solv b Task 1:A dam is used to store water, and a circular gate which is hinged at its bottom edge is used tocontrol the flow as shown in figure 1. A pressure of 300 kPa is applied to the water free surface.For this gate, width=1 m (in the direction of the page), hị =1 m, and h2 = 6 m.P = 300 kPahiWaterAtmosphericpressureGatehaHinge.Figure 1: Schematic for task 1. (Giancoli et al.)a. Describe the forces acting on the gate and the center of pressure.b. Determine the resultant force and the position of the center of pressure on the gate.

Answered: Image /qna-images/answer/74217262-f958-4348-8654-d43301901fd4.jpg

A dam is used to store water, and a circular gate which is hinged at its bottom edge is used to control the flow as shown in figure 1. A pressure of 300 kPa is applied to the water free surface. For this gate, width =1 m (in the direction of the page) , hị = 1m, and h; = 6 m. P = 300 kPa hi Water Atmospheric pressure `Gate hz Hinge. Figure 1: Schematic for task 1. (Giancoli et al.) a. Describe the forces acting on the gate and the center of pressure. b. Determine the resultant force and the position of the center of pressure on the gate.

A dam is used to store water, and a circular gate which is hinged at its bottom edge is used to control the flow as shown in figure 1. A pressure of 300 kPa is applied to the water free surface. For this gate, width =1 m (in the direction of the page) , hị = 1m, and h; = 6 m. P = 300 kPa hi Water Atmospheric pressure `Gate hz Hinge. Figure 1: Schematic for task 1. (Giancoli et al.) a. Describe the forces acting on the gate and the center of pressure. b. Determine the resultant force and the position of the center of pressure on the gate.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The face of a dam is a vertical rectangle of height 100 ft and width 200 ft (Figure 6.8.5a). Find the total fluid force exerted on the face when the water surface is level with the top of the dam.
The water level in a tank is 66 ft above the ground.A hose is connected to the bottom of the tank at the groundlevel and the nozzle at the end of the hose is pointed straightup. The tank cover is airtight, but the pressure over the watersurface is unknown. Determine the minimum tank air pressure (gage) that will cause a water stream from the nozzle torise 90 ft from the ground.
15- What will be the diameter (in mm) of a water droplet, the pressure inside which is 0.00221 N/cm2 greater than the outside pressure? (Take surface tension as 0.075 N/m)
1. If the pressure 4 m below the free surface is 150 kPa, calculate its specific weight and specific gravity. fluid mechanics
The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as shown, making an angle of 45° with the ground from both sides. Each side is 0.75 m wide, and the two parts are held together by a cable and turnbuckle placed every 6 m along the length of the trough. Calculate the tension in each cable when the trough is filled to the rim.
THERMOFLUID A 3-m-wide, 8-m-high rectangular gate is located at the end of a rectangular passage that is connected to a large open tank filled with water as shown in Figure 2. The gate is hinged at its bottom and held closed by a horizontal force, FH, located at the center of the gate. The maximum value for FH is 3,500 kN. a) Determine the maximum water depth, h, above the center of the gate that can exist without the gate opening b) If the gate is hinged at the top, what is the value of h? Explain your answer.
A very large cyndrical shaped tank has a radius of 4 feet and a height of 15 feet. The tank is filled with chocolate milkshake to a depth of 11 feet. The weight density of the milkshake is 48 pounds per cubic foot. Find the work required to pump the milkshake to the top of the tank.
The two sides of a V-shaped water trough are hinged to each other at the bottom where they meet, as shown in Fig. 5, making an angle of 45° with the ground from both sides. Each side is 0.75 m wide, and the two parts are held together by a cable and turnbuckle placed every 6 m along the length of the trough. Calculate the tension in each cable when the trough is filled to the rim
In order to measure the pressure difference between two points in a pipeline carrying water, an inverted U tube is connected to the points, and air under atmospheric pressure is entrapped in the upper portion of the U-tube. If the manometer deflection is 0.8 m and the downstream tapping is 0.5 m below the upstream point, find the pressure difference between the two points
A hemispherical tank of 4 m radius is full of water/ It is fitted with a 60 mm diameter sharp-edged orifice at the bottom. Calculate the time required to lower the level in the cistern by 2 m. Take Cd= 0.6
A glass capillary tube is 0.2 mm in diameter. The surface tension is 0.0735 N/m. The pressure in the capillary water just under the meniscus will be ________ kN/m ^2.
In the figure shown, stop B will break in the force on it reaches 40 kN. Find the critical water depth (h-bar) the length of the gate perpendicular to the sketch is 1.5m. Ans (5.77m)