A1 m long and 35 mm diameter aluminum shaft is to be replaced by a steel hollow shaft of the same length and the same outside diameter. It is required to design the steel shaft to withstand double the shear stress that of aluminum shaft. Determine the inside diameter of the stee shaft. Find the values of the shear stresses on each shaft if a torque of 3 kN.m is applied to both of them.

A1 m long and 35 mm diameter aluminum shaft is to be replaced by a steel hollow shaft of the same length and the same outside diameter. It is required to design the steel shaft to withstand double the shear stress that of aluminum shaft. Determine the inside diameter of the stee shaft. Find the values of the shear stresses on each shaft if a torque of 3 kN.m is applied to both of them.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A solid shaft 50 mm in diameter is subject to the torques applied in thegears. Determine the maximum shear stress on the shaft.
The drive shaft AB of an automobile is made of a steel having allowable shear stress of tallow = 8 ksi. If the outer diameter of the shaft is 2.5 in. and the engine delivers 200 hp to the shaft when it is turning at 1140 rev>min, determine the minimum required thickness of the shaft’s wall.
A solid steel shaft is to be used to transmit 5 hp from the motorto which is attached. If the shaft rotates at 175 rpm and thesteel has an allowable shear stress of 14.5 ksi, determine therequired diameter of the shaft to the nearest 1/8 in.
The shaft is supported on bearings that do not resist axial load. If the allowable shear stress for the shaft is Tadm = 40 MPa, determine, to the nearest 1mm, the smallest diameter that will support the load.
A circular solid shaft has a diameter of 60 mm and is subjected to a torque load of 8.7 kN•m. Determine the resulting torque maximum and minimum shear stress.
Motor A develops a power of 300 W and drives a pulley at 90 rpm. Determine the required diameters of the steel shafts that drive the pulleys A and B if the allowable shear stress is τ perm = 85 Mpa.
The 12 kN.m torque is applied to the free end of the 5-m steel shaft. The angle of rotation of the shaft is to be limited to 3o. (a)Find the diameter d of the smallest shaft that can be used. (b) What will be the maximum shear stress in the shaft? Use G = 83 GPa for steel.
The 6-hp reducer motor can turn at 1200 rev>min. If the allowable shear stress for the shaft is tallow = 6 ksi, determine the smallest diameter of the shaft to the nearest 1 16 in. that can be used.
A line shaft rotating at 320 rpm is to transmit 35 kW power. The allowable shear stress for the shaft material is 56 N/mm2. Determine the diameter of the shaft?
The hollow circular shaft is subjected to the torque of 4 kN # m. Determine the principal stresses at a point on the surface of the shaft.
S2) The allowable shear stress limit value of the steel from which the stepped shaft is manufactured is 8MPA talow. If the rounding radius at cross-sectional transitions is r2.25 mm, determine the maximum torque T that can be applied.
a hollow shaft for a rotary compressor is to be designed to transmit maximum torque of 4750 n-m. the shear stress in the shaft is limited to 50 mpa. determine the inside outside diameter of the shaft if the ratio of inside to outside diameter of the shaft is 0.4