2. A tank contains 100 liters of brine holding 60kg of salt in solution. Water containing 1kg of salt per liter flows into the tank at the rate of 2 liters per minute, and the mixture, kept uniform by stirring, flows out at the rate of 3 liters per minute. a. What is the initial concentration of salt in the solution in kg/L? b. What is the volume of the solution in the tank after one hour? c. Find the amount of salt at the end of 1 hour.

2. A tank contains 100 liters of brine holding 60kg of salt in solution. Water containing 1kg of salt per liter flows into the tank at the rate of 2 liters per minute, and the mixture, kept uniform by stirring, flows out at the rate of 3 liters per minute. a. What is the initial concentration of salt in the solution in kg/L? b. What is the volume of the solution in the tank after one hour? c. Find the amount of salt at the end of 1 hour.

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter1: Basic Concepts Of Chemistry

Section: Chapter Questions

Problem 49RGQ: Fluoridation of city water supplies has been practiced in the United States for several decades. It...

See similar textbooks

Similar questions

(a) A solution of 20.91 % by weight H₂SO4, has a specific gravity of 1.150. What is the normality of this solution? (b) Water is added to dilute this solution to a solution of 3.03% by weight H2SO4 (SG=1.020). What is the new normality of the resulting solution and how were they mixed? (Assume 100 mL of the original solution was used.)
A 5.00% (m/v) dextrose (glucose) solution is typically used as an IV solution for patients with low blood sugar that need carbohydrates and/or have fluid loss. This solution can be made by weighing 5.00 g glucose and dissolving it in enough water to make 100. mL of solution. A patient needs at least 2.00 L of specialized IV of 7.50% (m/v) dextrose solution. A sterile solution was made by doing the following: 150. g glucose was dissolved in 2.330 kg of water to make a solution volume of 2.00 L . The molar mass of dextrose (glucose) is 180. g/mole. (a) What is the density of the solution? g/mL (b) What is the %(m/m) of the solution? % (m/m) (c) What is the molarity of the solution? M (d) What is the molality of the solution? m
You have been tasked with determining the wastewater solids generated by a community. To determine solids, you collect two effluent samples of 100 mL each. The first sample was placed, unfiltered, in a crucible and dried at 105 ̊C overnight. The weight of the dried sample and crucible was 5.6112 g, while the weight of the crucible was 5.6000 g. The second sample was filtered. The filter and drying dish were dried overnight at 105 ̊C after which they weighed 2.1085 g. The filter and drying dish were then placed in a muffle furnace at 550 ̊C for 30 mins, after which they weighed 2.103 g. The drying dish weighs 1.6000 g and the filter weighs 0.5 g. a) Determine the concentration of TS, TSS, VSS, FSS and TDS in mg/L: b) Does TSS concentration meet the federal effluent regulations? If not, what removal techniques would you recommend and what minimum percent must be removed prior to discharge?
(a) A solution of 20.91 % by weight H2SO4 has a specific gravity of 1.150. What is the normality of this solution? (b) Water is added to dilute this solution to a solution of 3.03% by weight H2SO4 (SG= 1.020). What is the new normality of the resulting solution and how were they mixed? (Assume 100 mL of the original solution was used.)
8.5 mL of a sample of sea water solution was added to a 44.317 g evaporating dish. The combination weighed 52.987 g. After evaporation the dish and contents weighed 44.599 g. a. What was the mass percent of dissolved solids in the sea water?
Stock iron(II) solution (200Ug mL-1 Fe) ferrous ammonium sulfate hexahydrate mass= 0.1437g, transfer it to a 100 ml beaker. add 15 ml approx of water and 15m1 'approx of dilute sulphuric acid (2M H2SO.). then transfer FeII to 100 ml flask makeup to the mark with water. calculate the moles of ferrous ammonium sulfate hexahydrate solution in unit ug/mL.
A) An aqueous solution of ethyl alcohol is made by transfering 4.72 mL of liquid ethyl alcohol to a 200 . mL volumetric flask, and then adding enough water to fill the flask to the mark. What is the volume/volume percentage of ethyl alcohol in the solution? Volume/volume percentage = ________% B) An aqueous solution of acetic acid is made by transfering 17.5 mL of liquid acetic acid to a 200 . mL volumetric flask, and then adding enough water to fill the flask to the mark. What is the volume/volume percentage of acetic acid in the solution? Volume/volume percentage = ________%
An aqueous solution of sodium hydroxide, NaOH , is made by dissolving 15.6 grams of sodium hydroxide in sufficient water in a 500. mL volumetric flask, and then adding enough water to fill the flask to the mark. What is the weight/volume percentage of sodium hydroxide in the solution? Weight/volume percentage = %