(c) Write short notes on what type of preparation is needed for a specimen in order to allow it to be studied under a standard (non-environmental) scanning electron microscope. In your answer you should make reference to electrical conductivity, metallic and non-metallic samples, pressure in the chamber, mounting of samples and fluids in the specimen.

(c) Write short notes on what type of preparation is needed for a specimen in order to allow it to be studied under a standard (non-environmental) scanning electron microscope. In your answer you should make reference to electrical conductivity, metallic and non-metallic samples, pressure in the chamber, mounting of samples and fluids in the specimen.

Comprehensive Medical Assisting: Administrative and Clinical Competencies (MindTap Course List)

6th Edition

ISBN:9781305964792

Author:Wilburta Q. Lindh, Carol D. Tamparo, Barbara M. Dahl, Julie Morris, Cindy Correa

Publisher:Wilburta Q. Lindh, Carol D. Tamparo, Barbara M. Dahl, Julie Morris, Cindy Correa

Chapter39: Phlebotomy

Section: Chapter Questions

Problem 5CR

See similar textbooks

Similar questions

A radiograph was produced using 80 kVp, 800 mA, .75 seconds and a 72 inches SID. In order to maintain the same density, how much time should be used with the following factors: 92 kVp, 200 mA, and 36 inches SID?
If you observe a specimen under this 20X objective and the specimen spans one-quarter of the field of view distance, how long is the specimen in micrometers?
Which of the following specimens cannot be tested on the Velocity Macroscopic Chemistry Module? a. Gross Hematuria b. Specimens <2 mL c. Pyridium d. Diluted Specimens e. All of the above
What are the differences between scanner, low power objective, high power objective and oil immersion objective? Introduce the terms stated above and explain comprehensively.
In sterilization, which among the supplies, instruments, glassware, etc. under the list of materials can be sterilized using either or both equipment below? List them down under the category: a) For “autoclaving” only, B) For Dry heat oven sterilization ,And C) Can be sterilized with either. Materials: 200-ml Erlenmeyer flask Stove 500-ml Erlenmeyer flask Autoclave 10-mL graduated cylinder Analytical balance 100-ml graduated cylinder pH meter Spatula Stirring rod 100-mL beaker Test tubes Distilled water Petri dish Stirring rod Alcohol lamp Glass dropper
If a researcher forgot to wipe the outside a sample cuvette to make it free of drops, fingerprints, and dust prior to reading it in the spectrophotometer, how might the absorbance value of the sample be affected? (Higher, Lower, No Change) Explain
What are the processes of concentrate samples analysis in Uv-visible spectroscopy? Please shortly answer at your own words(3-4 lines).
how often do we have to clean and caliberate a spirometer based on national and international guidelines
Which spectrophotometer mode should you use to calibrate the instrument and which mode should you use to read your samples? Transmittance for both Absorbance for both Absorbance to calibrate and transmittance to read samples Transmittance to calibrate and absorbance to read samples Flip a coin to pick a mode each time.
If, when using 10X ocular and a 20X objective, the field size is 2 mm. The approximate field size with a 50X objective is ________ mm. 0.6 0.8 0.4 1
Why should you use and handle laboratory instruments and equipment according to specified usage?
What are the mechanisms of samples separation work in Thin layer Chromatography? Please shortly write at your own words. Answer should be to the point (5-6 lines maximum).