An over head transmission line supported from two towers location at the same level. The distance between the towers is 200 m. The tension in the wires is 900O N. The weight of one meter of the conductor is 10 N. The sag of the wires is *

An over head transmission line supported from two towers location at the same level. The distance between the towers is 200 m. The tension in the wires is 900O N. The weight of one meter of the conductor is 10 N. The sag of the wires is *

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2MCQ: Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False

See similar textbooks

Related questions

Q: If Voltage regulation of Transmission line increases Efficiency will decreases Select one: True…

A: Choose the correct option If the voltage regulation of transmission line increase, efficiency will…

Q: Define power system. Write down the characteristics of transmission line

A: An electric power system is a network of electrical components used to supply, transfer, and…

Q: The diameter of the overhead lines in the form of cylindrical conductors in a 300 kV three-phase…

A: Given diameter = 20mm, Vline = 300kV. Your b subpart is not clear I assume you have asked for…

Q: In a three phase 500 kV transmission line, diameter of the conductors are 48 mm. The breakdown…

Q: An over head transmission line has a cross area of conductor of 4 cm and supported from two towers.…

A: Given: For an overhead line supported at the same level, weight per meter length of conductor w=6 N,…

Q: The towers of height 45 m and 85 m respectively support a transmission line conductor at water…

Q: A=4 (SQUARE CM) Homer work. An over head transmission line has a cross area of conductor of 4 cm and…

A: An over head transmission line, Cross area of conductor a=4 cm2 Distance between the towers l=200m…

Q: Q4: Each conductor of a 3-phase high-voltage transmission line is suspended by a string of 4…

A: Given data, V2=13.2 KV, V3=18 KVXc= 1Ω

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: As given in the question transmission line (L) = 150 Height from the bottom is = 10 meter…

Q: A 132 kV transmission line has the following data: Length of span = 260 m, weight of…

A: According to the question we have to find the value of the height above ground at which the…

Q: 32. An overhead transmission line at a river crossing is supported from two towers at heights 25m…

Q: pomy I. An overhead transmission line at a river crossing is supported from two towers at heights of…

A: Transmission Line: In electrical engineering, a transmission line is a specialized wire or other…

Q: What is the maximum length in km for 3 phase transmission line having conductor of 0.875 square…

Q: 400MVA power is transmitted with 380kV voltage and 18.1948 degree power angle with the help of a 500…

Q: 1. A transmission line conductor is supported from two towers at heights of 70 m above water level.…

A: Given, Height of the two towers =70m Distance(l) =300m Tension(T) =1500kg Size of conductor(A)…

Q: What is the necessary condition for matching transmission lines? In addition, what is a microstrip…

A: The necessary condition for matching transmission lines is Impedance Matching. The transmission line…

Q: In the measurement of level in a tank, height of the tank is about 1666 cm, then the span is given…

A: We need to determine the span if tank height is 1666 cm.

Q: The weight of a transmission line conductor is 1.5 kg per meter. The span of the line is 200 meters.…

Q: The appropriate locality for the power factor improvement device is a. At the sending end. b. Near…

A: The appropriate locality for the power factor improvement device is near the electrical appliance…

Q: 04. A Transmission Line has a span of 250 meters between two level supports. The conductor has a…

A: The given data's are, Life span is 250 m, Cross sectional area is 1.29 cm2, Weight is W=1170…

Q: An overhead transmission line is supported at a river crossing by two towers of height 34 m. The…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: What are the factors which governs the performance of transmission line?

A: There are totally 4 parameters which includes Resistance, Inductance, Capacitance and Shunt…

Q: If a transmission line has to be designed with an ultimate strength 8000 kg and a safety factor of…

A: Given, l=275 m T=8000 kg w=2 kgmwi=0.7 kgmww=0.95 kgm where, l is the length of span, w is the…

Q: The span between two level supports for a 132 KV overhead transmission line is 200 The weight of…

A: According to question: Total weight of 1m length of conductor is calculated as…

Q: 8/The Efficiency of a Transmission Line should be _____? A. as high as possible. B. as low as…

A: In a power system the electrical power is being transmitted through hundreds of kilometers. The…

Q: What is the maximum length in km for 3 phase transmission line having conductor of 0.875 square…

Q: An Overhead transmission line has a span of 115 m. Ultimate strength is 3600 Kg and factor of safety…

Q: 4.3 A transmission-line cable with a length of 2 km consists of 19 strands of identical copper…

A: To determine the resistance of conductor

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-875…

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-775…

A: We have been asked to find the maximum length in km for 1-phase transmission line having, Copper…

Q: A transmission line conductor has a weight of 1.2 kg/m and the span of the line is 200 m. The…

A: Solution: weight of conductor Wc=1.2 kg/m, span of line L=200m, maximum tensile strength=8000 kg…

Q: With at least five points , compare overhead to underground transmission lines.

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: 6. What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-875…

A: Single phase transmission line. Copper conductor cross sectional area A= 0.875cm2 = 0.875× 10-4 m2…

Q: 3.a. An equipotential bonding grid at a farm location is to be connected to the ground terminal bus…

A: Ans. 3(a) Equipotential Bonding Grid is a Conductive Pool Shell. An equipotential bonding grid at a…

Q: 05/ A transmission line over a hillside where the angle is (0 = 2.2924°), is supported by two 22 m…

Q: What is the maximum length in km for 1 phase transmission line having conductor of 0.875 square…

Q: A transmission line has a span of 250 m between supports, the supports being at the same level. The…

A: It is given that: Length of span=l=250 mUltimate strength=4220 kg/cm2Area=A=1.29 cm2Factor of…

Q: 014: Fill in the blanks with suitable answers: 1. One of the advantages of an interconnected power…

A: 1). One of the main advantage of interconnected power system is power shared incase of exceeding the…

Q: 1. A transmission line has a conductor weight of 1200 kg/km and stress of 1110 kg. The sag was 9m.…

A: Please refer the attached images for the complete answer..

Q: The weight of the conductor in the transmission line is 1.5 kg/m. The span of the line is 100 m. The…

Q: Q1/ What is the cause of low and high voltages in electrical transmission lines from the receiving…

A: Given: Low and high voltage in electrical transmission lines

Q: A transmission-line cable consists of 12 identical strands of aluminum, each 3 mm in diameter. The…

A: Given: No. of strands= 12, Resistivity of aluminum strand= 2.8×10-8 Ωm.

Q: The towers of height 45 m and 80 m respectively support a transmission line conductor at water…

Q: In a 380 kV three-phase transmission system, the diameter of the overhead lines in the form of…

A: Part (a): The line voltage is given as 380 kV. The disruptive critical voltage is determined as:…

Q: write the factor governing height of pole

Q: The towers of height 45 m and 80 m respectively support a transmission line conductor at water…

Q: A transmission line has a span of 150m between level supports of 10 meter height. The ground…

A: Consider the diagram shown in Figure below

Q: Estimate the distance over which a load of 15000 kW at 0·85 p.f. can be delivered by a 3-phase…

Q: A transmission line has a span of 150m between level supports of 18 meter height. The ground…

Q: What is the maximum length in km for a 1-phase transmission line having copper conductor of 0-875…

A: Single phase transmission line, Cross section area a=0.875 cm2 P=220 kW V=3500 V cos ϕ=1Efficiency…

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

An over head transmission line
supported from two towers
location at the same level. The
distance between the towers
is 200 m. The tension in the
wires is 9000 N. The weight of
one meter of the conductor is
10 N. The sag of the wires is *

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Given;

VIEW

Step 2 solution;

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What are the colors of the conductors in nonmetallic-sheathed cable for a. 2-wire cable? _______________, _______________ b. 3-wire cable? _______________, _______________, _______________
Calculate the inductive reactance in /km of a bundled 500-kV, 60-Hz, three-phase completely transposed overhead line having three ACSR 1 113 kcmil conductors per bundle, with 0.5 m between conductors in the bundle. The horizontal phase spacings between bundle centers are 10, 10, and 20 m.
Overhead transmission-line conductors are bare with no insulating cover. (a) True (b) False
Using the above example, determine the wire size needed for the 400-ampere service in accordance with the National electrical Code. Assume that the conductors have type THWH insulation. (Note: As a general rule, for each 100 feet of conductor length the wire size is increased one standard size because of voltage drop.)
A transmission-line cable with a length of 2 km consists of 19 strands of identical copper conductors, each 1.5 mm in diameter. Because of the twist of the strands, the actual length of each conductor is increased by 5. Determine the resistance of the cable if the resistivity of copper is 1.72-cm at 20C.
On the 1km long dc distributor above the applied voltage at point O is 200V. Lengths ??? = 100?,??? = 600? and the impedance for the conductor material per 10000m is ?? = 5 < 53.130Ω. Calculate:a. The potential at point C b. Current along section OC of the distributor
How many 14 AWG THHN conductors, including an equipment grounding conductor, can be installed in a 3/8-in. flexible metal conduit using inside fittings? Select one: A. 2 B. 6 C. 4 D. 8
5. Identify the minimum distance requirements between network cables and power sources and identify types and location for cable supports.
1. The engineering calculations for an 800-ampere service-entrance call for two 500 kcmilcopper conductors per phase connected in parallel. The neutral conductor calculations show that the neutral conductors need only be 3 AWG copper conductors. Theriser diagram shows two rigid metal conduits, each containing three 500 kcmil phaseconductors and one 1/0 AWG neutral conductor. Why is the neutral conductor sized asa 1/0 AWG, or is this a mistake?
n an ungrounded electrical systems with conductors installed in grounded metal raceways and enclosures, what is the voltage from the current carrying conductors to the metal raceways and WHY?
1. What are the applications for stripline and microstrip transmission lines? 2. Give 2 examples of characteristic impedance application for each stripline and microstrip transmission lines.
Please Explanation with Hand Written proper calculation with Draw. Other wise leave the Question. A overhead transmission line comprising of two parallel conductors having 1.5 cm of diameter of each. Conductor spacing is 1m. Calculate the or inductive reactance of line at 50 Hz frequency.