(h) Consider the binary phase diagram below. i. What is the eutectic composition and temperature? At 150°C, what is the solubility limit of Sn in Pb? At 250°C with an alloy of the same overall composition by weight, what phase(s) is/are present? For a 40 wt% Sn-60 wt% Pb alloy at 200°C, determine: (a) the phase present, (b) the phase compositions and (c) the relative amount of each phase. In addition to your solution, you should indicate your tie line on the figure. ii. 111. iv. Composition (at% Sn) 20 40 60 80 100

(h) Consider the binary phase diagram below. i. What is the eutectic composition and temperature? At 150°C, what is the solubility limit of Sn in Pb? At 250°C with an alloy of the same overall composition by weight, what phase(s) is/are present? For a 40 wt% Sn-60 wt% Pb alloy at 200°C, determine: (a) the phase present, (b) the phase compositions and (c) the relative amount of each phase. In addition to your solution, you should indicate your tie line on the figure. ii. 111. iv. Composition (at% Sn) 20 40 60 80 100

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Using the Mg-Pb phase diagram below, if you start at point A andcool down very slowly to room temperature (point D), sketch the microstructure associated with each letter, determine what phases are present at each letter, determine the compositions for each phase, and determine the weight in each phase. The Mg-Pb mixture has 20 wt. % Pb in it. You start with 100 kg. A. 700ºC B. 600ºC C. 400ºC D. 25ºC
In the system NaCl-H2O, a simple eutectic is observed at −21.1°C for a solution containing 23.3% by weight NaCl where NaCl•2H2O and ice crystallize out of the mixture. At a composition of 27% by weight of NaCl and at −9°C a peritectic point exists where the dihydrate decomposes to form anhydrous NaCl. The temperature coefficient of solubility of anhydrous NaCl is very small and positive. Make a rough sketch for the system showing clearly the phases in equilibrium in the various areas and along the curves of the diagram.
1. Sodium carbonate is recovered as decahydrate from 1000kg of 5% solution of sodium carbonate in water. If it is desired that 95% of Na2CO3 is to be recovered as decahydrate by cooling to 278 K, determine the following: a) the mass of water evaporated (b) the mass of crystals obtained (Na2CO3 ∙ 10H2O). The solubility of Na2CO3 in water at 278K is 9.0% (weight) 2. A copra batch contains 44% oil and is to be extracted with n-hexane. The extracted meal contains 0.07 kg of oil/kg oil free matter and the mass fraction of n-hexane in it is 0.05. The extract contains 49% n- hexane. If 10,000 kg of copra are to be processed, how many kg of n-hexane are required and the determine the amount of extract. 3. Absorption of sulphur dioxide is carried out in a packed tower. Gas containing 14.8% sulphur dioxide and the rest inert gases enters the tower while the leaving gases contains 1% sulphur dioxide. Water flows at the rate of 1m3/min. The tower handles 7380 m3/hr of gas at 303K and 1 bar. Find…
L-Serine is an amino acid important for its roles in synthesizing other amino acids and for its use in intravenous feeding solutions. It is often synthesized commercially by fermentation, and recovered by subjecting the fermentation broth to several processing steps and then crystallizing the serine from an aqueous solution. The solubilities of L-serine (L-Ser) in water have been measured at several temperatures, producing the following data:5T(K) 283.4 285.9 289.3 299.1 316.0 317.8 322.9 327.1x(mole fraction L-Ser) 0.0400 0.0426 0.0523 0.0702 0.1091 0.1144 0.1181 0.1248One of the ways such data can be represented is with the van’t Hoff equation: ln x =( a=T b).Graph the data so that the resulting plot is linear. Estimate a and b and give their units.
Polyethylene glycol 400 (PEG400) is a nonvolatile liquid polymer, which when mixed with water canbe used as a base for parenteral formulations. The designation “400” means that the molecular weightof PEG molecules is approximately 400 g/mol. Preparation with water (ΔHv = 40.7 kJ/mol) requires that the two be mixed at 56 oC, at which the equilibrium vapor pressure of pure water is 16.5 kPa. a. If 105 g of PEG400 are added to 500 g of water at 56 oC, what will the boiling temperature of the solution be?
The following temperature-composition data were obtained for a mixture of octane (O) and methylbenzene (M) at 1.00 atm, where x is the mole fraction in the liquid and y the mole fraction in the vapour at equilibrium. The boiling points are 110.6oC and 125.6oC for M and O, respectively Plot the temperature-composition diagram for the mixture. What is the composition of the vapour in equilibrium with the liquid of composition (i)Xm =0.250 and (ii) Xo =0.250?
(a) The heat evolved upon dissolution of atmospheric ozone into water is determined to be +5 kcal/mol at 298 K. Given that ozone has a Henry’s constant of 9.4 × 10−3 mol/L/atm at 298 K, determine its Henry’s constant at 273 K. Note that the definition of Henry’s constant is for the process air to water. (b) If the atmospheric ozone concentration in a polluted air is 100 ppbv, what is the concentration in equilibrium with a body of water in that region at 298 K? Note that you need to assume no losses of ozone other than absorption into water
Water boils at 100 oC at 1 atm (101325 Pa). Tom dissolve 574.4 g of sugar (MW = 342.3 g/mol) in 1.25 Kg of water (MW = 18.02 g/mol). Assuming ideal, use Raoult's law to estimate the vapor pressure of water of the mixture at 100 oC. Pwater = _______ Pa. 3 sig. fig.
Determine the following from the Txy diagram of a two-component (A and B) solid-liquid system: a) Consider a mixture with overall B composition of 0.57. What is the ratio of the amount of solid containing 0.67 B and 0.33 A to the amount of the eutectic mixture at the eutectic temperature? b) What is the chemical formula of the solid represented by the vertical phase boundary passing through point g? (Hint: use mole fractions of A and B to answer this) c) Suppose we have a solid mixture represented by point k. How much of the solid in Problem 4c is in equilibrium per kg of pure B?
The assumptions about the virtual process state diagrams of metals A and B similar to the lead-tin system in Figure 9.8 are as follows. (1)The α phase and β phase exist at both ends of A and B. (2) The process composition is 36 wt% A to 64 wt% B. (3) The composition of β phase at the process temperature is 88 wt% A to 12 wt% B. Find the composition of an alloy in which the weight fraction of invitation β and total β is 0.367 and 0.768, respectively.
A polymer of large molar mass is dissolved in the organic solvent m-cresol (C7H8O) at 25 °C, and the resulting solution rises to a final height of 13.4 cm above the level of the pure solvent, as solvent molecules pass through a semipermeable membrane into the solution. If the solution contains 5.24 g polymer per liter, calculate the molar mass of the polymer. Take the density of the solution to be 1.03 g cm-3.
The separation of aromatic compounds from paraffins is essential in producing many polyesters that are used in a variety of products. When aromatics and paraffins have the same number of carbon atoms, they often have similar vapor pressures, which makes them difficult to separate by distillation. Extraction is a viable alternative, as illustrated by the following simple system. Sulfolane (an industrial solvent) and octane may be considered completely immiscible. At 25°C, the ratio of the mass fraction of xylene in the octane-rich phase to the mass fraction of xylene in the sulfolanerich phase is 0.25. One hundred kg of pure sulfolane are added to 100 kg of a mixture containing 75 wt% octane and 25% xylene, andthe resulting systemis allowedto equilibrate. How much xylenetransferstothe sulfolane phase?