A bridge type rectifier circuit has the following specifications: ac supply line is 120 volts, average load power is 3W, and secondary peak voltage is 70 volts. Determine the following: (a) load resistance, (b) peak voltage of each diode, (c) average load current, (d) turns ratio of transfer

A bridge type rectifier circuit has the following specifications: ac supply line is 120 volts, average load power is 3W, and secondary peak voltage is 70 volts. Determine the following: (a) load resistance, (b) peak voltage of each diode, (c) average load current, (d) turns ratio of transfer

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Related questions

Q: Design rectifier circuits to provide an output of 100 VDC using a half wave rectifier calculate the…

Q: The 12.6V secondary of a transformer is connected to a half-wave rectifier and a 20-ohms load…

Q: Setup the Half Wave Rectifier using LiveWire Simulation software for the given below values. f=1HZ…

Q: Explain the firing angle range in the half-wave and full-wave controlled rectifier circuits feeding…

A: The solution is mentioned below

Q: A center tapped rectifier is supplied using 220 V,60 Hz supply, then using ideal mode, the peak…

A: Given, A center tapped rectifier has, Input voltage (Vi)= 220 volts (rms value) Frequency (f)= 60 Hz

Q: B. Draw the schematic diagram of a full wave bridge type rectifier. Explain its operation and sketch…

Q: Find the approximate dc voltage produced by a center tapped full wave rectifier, if the peak output…

A: Find the output voltage of the centre tap. Rectifier. Peak voltage Vm= 8V Diode cut off voltage…

Q: Discuss the advantages and disadvantages of all rectifier circuits :

Q: 3- What are the advantages of full wave rectifier comparing to half wave? 4- What is the effect of…

A: Need to explain

Q: Q2. A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60…

A: Given data, Supply RMS voltage Vr=90 V. Frequency f=60 Hz. Load resistance RL=440 Ω.

Q: 4):-A three-phase half wave controlled rectifier has a supply of 150V/phase. Determine the mean load…

Q: What is the approximate rms value of secondary voltage to get a peak load voltage of 40 V out of a…

Q: What will be average output voltage of a 3 phase, 6 pulse rectifier with a line to neutral voltage…

A: For a three-phase, six pulse rectifier circuit, the value of the average output voltage can be…

Q: 1. Explain the operation of the half-wave rectifier circuit.

A: We are authorized to answer 1 question at a time so i am answering only 1st please repost your…

Q: 38. The single-phase ac center-tap full-wave rectifier input voltage is 230 V (rms). Determine the…

Q: B) Explain the effect on the output signal for changing the frequency of the input signal in a…

A: Explanation: Here for the half-wave rectifier, we use general RL load The circuit diagram input…

Q: What is the value of angle of conduction for half wave rectifier. Briefly Explain

Q: A half-wave rectifier circuit has the following specifications: ac supply line is 120 volts, load…

A: A Half-bridge rectifier is an AC to DC converter. single-phase HWR converts AC voltage into…

Q: 1.Why DC Output power should be increased in Rectifier Circuit?

A: Need to find why DC output power should be increased

Q: a half wave rectifier is supplied using 240 V (rms), 50 Hz supply, then using constant voltage drop…

Q: Discussion: - 1-from the output signal for half and full wave rectifier, calculate the peak, root…

A: A full wave rectifier converts both halves of an alternating wave (AC signal) cycle into a pulsating…

Q: A three phase full wave uncontrolled bridge rectifier has an AC input voltage of 90 V RMS at 60 Hz…

A: Given, A three phase full wave uncontrolled bridge rectifier, Vin= 90V rms (line…

Q: 3. The current supplied by a rectifier has a sinusoidal wave shape with a maximum value of 6.83 amp.…

A: Use average value integral to calculate average output current of full wave and half wave…

Q: diode circuit responsible to add or restore a DC voltage level to an input AC signal: A) Rectifier…

A: The explanation is as follows.

Q: 2. What design parameters of the half wave single-phase rectifier?

A: (2) A rectifier is an electronic device that converts AC voltage into DC voltage. In other words, it…

Q: Consider the half wave rectifier is supplied with 115V, 80HZ signal. Assume the number of turns in…

Q: b) From a single-phase half-wave rectifier circuit, demonstrate on how the DC outp voltage being…

Q: 1_Why Ripple factor should be minimized in Rectifier Circuit?

A: As per Bartleby guidelines we are allowed to solve only one question,please ask the rest again. The…

Q: 1. Calculate the theoretical output DC voltage of the half-wave rectifier circuit and compare it…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What is the difference of (a) half-wave rectifier, (b) full-wave rectifier, an describe its nature…

Q: Connect the half-wave rectifier with resistive load (RL=1KΩ ) and set the parameters value of peak…

A: The half wave rectifier circuit diagram and its working is thoroughly explained along with the…

Q: Given a half wave rectifier with input ac voltage of 200 Vrms, a transformer turns ratio of 18:3 and…

A: In the half wave rectifier Find the peak voltage in primary side Secondary side Peak value of load…

Q: calculate the (a) average dc output voltage and (b) RMS output voltage using the equation for…

A: Fig: Output waveform of a half-wave rectifier From the given…

Q: Explain the factor that affects the output voltage of a power supply circuit: Zener diode as a…

A: fators affecting output voltage

Q: What will be the consequence of one diode failing open in the bridge rectifier of a single-phase…

A: The diodes are made of semiconductor materials. Silicon and germanium are common semiconductors for…

Q: The half-wave rectiﬁer as shown is operating at a frequency of 60Hz, and the rms value of the…

A: Given data, The value of rms voltage is Vrms = 12.6±10% V. The value of operating frequency is f =…

Q: what do you know about Full Wave Bridge Rectifier operation explain in detail?

Q: 3. Full Wave Center Tapped Rectifier a. Determine V, and the required PIV rating of each diode for…

Q: Create a rectifier circuit that provides an output of 100Vdc by using the following circuit: a. Half…

A: Half wave rectifier circuit. Vi=Vmsin(ωt)Vo=12π∫0πVmsin(ωt)d(ωt) =Vmπ

Q: 4) Consider the half-wave rectifier circuit shown below. The ac input voltage to the circuit is a 60…

A: Circuit Vrms = 6.3 = Vm2Vm = 6.32c = 47 mF , Rl = 10Ω(a) Peak o|p voltage across load RL→During…

Q: What is the value of angle of conduction for Full wave rectifier. Briefly Explain

A: Rectifier is device which convert alternating signal in to pulsating direct signal. Diode is…

Q: 2. What is the value of the peak inverse voltage on the diode in half -wave rectifier?

A: As per Bartleby guidelines we are allowed to solve only three subparts please ask the rest again.…

Q: What happens when one of the diode is removed from the bridge rectifier? Show the input and output…

A: Bridge Rectifier:-

Q: Explain the working operation of the V-I characteristics of the Silicon-Controlled Rectifier.

A: Figure 1 shows the symbol of an scr or silicon controller rectifier. It is an 3 terminal device…

Q: Draw a reference three phase input signal, the output voltage and current waveforms of a three phase…

A: The three pulse rectifier is given by :

Q: Q1/ a/Draw the output voltage waveform for the bridge rectifier in this figure : D 120 V ms B/ What…

A: Need to find ouput voltage and PIV

Question

A bridge type rectifier circuit has the following specifications: ac supply line is 120 volts,
average load power is 3W, and secondary peak voltage is 70 volts. Determine the following:
(a) load resistance, (b) peak voltage of each diode, (c) average load current, (d) turns ratio of
transfer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
A 24-V secondary of a transformer is connected to a half-wave rectifier and a 50 ohms load device. Calculate the DC output voltage Calculate the average current Which rectifier diode would be adequate for this application?
The 12.6V secondary of a transformer is connected to a half-wave rectifier and a 20-ohms load device. Calculate the average DC output voltage Calculate the average current Which rectifier diode would be adequate for this application?
1- Connect the half-wave rectifier with resistive load (RL=1KΩ ) and setthe parameters value of peak amplitude equal (220) volt, frequency equal(50) HZ.2- Draw the output waveform for the DC output and the r.m.s value of theoutput voltages.3- What is the value of the peak inverse voltage on the diode in half -waverectifier?
What are the performance parameters of rectifier?
What will be average output voltage of a 3 phase, 6 pulse rectifier with a line to neutral voltage of 1230 V?
A center tapped rectifier is supplied using 220 V,60 Hz supply, then using ideal mode, the peak inverse voltage of the diode is equal to
Q#2: what do you know about Full Wave Bridge Rectifier operation explain in detail?
Explain the working operation of the V-I characteristics of the Silicon-Controlled Rectifier.
Explain the concept of operation of the half-wave rectifier circuit from input to output and how the AC signal will be converted to DC output shown in the photo. Thank you.
Half wave rectifier and full wave rectifier circuit, what is the relationship between the input voltage waveformand resistor voltage waveform if the diode is shorted? Does the input voltage waveform and resistor voltage waveform has the same peak value when the diode is present? Explain why.
What is the purpose of a rectifier circuit? Describe the operation of a half-wave rectifier and a full-wave rectifier using diodes. Draw network and input-output voltages of both cases.