A certain gas at 101.325 kPa and 16°C whose volume is 2.83 m³ are compressed into a storage vessel of 0.31 m³ capacity. Before admission, the storage vessel contained the gas at a pressure and temperature of 137.8 kPa and 24°C; after admission the pressure has increased to 1171.8 kPa. What should be the final temperature of the gas in the vessel in Kelvin? (4 decimal places)

A certain gas at 101.325 kPa and 16°C whose volume is 2.83 m³ are compressed into a storage vessel of 0.31 m³ capacity. Before admission, the storage vessel contained the gas at a pressure and temperature of 137.8 kPa and 24°C; after admission the pressure has increased to 1171.8 kPa. What should be the final temperature of the gas in the vessel in Kelvin? (4 decimal places)

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter1: Gases And The Zeroth Law Of Thermodynamics

Section: Chapter Questions

Problem 1.11E: What is the value of FP for a sample of gas whose temperature is -33.0 C and volume is 0.0250 L?...

See similar textbooks

Similar questions

Urea (H2NCONH2) is used extensively as a nitrogen source in fertilizers. It is produced commercially from the reaction of ammonia and carbon dioxide: 2NH3(g)+CO2(g)----heat----> H2NCONH2(s) + H2O(g) Ammonia gas at 223°C and 90 atm flows into a reactor at a rate of 500 L/min. Carbon dioxide at 223°C and 45 atm flows into the reactor at a rate of 600 L/min. What mass of Urea is produced per minute by this reaction assuming 100% yield.
The label has come off a cylinder of gas in your laboratory. You know only that one species of gas is contained in the cylinder, but you do not know whether it is hydrogen, oxygen, or nitrogen. To find out, you evacuate a 5-liter flask, seal it and weigh it, then let gas from the cylinder flow into it until the gauge pressure equals 1.00 atm. The flask is reweighed, and the mass of the added gas is found to be 13.0 g. Room temperature is 27°C, and barometric pressure is 1.00 atm. What is the gas?
To evaluate the use of renewable resources, an experiment was carried out with rice hulls. After pyrolysis, the product gas analyzed 6.4% CO2, 0.1% O2, 39% CO, 51.8% H2, 0.6% CH4, and 2.1% N2. It entered a combustion chamber at 90 °F and a pressure of 35.0 in. Hg and was burned with 40% excess air (dry) at 70 °F and an atmospheric pressure of 29.4 in. Hg; 10% of the CO remains. a. How many cubic feet of air were supplied per cubic foot of entering gas? b. How many cubic feet of product gas were produced per cubic foot of entering gas if the exit gas was at 29.4 in. Hg and 400 °F?
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In a hospital, pure oxygen may be delivered at 50 psi (gaugepressure) and then mixed with N2O. What volume of oxygen at 20Cand 50 psi (gauge pressure) should be mixed with 1.7 kg of N2O toget a 50%/50% mixture by volume at 20C? (a) 0.21 m3; (b) 0.27 m3;(c) 1.9 m3; (d) 100 m3
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In another test, the valve of a 500 L cylinder full of the gas mixture at 2000 psi (gauge pressure) is opened wide so that the gas rushes out of the cylinder very rapidly. Why might some N2O condense during this process? (a) This is an isochoric process in which the pressure decreases, so the temperature also decreases. (b) Because of the rapid expansion, heat is…
A mixture of propane and methane occupied 122 mL at 25⁰C and 1.0 atm. This mixture was totally burned in excess O2 to produce CO2(g) and H2O(g). The mass of the CO2 produced was 0.506 g. What is the mass % composition of the original mixture? Show all work.
Ammonia (considered to be ideal gas, 1 mole) initially at 25 degree C and 1 bar pressure is heated at constant pressure until the volume has tripled.Use CP = 25.895 + 32.999 x 10^– 3 T – 30.46 x 10^– 7 T2 , J/mole-KCalculate: a) Q b) W c) delta H
A rubberized, cubic chamber was filled with butane gas and was expanded from 3.0L to 4.5L at a pressure of 2.7atm and it absorbed 230J of heat from the surroundings. b. Assuming that the internal energy of this system is all kinetic energy and that the cube contains one mole of butane gas, what is the velocity of a single butane molecule covering a distance between the opposite corners of the expanded cube (express in m)? How long would it take to cover that distance (express in sec, use SI prefixes instead of scientific notation)?c. How much power can be generated by all the molecules in this cube after 1 hour? Express your answer in W. (Use the v obtained from 2b then recompute total KE) (Note that 1L atm=101.325J)
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. The beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
Gypsum (plaster of Paris : CaSO,. 2H,0) is produced by the reaction of calcium carbonate and sulfuric acid. A certain lime stone analyzes: CaCO, 96.89 %; MgCO, 1.41 %; inerts 1.70 %. For 5 metric tons of limestone reacted completely, determine: a. kg of anhydrous gypsum (CaSO,) produced. b. kg of sulfuric acid solution (98 wt%) required.
I have a geothermal heat pump that heats and cools my house. It heats the houses by compressing 286K refrigerant at 1 ATM, and compresses it to 1.2ATM. What temperature (in Kelvin) is the compressed refrigerant in the radiator?
Boyle’s law for confined gases states that if the temperature is constant, pv = c, where p ispressure, v is volume, and c is a constant. At a certain instant the volume is 75 cubic inches, thepressure is 30 psi, and the pressure is decreasing at the rate of 2 psi every minute. What is therate of change of the volume at that instant?