Given the following two standard electrode reduction potential half reaction decide which reaction will get oxidized and which reaction will get reduced. Next determine which half reaction will take place at cathode and which at the anode. Next determine the standard cell potential (E°cell). Next balanced both half reactions to get the balanced overall oxidation-reduction reaction. Next if you only have 8.76 grams of NO3- then what is the maximum work (Wmax) that can be performed. Finally if you are given the concentrations for each reactant and product determine what the non-standard cell potential (E) will be.

Given the following two standard electrode reduction potential half reaction decide which reaction will get oxidized and which reaction will get reduced. Next determine which half reaction will take place at cathode and which at the anode. Next determine the standard cell potential (E°cell). Next balanced both half reactions to get the balanced overall oxidation-reduction reaction. Next if you only have 8.76 grams of NO3- then what is the maximum work (Wmax) that can be performed. Finally if you are given the concentrations for each reactant and product determine what the non-standard cell potential (E) will be.

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter2: Electrical Components And Circuits

Section: Chapter Questions

Problem 2.12QAP

See similar textbooks

Similar questions

The volume of HCI is 100 mL , mass of solid added is 1.008g, moles of solid 0.0276 Mol, mass of HCI is 100g, initial temperature is 21.8 degrees Celsius, Final temperature is 30.7 degrees Celsius, Calculate q rxn(= -mc Delta T of HCI),
a cylinder was connected to an open ended U-tube (1 atm) containing some mercury, Hg (density=13.6gcm^-3), and the Hg was displaced 100mm towards the container. What is the pressure of the gas inside the container?
What is the mole fraction of magnesium nitrate, Mg(NO3)2, in an aqueous solution that is 5.549 wt % in magnesium nitrate? MW(Mg(NO3)2) = 148.315 g/mol. 5.834e-2 1.721e-1 7.080e-3 9.929e-1
Ammonia gas (A) diffuses through a stagnant gas mixture consisting of one-third Nitrogen (B) and two thirds Hydrogen (C) by volume. The total pressure is 206.8 kN/m2 and the temperature is 540c.Calculate the rate of diffusion of Ammonia through a film of gas 0.5mm thick when the concentration change across the film is 10% to 5% by volume. The diffusivities at 200 0 c and one std. atm.pressure are reported to be DAB = 5.391 x 10 -4 m2 /s and DAC = 1.7371 x 10 -4 m2 /s.
Ammonia (considered to be ideal gas, 1 mole) initially at 25 oC and 1 bar pressure is heated at constant pressure until the volume has tripled.Use CP = 25.895 + 32.999 x 10^– 3 T – 30.46 x 10^– 7 T2 , J/mole-KCalculate: c) delta H d) delta U e) delta S show complete solution
Combustible vapor-air mixtures are flammable over a limitedrange of concentrations. The minimum volume % of vapor thatgives a combustible mixture is called the lower flammable limit(LFL). Generally, the LFL is about half the stoichiometric mix-ture, the concentration required for complete combustion of thevapor in air. (a) If oxygen is 20.9 vol % of air, estimate the LFL forn-hexane, C₆H₁₄. (b) What volume (in mL) of n-hexane (d=0.660 g/cm³) is required to produce a flammable mixture of hexane in 1.000 m³of air at STP?
Calculate the partial pressure in atm of each gas in a mixture of gases. In a tank containing 16.00 grams of carbon dioxide, 26.50 g of nitrogen gas, and 8.00 grams oxygen gas for a total pressure of 80.0 kPa. Conversion: 1 atm = 101.325 kPa; MW(CO2) = 44.01 g/mol;MW(N2) = 28.0 g/mol; and MW(O2) = 32.0 g/mol. The pCO2, pN2, and pO2 in atm are .........., ............, and .............., respectively in 3 sig. figures.
Forgot to put the units they are asking for on the previous submission. Am I doing this correctly? A gaseous sample of molecules, with a molar mass of 87.9 g/mol, is contained in a cylinder at a temperature of 362. K and pressure of 101.9 kPa. The collision cross section of a molecule is 0.73 nm2 The collision freqency, z, of the gas under these conditions is ____________ s-1.
100.0 g of propyne (C3H4) (g) is burnt in a 30.0 L rigid vessel containing pure O2 (g) at P = 10.00 bar and an initial temperature of 25.0 °C. At the end of the reaction the temperature of the vessel is 250. °C. At the end of the reaction, what are the partial pressures (in bar) of CO2 (g) and O2 (g)?
If 15.1 g of the mixture with a volumetric composition of 45% N2, 35% O2 and 20% X gas is applying 3 atm pressure to a 5 dm3 volume vessel at 25 ° C, in which option is the molecular weight of X gas given correctly? (MN2: 28 gmol-1, MO2: 32 gmol-1)
A truck tire has a volume of 218 L and is filled with air to 35.0 psi at 295 K. After a drive, the air heats up to 318 K. (a) If the tire volume is constant, what is the pressure? (b) If the tire volume increases 2.0%, what is the pressure? (c) If the tire leaks 1.5 g of air per minute and the temperature is constant, how many minutes will it take for the tire to reach the original pres-sure of 35.0 psi (μ of air= 28.8 g/mol)?
1. Determine the value of the ideal gas constant.2. Compare your value of ideal gas constant to the literature value, and calculate the percent error. Mg(s) + 2 HCl(aq) -> H2 (g) + MgCl2(aq) given: Mass of Mg Ribbon: 0.0325g10 mL of 6 M HCl Barometric Pressure: 101.8 kPa Room Temperature: 24.5 oC Water Vapour Pressure: 23.1 mmHg Mass of Mg Ribbon: 0.0325g Initial volume of the Burette: 1.55 mL Final Volume of the Burette: 36.35 mL Height of the Water Column in the Burette: 167.0 mm