Gas Stoichionmetry1. What volume (in mL) of carbon dioxide forms when 525 milligrams of calcium carbonate reacts with excesshydrochloric acid? Assume that the carbon dioxide is formed at a pressure of 201 kPa and a temperature of 25°C.CaCO3(5) + HClaq) → CO,(g) + H,0,g) + CaClz{aq}[unbalanced equation]metalஅ

The volume of carbon dioxide is to be calculated when 525 milligrams of calcium carbonate reacts…

Answered: Gas Stoichionmetry 1. What volume (in…

Chemistry: Principles and Practice

3rd Edition

ISBN:9780534420123

Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Chapter6: The Gaseous State

Section: Chapter Questions

Problem 6.18QE

See similar textbooks

Similar questions

What is the value of FP for a sample of gas whose temperature is -33.0 C and volume is 0.0250 L? What temperature is required to change the volume to 66.9 cm3?
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
Methane (CH4) gas flows into a combustion chamber at a rate of 200. L/min at 1.50 atm and ambient temperature. Air is added to the chamber at 1.00 atm and the same temperature, and the gases are ignited. a. To ensure complete combustion of CH4 to CO2(g) and H2O(g), three times as much oxygen as is necessary is reacted. Assuming air is 21 mole percent O2 and 79 mole percent N2, calculate the flow rate of air necessary to deliver the required amount of oxygen. b. Under the conditions in part a, combustion of methane was not complete as a mixture of CO2(g) and CO(g) was produced. It was determined that 95.0% of the carbon in the exhaust gas was present in CO2. The remainder was present as carbon in CO. Calculate the composition of the exhaust gas in terms of mole fraction of CO, CO2, O2, N2, and H2O. Assume CH4 is completely reacted and N2 is unreacted.
5-54 Automobile air bags are inflated by nitrogen gas. When a significant collision occurs, an electronic sensor triggers the decomposition of sodium azide to form nitrogen gas and sodium metal. The nitrogen gas then inflates nylon bags, which protect the driver and front-seat passenger from impact with the dashboard and windshield. What volume of nitrogen gas measured at 1 atm and 27°C is formed by the decomposition of 100. g of sodium azide?
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.
5-25 A gas in a bulb as in Figure 5-3 registers a pressure of 833 mm Hg in the manometer in which the reference arm of the U-shaped tube (A) is sealed and evacuated. What will the difference in the mercury levels be if the reference arm of the U-shaped tube is open to atmospheric pressure (760 mm Hg)?
5-37 A sample of a gas at 77°C and 1.33 atm occupies a volume of 50.3 L. (a) How many moles of the gas are present? (b) Does your answer depend on knowing what gas it is?
The compression ratio in an automobile engine is the ratio of the gas pressure at the end of the compression stroke to the pressure in the beginning. Assume that compression occurs at constant temperature. The total volume of the cylinder in an automobile is 350 cm3, and the displacement the reduction in volume during the compression stroke is 309 cm3. What is the compression ratio in that engine?
A gas of pure N2i s confined to a cylinder with a movable piston at one end. The initial pressure of gas is 1.2 x 105 N/m2, the initial volume is 1.0 x 10-3m3, and the initaltemperature is 30oC. (a) How many moles of the gas are in the container? If the piston is compressed so that the pressure is increased to 4.20 x 105 N/m2 and volume is decreased to 5.10 x 10-4m3, what is the new temperature of the gas?
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. The beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
P1A.6 The molar mass of a newly synthesized fluorocarbon was measured in a gas microbalance. is device consists of a glass bulb forming one end of a beam, the whole surrounded by a closed container. e beam is pivoted, and the balance point is attained by raising the pressure of gas in the container, so increasing the buoyancy of the enclosed bulb. In one experiment, the balance point was reached when the fluorocarbon pressure was 327.10Torr; for the same setting of the pivot, a balance was reached when CHF3 (M = 70.014 g mol−1) was introduced at 423.22 Torr. A repeat of the experiment with a di erent setting of the pivot required a pressure of 293.22 Torr of the uorocarbon and 427.22 Torr of the CHF3. What is the molar mass of the fluorocarbon? Suggest a molecular formula.
One type of gas mixture used in anesthesiologyis a 50%/50% mixture (by volume) of nitrous oxide (N2O) and oxygen(O2), which can be premixed and kept in a cylinder for later use.Because these two gases don’t react chemically at or below 2000 psi, attypical room temperatures they form a homogeneous single gas phase,which can be considered an ideal gas. If the temperature drops below-6C, however, N2O may begin to condense out of the gas phase. Thenany gas removed from the cylinder will initially be nearly pure O2; asthe cylinder empties, the proportion of O2 will decrease until the gascoming from the cylinder is nearly pure N2O. In a hospital, pure oxygen may be delivered at 50 psi (gaugepressure) and then mixed with N2O. What volume of oxygen at 20Cand 50 psi (gauge pressure) should be mixed with 1.7 kg of N2O toget a 50%/50% mixture by volume at 20C? (a) 0.21 m3; (b) 0.27 m3;(c) 1.9 m3; (d) 100 m3

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Introduction to General, Organic and Biochemistry

Chemistry

ISBN:

9781285869759

Author:

Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:

Cengage Learning

Physical Chemistry

Chemistry

ISBN:

9781133958437

Author:

Ball, David W. (david Warren), BAER, Tomas

Publisher:

Wadsworth Cengage Learning,

Chemistry: Principles and Practice

Chemistry

ISBN:

9780534420123

Author:

Daniel L. Reger, Scott R. Goode, David W. Ball, Edward Mercer

Publisher:

Cengage Learning

Introduction to General, Organic and Biochemistry

Chemistry

ISBN:

9781285869759

Author:

Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar Torres

Publisher:

Cengage Learning

Physical Chemistry

Chemistry

ISBN:

9781133958437

Author:

Ball, David W. (david Warren), BAER, Tomas

Publisher:

Wadsworth Cengage Learning,

General Chemistry - Standalone book (MindTap Cour…

Chemistry

ISBN:

9781305580343

Author:

Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; Darrell

Publisher:

Cengage Learning

Principles of Modern Chemistry

Chemistry

ISBN:

9781305079113

Author:

David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:

Cengage Learning

Introductory Chemistry: An Active Learning Approa…

Chemistry

ISBN:

9781305079250

Author:

Mark S. Cracolice, Ed Peters

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS