A student obtains the following data by following an experimental procedure to this one. Based on this data, what is the value of R (in L.atm/mol/K) that would be calculated? Report the result to four significant figures. Use 273.15 K for the temperature conversion. Pressure of dry H2 = 742.7 mm Hg Temperature 22.50 degrees C %3D Mass of Mg used = 0.04480 g olume of H2 = 44.55 ET units onversion factor 0.8966 mL/ET Unit

A student obtains the following data by following an experimental procedure to this one. Based on this data, what is the value of R (in L.atm/mol/K) that would be calculated? Report the result to four significant figures. Use 273.15 K for the temperature conversion. Pressure of dry H2 = 742.7 mm Hg Temperature 22.50 degrees C %3D Mass of Mg used = 0.04480 g olume of H2 = 44.55 ET units onversion factor 0.8966 mL/ET Unit

Chemistry: Principles and Reactions

8th Edition

ISBN:9781305079373

Author:William L. Masterton, Cecile N. Hurley

Publisher:William L. Masterton, Cecile N. Hurley

Chapter5: Gases

Section: Chapter Questions

Problem 1QAP

See similar textbooks

Similar questions

One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In a hospital, pure oxygen may be delivered at 50 psi (gaugepressure) and then mixed with N2O. What volume of oxygen at 20Cand 50 psi (gauge pressure) should be mixed with 1.7 kg of N2O toget a 50%/50% mixture by volume at 20C? (a) 0.21 m3; (b) 0.27 m3;(c) 1.9 m3; (d) 100 m3
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In another test, the valve of a 500 L cylinder full of the gas mixture at 2000 psi (gauge pressure) is opened wide so that the gas rushes out of the cylinder very rapidly. Why might some N2O condense during this process? (a) This is an isochoric process in which the pressure decreases, so the temperature also decreases. (b) Because of the rapid expansion, heat is…
What is the volume of 1.337 moles of CO2 gas at S.T. P. ? Express your answer to 2 decimal places and use the proper abbrev iation for the UNITS
Upon an experimental process, a round-bottomed glass flask (evacuated) weighs 62.0 g when its empty. In the following step, this flask was fulfilled with a liquid (d: 0.98g/mL) and weighs 160.0 g. The same flask used again in another experiment and weighs 62.5 g when fulfilled with an ideal gas (experimental conditions: 760mmHg and 300K) According to this data, calculate the molecular weight of the ideal gas.
Ethanol vapours were allowed to completely fill a jug with a volume of 18.9L. The ethanol was burned yielding 9.6mL of LIQUID water in the bottom of the jug. C2H5OH + 3 O2 ---> 2 CO2 + 3H20 If the room temperatue was 23.5 degrees Celsius and the pressure was 97.5 KpA, calculate the percentage yield of the water gathered in the jug. Select the final answer from the options below: - Not enough information - 76% - 24% - 17%
Boyle’s law for confined gases states that if the temperature is constant, pv = c, where p ispressure, v is volume, and c is a constant. At a certain instant the volume is 75 cubic inches, thepressure is 30 psi, and the pressure is decreasing at the rate of 2 psi every minute. What is therate of change of the volume at that instant?
6 Methods that employ separation of the product chemically through precipitation, with purification, drying and weighing of the resultant product: A. Spectrophotometric analysisB. Volumetric analysisC. Gravimetric analysisD. Gasometric analysis7 Phase changes involving fusion, except:a. Solid to liquidb. Liquid to solidc. Gas to liquidd. Gas to solid
To evaluate the use of renewable resources, an experiment was carried out with rice hulls. After pyrolysis, the product gas analyzed 6.4% CO2, 0.1% O2, 39% CO, 51.8% H2, 0.6% CH4, and 2.1% N2. It entered a combustion chamber at 90 °F and a pressure of 35.0 in. Hg and was burned with 40% excess air (dry) at 70 °F and an atmospheric pressure of 29.4 in. Hg; 10% of the CO remains. a. How many cubic feet of air were supplied per cubic foot of entering gas? b. How many cubic feet of product gas were produced per cubic foot of entering gas if the exit gas was at 29.4 in. Hg and 400 °F?
A vessel containing 39.6 cm3 of helium gas at 25 C was inverted and placed in cold liquid ethanol. As the gas contracted, ethanol liquid was forced into the vessel to maintain the same pressure of helium. If this required 18.8 cm3of ethanol, what was the final temperature?
(a) For liquid benzene β = 9.30 x 10-5 atm-1 at 20 °C and 1 atm pressure. Utilizing the equation derived ln(v2/v1)=α(T2-T1)-β(P2-P1) and assuming β to be independent of pressure, find the percentage change in volume of a sample of benzene on being compressed at constant temperature from a pressure of 1 atm to a pressure of 11 atm. (b) What would be the percentage change in volume of an ideal gas compressed over the same pressure interval at constant temperature?
In normal conditions (1 atm, 300K), 2 m3 of liquid water weighs: a. 2 kg b. 20 kg c. 200 kg d. 2000 kg
For an ideal gas P= nRT/V, and for a gas whose molecules have volume P=nRT/(V-nb) How would you modify this latter equation for a real gas to correct for the fact that there are attractive forces between molecules.