First question: Distributor (AB) fed from one end Find the distribution of currents and voltages on the distributor and find the lowest voltage point if the resistance is 7.5 * 10^-3 m/ for each conductor 400V 50m A 70m E 40m D B 60m 20A 40A 60A 15A

Q: Q2- 100 KVA, (6600/330) ,single-phase transformer, the primary connected to supply voltage 100 V and…

A: Transformer is a static device which is used to step up or down the voltage level or current level…

Q: 4. A receiver has 2 uncoupled tuned circuit before the mixer, each with a Q of 75. The signal…

A: For the above given question we need to calculate the value of image rejection ratio by considering…

Q: Q. Determine the output of the DAC in figure (a) if the sequence of 4-bit numbers in part (b) is…

A:

Q: A particle start its motion from rest under the action of constant force. if the distance covered in…

A: Given data , t1 = 10 seconds  S1 = distance covered in t1 seconds t2 = 20 seconds  S2 = distance…

Q: Determine the state-transition matrix

A:

Q: Calculate current 122 ha Timo R Viza =C ext) = 100√2 sin (wt + 80) 12 2₁-50 Ze = -50. Z₂ 60 R = 80…

A: Given: Consider the following circuit: To find: The current IL2.

Q: 04/ For the network in Fig.4 1. Write the equations necessary to solve for the branch currents. 2.…

A: Mesh analysis is the method to finding a current in a circuit. This method used in network theory.…

Q: A single phase transmission line of length of 1.5km (between the source and the load) supplies an…

A: Given parameters load end (receiving end) voltage,  VR=220 V Resistance of line =0.01 ohm/km…

Q: A copper coil, when connected to a 30-volt supply, initially takes a current of 3 A and has a mean…

A: From the question, it is given thatVS=30 VI1=3AI2=2.85 AT1=20°CT2=33.4°CWe have to determine the…

Q: Define and explain the following terms. 1. Schematic Diagram 2. Block Diagram 3. Pictorial Diagram…

A: In these questions there are different types of diagrams that are used in different fields is…

Q: 13.218 An air-filled rectangular waveguide is to be constructed for single-mode operation at 15 GHz.…

A: We need to find out a and b for given condition for given waveguide.

Q: Please explain how does the circuit work base on the given circuit diagram.

A: Given circuit diagram with an LED in series with a resistor and a buzzor in parallel to the supply.

Q: Calculate the maximum value of Rb when Vin = 5V

A: It is given that: Vin=5V

Q: Q3-A)-Indicate whether the following statements are true or false and correct the false statements…

A:

Q: 1. What resistance must be placed in parallel with a 12 Q2 resistor to obtain a combined resistance…

A: In this question we need to find a resistance value connected in parallel to 12 ohm so that…

Q: maximum value.

A:

Q: A resistance R-30 2 is connected in series with an inductance (L) of reactance X₁.- 40 2 and a…

A: Series RLC circuit-                     impedance Z= R+ j(XL-XC)           magnitude of…

Q: Q4-A10 KVA transformer During the day it is loaded as follows: For 6 hours For 8 hours full load at…

A:

Q: A 400 resistor is connected in parallel to a coil having a resistance of 10 and an inductance of 3H.…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: 2. Design a bandpass filter of the following form with a lower cutof frequency of 20.1 kHz and an…

A: Solution- Given, fL = 20.1 KHzfH = 20.3 KHzR =20 Kohm for series RLC circuit,fH = 12πR2L+R2L2+1LC…

Q: 6. Use Kirchhoff's Laws to calculate the potential difference and the current across each resistor…

A:

Q: A wire 1.5 m long has a cross-sectional area of 2.4 m It is hung vertically stretches 0.32 mm when a…

A: Given, l =1.5 mA = 2.4 mm2∆l = 0.32 mm = 0.3210-3 mm = 10 kg ∑FY =0T-mg =0T-109.81 = 0T = 98.1…

Q: Example 32.16. A 50-kVA, 4,400/220-V transformer has R₁ = 3.452, R₂ = 0.009. The values of…

A:

Q: By Nodal Analysis, obtain Io j4Ω 100/20° V 3Ω In ΖΩ ΑΛΛΑ 1431 ΤΩ -j2 Ω

A:

Q: Consider the circuit in Figure A4. (a) Explain its operation with the aid of diagrams. (b) Assume…

A: Given the circuit, as shown below: a) We need to explain its operation with the aid of diagrams.b)…

Q: 1) A 0.0159 HInductance coil and a 40 ohm resistor are connected in series across 240 volts, 60…

A: As per bartleby guideline for more than one question asked only first is to be answered please…

Q: A 16 bit ADC system with a sample period of 20µs is used to record a song that lasts for 5 minutes.…

A:

Q: Explain the working principle of the 3-phase motor control with forward-reverse-stop pushbuttons.…

A: To explain the working principle of the 3-phase motor control with forward-reverse-stop pushbuttons.

Q: Example 8.11(b). A 4-pole lap-connected armature of a d.c. shunt generator is required to supply the…

A: DC shunt generator- In a shunt-wound generator, the field winding is connected across the armature…

Q: Determine the LED “on” current for the circuit above. Assume the logic “on” voltage is 5 volts, VLED…

A:

Q: Find Z₁ for maximum average power transfer and the maximum average power transferred. ΠΩ www 1Ω…

A:

Q: For the ideal transformer that shown in Fig. 2.b. (a = N₂/N₁) prove that: ZL 1. Zin = 2/14342 2.…

A:

Q: Q3. Consider the sequence: x(n) = 48(n) + 38(n-1) + 28(n-2) + 8(n-3) Let X(k) be the six-point DFT…

A:

Q: An electron in a TV picture tube moves toward the front of the tube with a speed of V = 5.10 m/s.…

A: We need to find out magnetic force on electron

Q: Question2: Given the sequence for k= 0, 1, 2 for k = 3,4 h(k)= = { 0 elsewhere, where k is the time…

A:

Q: A DC shunt motor is supplied by 250-volt and 15kW at rated load, if the No-load speed r.p.m and…

A: In this question we will find the efficiency , speed and torque developed for dc shukr motor....

Q: The displacement of an object is measured using a linear potentiometer with resistance Rp = 1.8 k as…

A: The given circuit is shown below. Given information about The circuit is, Rp=1.8 kΩ. L=250 mm.…

Q: R(s) + a s(s+ b) C(s) G(s) Figure 3(a): Uncompensated System E(s) Lead G(s) Figure 3(b): Phase Lead…

A:

Q: Q5/ Using a 4-Y or Y-A conversion, find the current I in each of the networks in Fig. 5. www 4 kn…

A:

Q: 1 diagrams of both the direct forms I and II simulation diagrams for the systems with the following…

A:

Q: 10.23. Draw the block diagrams of both the direct forms I and II simulation diagrams for the systems…

A:

Q: Q1. Multiple Choice Questions (MCQ): 1. For a horn antenna, in which flaring is done only in one…

A: As per guidelines given to us we can only provide the solution of first question in multiple type of…

Q: e RMS value of the voltage waveform

A: Active Power- It is power utilized by the load. Reactive power- It is the power which remains within…

Q: sunny Note: - You are attempting question 4 out of 12 A three phase,20 MVA, 33 kV alternator having…

A: In this question we need to choose a correct option.

Q: 10 37. 38. 다 39. BIU A !!!

A: Since you have asked multiple questions, we will solve the first question for you as per guideline.…

Q: For the circuit shown in Fig 4 find 1- Rth to the left of the terminals a-b. 2- Maximum power…

A: In this question,  We need to determine the Thevenin resistance across the terminal a and b.  Also…

Q: An electron in a TV picture tube moves toward the front of the tube with a speed of V = 5.10 m/s.…

A: We will find out magnetic force.

Q: If resonant frequency, wo = 1100 rad/s, find the following: a) L in mH; b) Quality factor Q; c)…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: HW: Determine the output expression if NAND gates are used in Fig. 3-26. A B C D E F G H a a +Vc Q…

A: By using concept of wired logic we need to derive the output Boolean expression for the given logic…

Q: A 230 V DC shunt motor has a full-load efficiency of 89.9%. Rated (full) load is 40 hp. Motor…

A: As per the guidelines of the bar