beaker. add 15 ml approx of water and 15m1 'approx of dilute sulphuric acid (2M H2SO.). then transfer FeII to 100 ml flask makeup to the mark with water. calculate the moles of ferrous ammonium sulfate hexahydrate solution in unit ug/mL.
In this station, you will find a sample of table salt; the chemical formula of table salt is NaCl. Using the balance, weigh out 6.00 g of NaCl and dissolve in 50 mL of deionized (d.i.) water. Once com-pletely dissolved, add additional d.i. water to make the final volume of solution 100.0 mL. What is the mass percent NaCl in the solution? What is the molarity of the solution
25 ppm of CaCO3 was found in the water sample obtained on the lake in the nearby town.Calculate the moles of CaCO3 having a molar mass of 100.09 g/mol in 10 liters of water samplesolution having a density of 997 kg/m3. (Ans.: 24.95 moles CaCO3)
What is the molarity of a concentrated solution of sulfuric acid with a specific gravity of 1.84 and 95.0% by weight sulfuric acid? specific gravity = density of substance at certain temp/density of water at 4 degrees C the density of water is 0.999973 g/mL at 4 degrees celsius. Describe how to prepare 3.0 L of 0.100M. I will pipet ______ and add this to 200mL water. The solution will be stirred and diluted to 3L with water.
Using the percent purity calculations, determine the percent yield of synthesis of aspirin. Part I Synthesis of Aspirin Mass of salicylic acid used (g) 2.029g Volume of acetic anhydride used (mL) 5ml Mass of acetic anhydride used (vol. × 1.08 g/mL) 5.4g Mass of aspirin synthesized (g) 3.256g Part II Melting Temperature Data Melting temperature (°C) 133°C Part III Salicylic Acid Standard Stock Solution Initial mass of salicylic acid (g) 0.210g Moles of salicylic acid (mol) 0.0147 mol Initial molarity of salicylic acid (M) 0.724 M Part III Beer’s Law Data for Salicylic Acid Standard Solutions Trial Concentration (M) Absorbance Water (mL) 1 10 0.301 0 2 7.5 0.219 2.5 3 5.0 0.163 5.0 4 2.5 0.074 7.5 Best-fit line equation for the salicylic acid standards Test of the Purity of the Synthesized Aspirin Initial mass of aliquot of product (g)…
Solution and explanation for Percentage Yield and Theoritical Yield for this data (Synthesis of Aspirin) Salicylic acid - 1.950 g Labeled watch glass - 50.664 g Labeled watch glass & piece of filter paper together - 50.872 g filter paper only - 0.208 g Where the data is from: https://youtu.be/tLXljLxRZ0U Room temperature - filter paper, watch glass and aspirin - 53.088 g
A powdered crude sample of Na2CO3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr.What is the %purity of the sample to the nearest whole number?
A concentration of toxic metals in plant tissue is often found by combusting the material in a furnace and then dissolving the ash in concentrated acid. A 0.5124-gram sample of leaves was combusted to ash and transferred to a 150-mL beaker. A 25-mL portion of concentrated HCl was added and the mixture was heated on a hot plate. Three 5-mL portions of concentration HCl were added over approximately 10 minutes with continued heating in between additions. The resulting mixture was cooled to room temperature and filtered into a 50-mL volumetric flask, which was brought to volume using distilled water and mixed well. From this stock solution, a 10-mL portion was pipetted into a clean 50-mL volumetric flask, brought to volume with distilled water, and mixed. This final solution was analyzed and found to contain 12.1 ppm lead. What are the mass percent of lead in the original plant tissue?
A stock solution of 75% v/v ethanol was diluted with distilled water to prepare 1L of 42% v/v ethanol. (Density of ethanol = 0.789 g/mL; MW of ethanol = 46 g/mol). Determine the initial volume (in mL) of 75% v/v ethanol used in the preparation. Final answer should NOT contain any unit. Type the VALUE only. Please observe 0 decimal places.
Prepare 1500mL of 0.5N H2SO4 solution with specific gravity of 1.84g/mL and assay of 97%
A solid sample contains unknown amounts of potassium and magnesium chloride and moisture. 1.193 g of the sample is dissolved in water and the solution is diluted to 250.00 mL. 25.0 mL of the sample is allowed to pass through an H + -saturated cation exchanger, the eluate consuming 22.03 mL of a 0.100 M NaOH solution. The moisture content of the sample was determined to be 5.22%. Calculate the % by weight of potassium and magnesium chloride in the sample.