A solution of potassium permanganate of unknown concentration was analyzed against a standard of various concentrations. What is the concentration of KMNO4 if its absorbance is 0.678? Table 1. Data for the Standard Calibration Curve KMNO4 Standard Solution (mol/L) Absorbance at 525 nm 0.000400 0.112 l0.000800 0.295 0.000120 0.443 0.000160 0.701 0.00200 0.932 O 0.00173 M O 0.00194 M O 0.00189 O 0.00155 M

A solution of potassium permanganate of unknown concentration was analyzed against a standard of various concentrations. What is the concentration of KMNO4 if its absorbance is 0.678? Table 1. Data for the Standard Calibration Curve KMNO4 Standard Solution (mol/L) Absorbance at 525 nm 0.000400 0.112 l0.000800 0.295 0.000120 0.443 0.000160 0.701 0.00200 0.932 O 0.00173 M O 0.00194 M O 0.00189 O 0.00155 M

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter24: Introduction To Spectrochemical Methods

Section: Chapter Questions

Problem 24.16QAP

See similar textbooks

Similar questions

You are working with metal thiocyanate complex, M(SCN)+, with a molar absorptivity constant, ε, of 2700 cm−1M−1 at 500 nm. If you are is using a 1.00 cm cuvette for absorbance measurements at 500 nm, what concentration of M(SCN)+ will give an absorbance value of 0.280?
A green solution containing Ni+2 ions absorbs 580 nm light. Undiluted, a sample of this solution sampled in a 1.00 cm diameter cuvette has an absorbance of 0.9765 a.u.. If the molar absorptivity coefficient for Ni+2 is 6.3 x 104 M -1 cm -1 at 580 nm, how much of the original stock Ni+2 solution (in mL) needs to be added to water to create a total dilute solution volume of 10.00 mL that measures an absorbance of 0.146 a.u. at 580 nm? Report your answer to 3 significant figures. Do not include the "mL' unit label in your response
The measurement of Li in brine (salt water) is used by geochemists to help determine the origin of this fluid in oil fields. Flame atomic absorption of Li is subject to interference by other elements. Atomic absorption of analysis of replicate sample of Li in a brine sample gave results in the table. a. Suggest a reason for the increasing apparent concentration of Li from sample 1 to 2. b. Suggest a reason for the increasing apparent concentration of Li from sample 1 to 3 c. Why do samples 4-6 give a nearly constant result? (What type of interference you think is being eliminated?
Derive an expression relating absorbance to the concentrations of standard and unknown ( c subscript s and c subscript x) and the volumes of the standards and unknown ( V subscript s and V subscript x ) as well as the volume to which the solutions were diluted (V subscript t). Derive expressions for the slope and the intercept of the straight line obtained in (a) in terms of the variables listed above.
A stock solution of analyte is made by dissolving 34.83 mg of copper (II) acetate hexahydrate(fw = 289.73 g/mol) in 25.00 mL of water. A second stock solution of internal standard is madeby dissolving 28.43 mg of germanium (I) acetate (fw = 190.74 g/mol) into 25.00 mL of water.These solutions are used to make a series of standards for ﬂame atomic absorption analysiscalibration. The standard solutions (each 10.00 mL total volume) should have the followingconcentrations of copper: 10.00; 25.00; 50.00; 100.0; and 200.0 μM. Each calibration solutionshould also contain 50.00 μM of germanium. What is the analyte stock solution concentration? What is the internal standard stocksolution concentration?Complete this table.
A solution of Tryptophan has an absorbance at 280 nm of 0.54 in a 0.5 cm length cuvette. Given the absorbance coefficient of trp is 6.4 x 103 Lmol-1cm-1. What is the concentration of solution?
An aqueous solution of a Ni2+ complex with a concentration of 8.61 × 10–5 M was analyzed by a UV-VIS spectrometer at 470 nm and in a 1.00-cm cell; a percent transmittance value of 78.70% was recorded. What is the absorbance of the solution? * Provide your answer with three decimal places and without units. Avoid using scientific notation.
. A student collects the following data for the absorbance of a complex measured in 1.00 cmspectrophotometric cells. The molar absorptivity (ε) of the complex under investigation is 2.25×103L/mol·cm. Calculate the concentration of the complex in solution at each time of the reaction.Time (min)MeasuredAbsorbanceComplex Concentration(M)0.000 1.50010.000 1.31320.000 1.12530.000 0.93840.000 0.750
Potassium dichromate (K2Cr2O7) and potassium permanganate (KMnO4) give overlapping UV-Vis absorption spectra in 1 M sulphuric acid. K2Cr2O7 shows an absorption maximum at 440 nm and KMnO4 shows the absorption maximum at 545 nm . An unknown sample solution containing a mixture of K2Cr2O7 and KMnO4 was analyzed using a 1-cm cell and the absorbance values at these two wavelengths were as follows: A440 = 0.515 and A545 = 0.835 The absorbance values for standard solutions of K2Cr2O7 (1.00 x 10-3 M) and KMnO4 (2.00 x 10-4 M) in 1 M sulphuric acid using the same 1 cm cell were as follows: Calculate the concentrations of K2Cr2O7 and KMnO4 in the unknown sample.
Flame Atomic Absorption Spectroscopy (FAAS) method is selected due to its wide applicability for metal ion analysis in drinking water samples. Discuss how can we determine the concentration of selected heavy metals (Cu and Cr) in the unknown tap water sample.
Atomic absorption spectroscopy with graphite furnace atomization is an extremely sensitive technique. The standard addition method is used with this technique to determine the concentration of copper in urine. A 20.00 mL sample of urine is spiked with 1.00 mL of 300. ppb Cu²+ and this mixture gives a response of 0.168. Another 1.00 mL aliquot of 300. ppb Cu²+ is added to this mixture and gives a reading of 0.235Determine the concentration of copper in the urine sample
Explain why an internal standard is required during sample preparation in quantitative analysis when using atomic spectroscopy?