Important válues if needed for this question. The freezing point of benzene, CH, is 5.500 °C at 1 atmosphere. K(benzene) = 5.12 °C/m In a laboratory experiment, students synthesized a new compound and found that when 10.98 grams of the compound were dissolved in 226.7 grams of benzene, the solution began to freeze at 4.640 °C. The compound was also found to be nonvolatile and a non-electrolyte. What is the molecular weight they determined for this compound? g/mol

Important válues if needed for this question. The freezing point of benzene, CH, is 5.500 °C at 1 atmosphere. K(benzene) = 5.12 °C/m In a laboratory experiment, students synthesized a new compound and found that when 10.98 grams of the compound were dissolved in 226.7 grams of benzene, the solution began to freeze at 4.640 °C. The compound was also found to be nonvolatile and a non-electrolyte. What is the molecular weight they determined for this compound? g/mol

Chemistry: An Atoms First Approach

2nd Edition

ISBN:9781305079243

Author:Steven S. Zumdahl, Susan A. Zumdahl

Publisher:Steven S. Zumdahl, Susan A. Zumdahl

Chapter10: Properties Of Solutions

Section: Chapter Questions

Problem 124CP

See similar textbooks

Similar questions

Which solute has the greatest effect on the boiling pointof 1.00 kg of water: 50.0 g of strontium chloride (SrCl2) or 150.0 g of carbon tetrachloride (CCl4) ? Justify youranswer.
For each of the following pairs of solutions, select the solution for which solute solubility is greatest. a. Ammonia gas in water with P = 1 atm and T = 50C Ammonia gas in water with P = 1 atm and T = 90C b. Carbon dioxide gas in water with P = 2 atm and T = 50C Carbon dioxide gas in water with P = 1 atm and T = 50C c. Table salt in water with P = 1 atm and T = 60C Table salt in water with P = 1 atm and T = 50C d. Table sugar in water with P = 2 atm and T = 40C Table sugar in water with P = 1 atm and T = 70C
Some lithium chloride, LiCl, is dissolved in 100 mL of water in one beaker, and some Li2SO4 is dissolved in 100 mL of water in another beaker. Both are at 10 C, and both are saturated solutions; some solid remains undissolved in each beaker. Describe what you would observe as the temperature is raised. The following data are available to you from a handbook of chemistry:
Calcium chloride, CaCl2, has been used to melt ice from roadways. Given that the saturated solution is 32% CaCl2 by mass, estimate the freezing point.
The dispersed phase of a certain colloidal dispersion consists of spheres of diameter 1.0 102 nm. (a) What are the volume (V=43r2) and surface area (A = r2) of each sphere? (b) How many spheres are required to give a total volume of 1.0 cm3? What is the total surface area of these spheres in square meters?
Sodium chloride (NaCl) is commonly used to melt ice on roads during the winter. Calcium chloride (CaCl2) is sometimes used for this purpose too. Let us compare the effectiveness of equal masses of these two compounds in lowering the freezing point of water, by calculating the freezing point depression of solutions containing 200. g of each salt in 1.00 kg of water. (An advantage of CaCl2 is that it acts more quickly because it is hygroscopic, that is. it absorbs moisture from the air to give a solution and begin the process. A disadvantage is that this compound is more costly.)
A solution is made by dissolving 34.0 g of NaCl in 100 g of H2O at 0C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated
Instead of using NaCl to melt the ice on your sidewalk you decide to use CaCl2. If you add 35.0 g of CaCl2 to 150. g of water, what is the freezing point of the solution? (Assume i = 2.7 for CaCl2.)