A cylinder leakage (leak-down) test indicates 30% leakage, and air is heard coming out of the air inlet. Technician A says that this is a normal reading for a slightly worn engine. Technician B says that one or more intake valves are defecti

A cylinder leakage (leak-down) test indicates 30% leakage, and air is heard coming out of the air inlet. Technician A says that this is a normal reading for a slightly worn engine. Technician B says that one or more intake valves are defecti

Automotive Technology: A Systems Approach (MindTap Course List)

6th Edition

ISBN:9781133612315

Author:Jack Erjavec, Rob Thompson

Publisher:Jack Erjavec, Rob Thompson

Chapter9: Automotive Engine Designs And Diagnosis

Section: Chapter Questions

Problem 5ASRQ: While looking at the results of an oil pressure test: Technician A says that higher than normal...

See similar textbooks

Related questions

Q: Pressure regulators are being discussed. Technician A says they are located in the fuel rail.…

A: Pressure Regulator are the important component of fuel rail system The function of Fuel pressure…

Q: The firing lines on an oscilloscope pattern are all abnormally low. Technician A says that the…

A: Solution:

Q: The amount of fluid allowed to enter the cylinder can be controlled, this is done with the use of…

A: Direction control valve

Q: Because the diesel engine has a lower compression ratio the thermal efficiency will be higher…

A: given: A comparison between the actual gasoline engine and actual diesel engine is to be made.…

Q: - Distinguish the major differences between centrifugal compressors and axial compressors - List the…

A: The major differences between the centrifugal compressor and axial compressors are given as, (1) In…

Q: Identify the true statement from the following O Venturimeter is a rate of flow measuring instrument…

A: # Venturimeter is used for flow measuring not for Rate of flow so this statement wrong #venturimeter…

Q: The following results refer to a test on a petrol engine

Q: Unburned HC and Carbon mono-oxide reduced in the exhaust gases if the A/F decreased True False

A: Unburned HC and Carbon mono-oxide reduced in the exhaust gases if the A/F decreased True False

Q: A technician is inspecting a vehicle and finds the upper radiator hose is collapsed, and the cooling…

A: Given :- A technician is inspecting a vehicle and finds the upper radiator hose is collapsed, and…

Q: Q157. an injector balance test requires an injector pulse tester and a ____ . a. fuel pressure…

A: An injector balance test requires an injector pulse tester and a

Q: iscuss what is the effect of efficiency on compressor temperature and duty.

A: A compressor is a device that reduces the volume of a material (typically a gas) to raise its…

Q: Which of the following is similar to a PCV valve but is specific to diesel engines? PCM EGR AIR…

A: PVR (positive crankcase ventilation): The PVR valves are not required in diesel engines. The PCV…

Q: True or False? Oil pressure is determined bywhether the pump is a gear type or rotor typeand by oil…

A: Given Data : Oil Pressure

Q: Which of the following is true of variable intake manifolds? a)they are designed to reduce intake…

A: Solution:

Q: The centrifugal compressors are used to produce low flow rates Select one: True False

A: Centrifugal compressor: It is a mechanical device which is use to compress the fluid (air,…

Q: In this diagram, which pressure differential valve has pressure loss? Which part of the system has…

A: Differential valves are used for detecting differential pressure. detection of the valve failure of…

Q: 38) Technician A says that most pressure regulating valves work by balancing hydraulic pressure…

A: In pressure regulators the hydraulic pressure is balanced by spring force. In this system fluid…

Q: Choose correct answer: A single way valve that lets air into the pneumatic system, but doesn’t…

A: the correct answer is check valve.

Q: When checking the exhaust system, the Certified Inspector must reject the vehicle if: It does not…

A: While checking the exhaust system the inspector must reject the vehicle if it has no muffler,…

Q: es are favored because of their lower cost and lighter weight Correct answer plug ball poppet…

A: To select the correct options.

Q: An injector balance test requires an injector pulse tester and a

A: The balance test will disable an injector to check if it changes idle quality. It also checks or…

Q: What checks can be performed to know if the lubricating oil of an engine has been contaminated?

A: Techniques to check whether the lubricating oil is contaminated are as follows, Debris analysis Wear…

Q: When performing an engine oil level check, if additional oil is needed, estimate the amount by…

Q: which of the following statements regarding relief valves is not true? A. A blown fusible plug must…

A: Which of the following statements regarding relief valves is not true? Answer: D. Spring-loaded…

Q: Which of the following statement(s) about steam calorimeters is/are correct? O The ideal degrees of…

Q: When fitting a freshly ground valve into a freshly ground seat: Technician A says that the seat…

A: The reconditioning of the valve seats is done to remove cracks, pitting and grooves from its…

Q: On the low-pressure side of a double diaphragm seal system, the transmitter measures a pressure of…

A: Given: There are double diaphragm seal system. On the side of low pressure there are a pressure of…

Q: True False Pressure reducing valves are used to limit maximum system pressure. True False Unlike…

A: Answer is given below:

Q: briefly 1. Valve lag 2. intake lag

Q: Technician A says that liquid cooling an engine helps to maintain a consistent operating…

A: A liquid cooling system is used in an engine to dissipates heat and helps to maintain a consistent…

Q: A compression test gave the following results: cylinder #1 = 155, cylinder #2 = 140, cylinder #3 =…

A: Here, compression in cylinder #1 nad cylinder #2 is near to each other, however pressures of…

Q: When using a fuel injector pulse tester, Technician A says that little or no pressure drop indicates…

Q: The hydraulic system is free from noise and produces high pressure. Select one: True False

A: the hydraulic system is not free from noise hence it is a false statement. hydraulic system can…

Q: Technician A says that excessive engine oil consumption can be caused by low oil levels. Technician…

A: Answer:- Technician B correct.

Q: Technician A says throttle pressure is controlled directly by the pressure regulator valve.…

A: According to Technician A - "throttle pressure is controlled directly by the pressure regulator…

Q: The gas/oil mixture used in a two stroke engine has been properly mixed. The carburetor high speed &…

A: Both tech are correct.

Q: quick tests to a GM hot film mass airflow meter on an engine with idling problems are being…

A: Hot film sensor The hot-film sensor is used for the indication of mass airflow entering the engine.…

Q: pressure from the indicator diagram using a planimeter? 6.) Besides from planimeter what other way…

Q: .1 Briefly explain how a fixed choke carburettor works Air flows into the top of the _from the air…

A: Hii, thanks for the question but we are authorized to answer one question at a time, since you have…

Q: Technician A says that air-fuel ratios can be regulated by controlling the “on time” of the…

A: Answer is a

Q: Technician A says that broken engine mounts can cause the fan to hit the shroud. Technician B says…

A: Solution:

Q: While discussing valve body assemblies in late-model transmissions: Technician A says that the valve…

A: Automatic transmission valve body is a major part of a vehicle’s automatic transmission system. It…

Q: Complete the following statement about compression testing using the following words. Words:…

A: 1 Before conducting a compression test, disable the ignition and the fuel ignition system. Most…

Q: To determine the quality of the steam that enters the steam prime movers, different types of steam…

A: Throttling calorimeter: - A throttling calorimeter is used to determine the dryness fraction of the…

Q: Why should the EGR valve remain closed at idle and at full throttle? What are requirements of BS VI…

A: EGR Valve has primary two setting i.e. Open and Closed. The EGR Valve is closed when the engine is…

Q: Which of the following statements is not true? A direct acting PRV: Is complex in construction,…

A: Note: As per our guidelines we are allowed to answer one question at a time. Please resubmit…

Q: Technician A says that when draining the engine oil, the engine should be fully cold for best…

A: CORRECT ANSWER IS D) NEITHER A NOR B As the old engine oil should be drained when the engine is warm…

Q: Discuss the importance of the valve system in an internal combustion engine.

A: Internal combustion engine: It is a combination of mechanical devices which is used to produce the…

Concept explainers

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

While discussing the results of an oil pressure test: Technician A says that when the fluid pressures are high, internal leaks, a clogged filter, low oil pump out put, or a faulty pressure regulator valve are indicated. Technician B says that if the fluid pressure increased at the wrong time, an internal leak at the servo or clutch seal is indicated. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
While determining the most likely problem of an engine with poor compression test results but acceptable cylinder leakage readings: Technician A says that the problem may be incorrect valve timing. Technician B says that the problem is worn valve seats. Who is correct? Technician A Technician B Both A and B Neither A nor B
Technician A says an engine may use one or more valve springs per valve. Technician B says additional valve springs are used to control vibration and increase total pressure. Who is correct? a. Technician A b. Technician B c. Both A and B d. Neither A nor B
Explain why a small PCV valve opening is adequate at idle speed.
True or False? Valve lash is adjusted in many different ways; however, on many OHC engines, the clearance is set by replacing a shim.
Technician A says that the purpose of a valve body is to increase oil pressures in response to increases in engine speed. Technician B says that valve bodies are normally fitted with three different types of valves, which start, stop, or use movable parts to regulate and direct the flow of fluid throughout the transmission. Who is correct? a. Technician A only b. Technician B only c. Both A and B d. Neither A nor B
Which of the following is not an effective way to determine if an engine has an internal coolant leak? Performing a pressure test on the system Visually inspecting the exhaust, coolant, and engine oil Using a dye penetrant and black light Using a combustion leak tester
True or False? A compression gauge will show the amount of air leaking through a cylinder as a percentage.
Technician A says that if an engine had good results from a compression test, it will have good results from a cylinder leakage test Technician B says that if an engine had good results from a cylinder leakage test, it will have good results from a running compression test Who is correct? Technician A Technician B Both A and B Neither A nor B
True or False? No-start, surging, or stalling can be caused by an EGR valve that does not open.
Technician A says it is not necessary to measure valve stem height unless the valves have been replaced. Technician B says valve stem height can be adjusted with shims. Who is correct? Technician A Technician B Both A and B Neither A nor B
While determining the cause for air leaking out of the oil throttle body during a cylinder leakage test: Technician A says that a burnt intake valve is indicated. Technician B says that a warped cylinder head or bad head gasket is indicated. Who is correct? Technician A Technician B Both A and B d. Neither A nor B