A “dead” 12-Volt lead/acid storage battery has 5.20 g of PbSO4 (molar mass = 303.3 g), deposited on its electrodes. To recharge it, a “trickle charger” is attached to the Pb anode that supplies 0.180 amperes of current at a voltage of 13.0 V. Calculate how much time it would take to convert all the PbSO4 back into SO42− ions in solution. Enter your answer in hours.

Q: Using a library or the Internet, research a fuel cell that usesmethanol for fuel. What is the…

A:

Q: Chromium can be electroplated from aqueous potassium dichromate, with the reduction shown below. If…

A: Given data Current (i) = 6 A Voltage (v) = 4.5 V Volume of K2Cr2O7 = 215 mL Concentration of K2Cr2O7…

Q: An electrical engineer is analyzing an electroplating run and wants to calculate the charge that has…

A: Voltage of the cell = 0.25 V Energy expended during electroplating run = 10.3 kWh = 10.3 ×103 watt h…

Q: What current is required to oxidize water at an electrode to liberate 1.00 mol O2/day in the…

A: Faraday first law: Mass of  substance deposited on any electrode is directly proportional to the…

Q: Assume the specifications of a Ni-Cd voltaic cell include delivery of 0.46 A of current for 1.00 h.…

A: Oxidation takes place at anode.  So, metal will be eroded from anode.  Thus, minimum mass of anode…

Q: 1. Fischl, a scientist from Mondstadt specializing in electrochemistry, performed an electrolytic…

A: Since you have asked multiple questions we will solve the first one for you. If you want the answer…

Q: A metallurgist wants to gold-plate a thin sheet with the following dimensions: 1.5in x 8.5in x…

A: first we have to find the volume,volume=length ×width×heightthen we know,density=massvolumeby…

Q: Consider the galvanic cell constructed with the following materials Zn electrode Zn(NO3)2(aq), Fe…

A: An electrochemical cell that converts the energy of spontaneous redox chemical reactions to…

Q: Assume the specifications of a Ni-Cd voltaic cell include delivery of 0.32 A of current for 1.00 h.…

A: Answer: According to the current value and time duration, charge required is…

Q: Two identical spoons were electroplated with Ag or Cd through the use of the electrolytic cells…

A: Amount of metal deposit on spoons depends on the amount of current passed.

Q: Which of the following expressions is correct for the maximum mass of copper, in grams, that could…

A: Given values -> Time = 16hour = 16 × 60×60 seconds                             =16×3600 seconds…

Q: 2. Consider a concentration cell which used the following half-reaction at 273 K. Co2*(aq) + 2e- →…

A: According to bartleby answering guidelines I can provide solutions of 1st three subparts of question…

Q: The following photos supplement what is included in the video on Courseworks. IMC Equipment for the…

A: Given data,  For Copper - Copper concentration cell   CuSO4(aq) = 0.001 M  CuSO4 (aq) = 1 M  The…

Q: Fischl, a scientist from Mondstadt specializing in electrochemistry, performed an electrolytic cell…

A: Given Amount of metal deposited = 15.73 g Current = 1.5 A Time = 5 hours n = 2

Q: Copper can be electroplated at the cathode of an electrolysis cell by the half-reaction.…

A: In this question, we want to determine the time in second would it take for 320mg of copper metal…

Q: A lead storage battery delivers a current of 6 A for one hour and 22 minutes at a voltage of 12 V.…

A: The electrical energy which is generated in the lead storage battery will be equivalent to the…

Q: How long(in hours) would be required for the electroplating of 78g of platinum from a solution of…

A: Mass of platinum required for electroplating = 78 g  Molar mass of platinum = 195.08 g/mol  Number…

Q: If you started at standard conditions with a battery of Cu*/Cu° and Ag*/Ag®, calculate what the…

A: In an electrochemical cell, reduction takes place at the cathode and oxidation takes place at the…

Q: Write the balanced reaction occurring in the voltaic cell. Compute the standard cell potential,…

A: Given :  Concentration of Ni(NO3)2 = 0.25 M  Concentration of Pb(NO3)2 = 0.50 M  E°Ni+2/Ni = -0.25 V…

Q: Chromium can be electroplated from aqueous potassium dichromate, with the reduction shown below. If…

A: a) 215 ml  ofb1.25  potassium  means (1.25/1000)×215 = 0.26 mol of potassium dichromate.   From the…

Q: Is it efficient and practical to operate a battery under these conditions of concentration (10 M…

A: Cell potential of a cell can be calculated as : E∘cell = E∘red - E∘oxi Nernst equation can be use to…

Q: A battery can provide a current of 2.40 A at 2.60 V for 4.50 hr. How much energy (in kJ) is…

A: Answer: If I Ampere current is generated by a battery for t seconds when it is operating at V…

Q: Like any piece of apparatus, an electrolytic cell operates at less than 100% efficiency. A cell…

A: The given data contains, Time = 10 hour. Current = 5.8 A. Mass of Cu = 53.4 g.

Q: What mass of zinc is required to galvanize the top of a 3.00 m × 5.50 m sheet of iron to a thickness…

A: Given: Thickness =0.100mm=0.0001m area of the sheet=3.00m×5.50m current=2.25A Density of…

Q: A lead storage battery delivers a current of 6 A for one hour and 22 minutes at a voltage of 12 V.…

A:

Q: Given: NO3 -> NO(g) ɛ° = 0.96 V %3D Sn4+ -> Sn2+ ɛ° = 0.13 V The two half cells were coupled to…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: The galvanic cell consisting of a lead electrode and a zinc electrode was set up and connected by a…

A: We have been asked to provide short hand notation for the given electrochemical cell reaction and to…

Q: A voltaic cell consists of a Pb/Pb2+ half-cell and a Cu/Cu2+ half-cell at 25 ∘C. The initial…

A: a)Reaction at cathode:Cu2+ + 2e- --> Cu(s)     Eocathode = 0.34 VReaction at anode:Pb (s) -->…

Q: 20. Due to COVID-19 coupled with erratic power supply from ZESCO, you decide to play around with…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A spoon of surface area 20.0 cm2 needs to be electroplated with silver to a thickness of 100 μm. How…

A: Given Area = 20 cm2 Density = 10.5 g/cm3 Current = 9.5 A Thickness = 100um = 0.01cm

Q: Purification of copper can be achieved by electrorefining copper from an impure copper anode onto a…

A: Given that :  Mass of copper deposited = 18.5kg = 18.5kg×1000g/kg = 18500g  Current(I) = 40.5A =…

Q: ) Show the equation and describes Faradays law which relates moles of analyte to charge in coulombs…

A: #(d): Faraday's first law describes the relation between the moles of the analyte deposited at the…

Q: A lead storage battery delivers a current of 6 A for one hour and 22 minutes at a voltage of 12 V.…

A: The discharging reaction if lead storage battery is given as:Pb (s) + PbO2 (s) + 2SO42- (aq) + 4H+→…

Q: An electrolytic process oxidizes nickel sulfide in a two-step reaction: • Part A NigS2(s) + Ni²taq)…

A: Current, i = 67.0 A time, t = 13.0 h = 13.0 × 60 × 60 = 46800 s (1 h = 60 min and 1 min = 60 s)…

Q: 1. Fischl, a scientist from Mondstadt specializing in electrochemistry, performed an electrolytic…

A: Given: The mass of metal deposited = 9.701 g. The current passed, (i) = 1.500 A. The time of passage…

Q: Question attached

A: Given that: ECell=0.64 VEoPb2+/Pbs=−0.1263 VPb2+=0.010 MVO2+=0.10 MV3+=1.0×10−5 M Cathode:…

Q: Purification of chromium can be achieved by electrorefining chromium from an impure chromium anode…

A: The reaction taking place can be written as  Cr3+ (aq) + 3 e- -------> Cr (s)  Given : current =…

Q: Gold is frequently purified by electroplating. Typically the gold is dissolved in a cyanide solution…

A: According to the laws of electrolysis, the weight that is deposited on the electrodes during the…

Q: The overall reaction and standard cell potential at 25 degrees celsius for the rechargeable Ni-Cd…

A: Given reaction is :  Cd (s) + NiO2 (s) + 2H2O (l) ----> Ni(OH)2 (s) + Cd(OH)2 (s) , E0 = 1.1 V…

Q: Cell 1 Cell 2 Two identical spoons were electroplated with Ag or Cd through the use of the…

A: given - electroplating diagram for Ag and Cd

Q: If in using a lead-acid battery to start a car, 1.00 gram of Pb (207.2 g/mol) is consumed on the…

A: Given:  m = 1 g of Pb MW = 207.2 mol = 1207.2= 0.004826 mol of Pb I = 0.5 C/s

Q: A battery can provide a current of 3.80 A at 3.60 V for 8.00 hr. How much energy (in kJ) is…

A: Given that a current of 3.80 A was provided by battery at 3.60 V. The power can be calculated as…

Q: (a) In the electrolysis of aqueous Naz2C204, how many liters of H2(9) (at STP) are generated by a…

A: The balanced chemical reaction can be written as follows: Na2C2O4 (aq) +  2H2O (l)  →  2CO2 (g) + H2…

Q: Given the balanced electrochemical reaction below (M and N represent generic metals), what is the…

A: Nernst equation is used to find the Ecell under non standard conditions.…

Q: A galvanic cell is constructed with one compartment that contains a mercury electrode immersed in a…

A: Here we have to determine the standard electrode potential of mercury electrode from the following…

Q: 8) Consider the galvanic cell constructed with the following materials Zn electro Zn(NO3)2(aq), Fe…

A:

Q: 2. A spoon of surface area 20.0 cm² needs to be electroplated with silver to a thickness of 100 µm.…

A: The question has asked to calculate the time for which current will flow to deposit the required…

Q: Start with a battery of Au+1/ Au0 and Li+1/ Li0 at standard conditions. If you wanted to lose 2.1…

A:

Electrolysis

Electrolysis is defined as the process of breaking down ionic compounds into their constituent elements by passing a direct electric current through the compound in a fluid state. The cathode reduces cations, while the anode oxidizes anions. An electrolyte, electrodes, and some form of external power source are the main components required for conducting electrolysis. A partition, such as an ion-exchange membrane or a salt bridge, may also be used, but this is optional. These are primarily used to prevent the products from diffusing near the opposing electrode.