A container is filled with a liquid of density p. The surface of the liquid is at atmo- spheric pressare R. A faucet is installed at a distance D below the surface of the liquid. The diameter of the thicker part of the faucet is 2d and its thinner part is d< D. What is the pressure in the thicker part of the faucet when the faucet is open? Express your answer in terms of P. 9, D, and Po only. Atmosphere pressure P, 2d 47.14769.70- Feb 8, 20

A container is filled with a liquid of density p. The surface of the liquid is at atmo- spheric pressare R. A faucet is installed at a distance D below the surface of the liquid. The diameter of the thicker part of the faucet is 2d and its thinner part is d< D. What is the pressure in the thicker part of the faucet when the faucet is open? Express your answer in terms of P. 9, D, and Po only. Atmosphere pressure P, 2d 47.14769.70- Feb 8, 20

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A vertical, clean, glass piezometer tube has an insidediameter of 1 mm. When pressure is applied, water at20 ° C rises into the tube to a height of 25 cm. After correctingfor surface tension, estimate the applied pressurein Pa.
A closed cylindrical vessel, 2m in diameter & 4m high is fully filled with water & rotated to its vertical axis at a constant speed of 12.2 rad/sec. The top is pressurized by 180 KPa. (a) What is the pressure at the center bottom of the cylinder? (b) What is the pressure at the circumference bottom of the cylinder? (c) What is the total hydrostatic force at the sides of the cylinder?
What is the smallest diameter glass tube that will keep the capillary height-change of water at 20 deg.C. less than 0.9 mm?
Pressure in a water container can be measured by an open vertical tube. If the expected water rise is about 20cm. What tube diameter is needed to ensure the capillary action is less than 3%?
The pressure at a point “m” in the figure shown was increased from 70 kPa to 105 kPa. This causedthe top level of mercury to move 20 cm in the sloping tube. What is the inclination, θ?
The U-tube in Fig has a 1-cm ID and contains mercuryas shown. If 20 cm 3 of water is poured into the righthandleg, what will the free-surface height in each leg beafter the sloshing has died down?
A vertical tube, 3-cm diameter and 1.2-m long, has its upper end open to the atmosphere. The tube contains equal volumes of oil (RD 0.85) and water. If the tube is full, find a) the gage pressure at the bottom of the tube; b) the total weight of the liquids
A triangular gate having horizontal base of 1.0m and an altitude of 1.5m is inclined 45° from the vertical with the vertex pointing upward. The vertex of the gate is 2.4m vertically below the surface of the water. What normal force , in KN, must be applied at the vertex of the gate to open it's hinged at the base?
water has surface tension of 72 dyne/cm. what contact angel would water make with this surface?
Find the capillary raise of the water in the tube of diameter 6mm, which is immersed vertically in the container. The surface tension of water is 0.07115 N/m. Take the angle of contact is = 00 The capillary raise of water in the tube is (unit in mm)= ______
A Horizontal Capillary Tube (Radius 10 Um) Con- Tains An Oil/Water Interface. The Pressure In The Oil Phase Is 14.5 Psi (100 KPa). Determine The Pressure In The Water Phase If The Contact Angle Is 30° And The IFT Is 30 Dynes/Cm (30 MN/M).
A cylindrical tray with liquid inside (densityp) is rotated about its axis of symmetry, which is vertical. If the angular velocity is , show that the pressure at a distance r from the axis of rotation is: P = P₁ + = pw²r² Where Po is the pressure at r=0.