A sample of 14000 ppm iron is Strong Acid has to be diluted between 95 and 180  ppm.  The method chosen was to dilute in three dilutions of 100 mL each.  The first dilution is a 1/5, the second dilution is a 1/6 and the third dilution is a 1/3.  Determine how much of each component goes in each tube.  Determine the concentration of each tube.  Are we within the proper range?

Q: The fat content of 10 g of commercial ice cream was determined by the Mojonnier method. The weights…

A: To calculate percent weight extracted in third extraction using the weight of fat given after second…

Q: How many grams of CaC2O4 would be required to make a saturated aqueous solution in a 1 Liter flask…

A: solubility is defined as the maximum amount of solute that can be dissolve in a solvent or we can…

Q: How much THE REQUIRED AMOUNT OF 500mg ASCORBIC ACID TABLETS should i need to pulverize? and; How…

A: Concentration of stock solution of ascorbic acid = 0.02 M…

Q: 1. Which method can be used to remove temporary hardness but not permanent hardness from a sample of…

A: (1) Given methods are -  A. Washing sodaB. Ion-ExchangeC. Boiling    (A). Washing soda method -  In…

Q: What is the Normality of 250ml of 2.417M AL(OH), diluted to 500ml? 14.50N 3.63N 1.21N 4.83N

A: Given,  Volume of Al(OH)3 in mL = 250 mL  Molarity of Al(OH)3 = 2.417 M  Al(OH)3 diluted to volume =…

Q: You have a 5.0 ml sample of a protein in 0.5M NaCl. You place the protein/salt sample inside…

A:

Q: Consider a solution made by massing 8.3 g of a nonvolatile solute (molar mass = 68.51 g/mol) and…

A: This question is related to the basics of solution and the different ways of expressing the…

Q: • Normal boiling point of carbon tetrachloride is 76.8 °C a. Calculate the boiling point of a…

A:

Q: 3.. How many milliliters of 0.15 M Aluminum Carbonate are required to make a 650 mg sample of a 500…

A: Given: Specific gravity of solution = 1.28  The concentration of aluminium carbonate i.e. Al2(CO3)3…

Q: A sample is analyzed for Pb. Is the ppm in a dry sample greater than,

A:

Q: Copper metal and aqueous iron (III) chloride were made to react to reduce iron to Fe2+ while…

A: Here we are required to find the mass of copper needed to react with 20.5% wt of iron (III) chloride…

Q: The distribution coefficient of hydrogen sulfide between benzene and water at 25 degrees Celsius is…

A:

Q: 10. How to prepare 40 ml of 25 ppm potassium solution from 0.01 M KNO3 solution? KNO3 : 100 g/mol,…

A:

Q: 10.00 mL of 1.10 M  HCl  diluted to 0.450 L

A:

Q: Calculate the amount of temporary and permanent hardness of a water sample in units of Degree…

A: We have to find the temporary and permanent hardness of a water sample in units of Degree Clarke’s,…

Q: 1. If 0.250 L of aqueous solution with a density of 1.00 g/ml contains 13.7 µg of pesticide, express…

A: Given: The volume of the solution = 0.250 L The density of the solution = 1.00 g/mL The mass of…

Q: What volume of Water for Injection, BP is to be added to a vial containing 500 mg amoxicillin to…

A: Given that : The mass of vial containing amoxicillin = 500 mg The volume of final solution = 10 mL…

Q: The salt content was extracted from a 12.0000 g junk food sample. The extract was diluted to 100.00…

A:

Q: A 5 gram (NH4)2SO4 (MW = 132.14 g/mol) was dissolved to make 500mL solution. It found to have a…

A:

Q: 325 mL of 0.25% (w/v) KCl  solution I would weigh out _____  g KCl and add water to dissolve, then…

A: SOLUTION: Step 1: (w/v) % of the KCl solution is 0.25%. The total volume of the solution is 325 mL.…

Q: 170 milliliters are required to prepare 900 mL of 2.00 M HCI (36.5g/mol) from the commercial reagent…

A: Concentration of commercial HCl = 37.2 % (w/w)

Q: Prepare 0.1N H2SO4 solution of 250ml volume. (Density of H2SO4 is 1.84 and purity is 98 %)

A: We are givenH2SO4 purity=98% i.e in 100 gm of solution H2SO4 present =98 gm

Q: If 400 mL of a 18% v/v solution of methyl salicylate in alcohol is diluted to 1500 mL, the…

A:

Q: prepare calcium sulfate soultion by dissolving 200 g calcium sulfate in enough water to sa volume of…

A: From given data  Mass of solute, calcium sulfate = 200 g = 0.200 Kg volume of solution = 850 mL…

Q: To determine the freezing point depression of a LICI solution, Toni adds 0.378 g of LiCI to the…

A: ∆Tf = i × Kf × m Where ; ∆Tf = depression in freezing point  i = van't Hoff factor  ( For LiCl , i =…

Q: o determine the amount of copper and the identity of the copper compound in the unknown sample, a…

A: Given :-  Stock volume of copper containing sample = 100 mL  Mass of copper containing sample in…

Q: Materials Needed semi-micro test tubes and rack solid I2 regular test tubes and rack squash pipettes…

A: The rule odf solubility is 'like dissolves like' whuch means that polar solute will be dissolved in…

Q: determine how to prepare 100ml of a 0.250m sodium chloride solution using sodium chloride power

A: Answer:Given:100 ml of 0.250 m sodium chloride solution.Preparation of given NaCl solution:Consider,…

Q: You have available a stock solution of 1.500M CuSO4. You need to prepare 500.0mL of 0.3000M CuSO4…

A: The solution is given below -

Q: c. Quantitatively transferring dissolved solids from a beaker by pouring washings into the final…

A:

Q: Dilutions From a 2.0 M Stock Solution 39 SEP Interpret Data The table shows the volume (Vstock) of a…

A: M1 = 2.0 M V1  =  ?  M2 = 0.5 M      ( mol/L  = M ) V2 =  1 L    M1 × V1  = M2 × V2 2.0 M × V1  =…

Q: How many milliliters if a 1:20 v/v solution of methyl salicylate in alcohol can be made from 100 mL…

A: The formula used here is  V1 × C1 = V2 × C2 where V is the volume of the solution and C is the %…

Q: In the following set-up, particles will move both ways across the membrane, but more so to the Pure…

A: The solution is given below -

Q: A solution was prepared by dissolving 35.0 mL of methanol in sufficient water to give a total volume…

A: We have to predict the percentage by volume of given solution.

Q: 18. How much ml of ethanol is needed to make 2000ml of an aqueous 15% (v/v) solution? A. 3000 mL B.…

A:

Q: Calculate the number of moles of: sodium hydroxide in 100 cm³ of 0.1 mol dm³ sodium hydroxide…

A: The number of moles = Molarity×volume×10-3

Q: Calculate the number of mL of a 500ppm solution needed to prepare 100mL of a 50 ppm solution.

A: Given:Concentration (C1) = 500 ppm.Volume (V2) = 100 mL.Concentration (C2) = 50 ppm.

Q: How many grams of digoxin are needed to make 1500mL of a 0.5g in 200mL solution of digoxin? Give…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 20.5mL of methanol, CH40 (MM = 32.042), is mixed with 88.5mL of water (MM = 18.015) at 25°C. The…

A: Mass percentage The mass percentage of solution is fraction of mass of the solute to the mass of the…

Q: If I take 13.23 grams of tri-sodium phosphate and dissolve it in 500mL, then subsequently tåke 50 ml…

A: One mole of tri-sodium phosphate contains three moles of sodium ions. Steps to be followed (i)…

Q: A 60.0 L tank of chlorine gas at 27 °C and 125 atm springs a leak in a 50-m3 well-ventilated storage…

A:

Q: What will be the new boilng point of 491ml  benzene (Kb = 2.53 oC•Kg/mol; Bp = 80.1oC) when mixed…

A:

Q: o NB3: What is the dilution factor of the 50 mM stock solution relative to the 1 mM solution?…

A: The dilution factor can be determined by the ratio between initial concentration to the final…

Q: A solution is made using 162.1 g of dimethyl ether (MM = 46.07 g/mol) and 90.0 g of methanol (MM =…

A: Mole fraction of any component can be obtained by dividing the moles of that component with the…

Q: 88. The molecular weight of NaOH is 40. How many grams of NaOH pellets are needed to make 500ml of…

A: Normality =Gram equivalent of solute / Volume of the solution (L)   No. of gram equivalents= Mass…

Q: Part 1: A solution of sulfuric acid was made by dissolving 20.0g of 98% sulfuric acid in 250mL of…

A: "Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: 250 mL of 1% m/v Na2CO3 (MW = 105.99 g/mol) was found to have a density of 1.05 g/mL at 25oC. Find…

A:

Q: Miscible, slightly miscible, immiscible SAMPLE Water Dichloromethane Cyclohexane 1M HCl…

A:

Q: What is the volume of sulfuric acid H2S04 required to prepare a dilute solution of 1000 ml with a…

A:

Q: Ab asked Mi to perform an experiment on freezing point depression. The solution was prepared by…

A: ∆Tf =Tf-Tf'=  Kf × mwhere ∆Tf = Depression in freezing point Tf and Tf' are initial and final…

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.