Measure the mass of 0.400g of Co(NO3)2 + 6H2O and dissolve it in 15mL of distilled or deionized water using a clean beaker Then while using a graduated cylinder, measure out 10.0mL of a prepared 0.10-M Na3PO4 soultion. Determine which compound Na3PO4 or Co(NO3)2 *6H2O will be the limliting reagent. Then detrimine the theiretical yeild

Measure the mass of 0.400g of Co(NO3)2 + 6H2O and dissolve it in 15mL of distilled or deionized water using a clean beaker Then while using a graduated cylinder, measure out 10.0mL of a prepared 0.10-M Na3PO4 soultion. Determine which compound Na3PO4 or Co(NO3)2 *6H2O will be the limliting reagent. Then detrimine the theiretical yeild

Chemistry

9th Edition

ISBN:9781133611097

Author:Steven S. Zumdahl

Publisher:Steven S. Zumdahl

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 109AE: Patients undergoing an upper gastrointestinal tract laboratory test are typically given an X-ray...

See similar textbooks

Similar questions

The first goal is to make the oxalic acid standard solution. You measure 1.5232 g of oxalic acid on an analytical balance, add it to a 250-mL volumetric flask and add deionized H2O to a final volume of 250.0 mL. Molar mass of H2C2O4•2H2O = 126.07 g/mol Mass of H2C2O4•2H2O = 1.5232g Volume of H2C2O4•2H2O solution = 250.0mL What is the Molarity H2C2O4 standard solution ?
Six 50.0 ml volumetric flask 1 through 6 are labeled. 10.00 ml of 2.00 x 10-1 M Fe(NO3)3 solution was then pipet into each volumetric flask. A 1.00,2.00,3.00,4.00 and 5.00ml of 2.00 x 10-3M NaSCN solution was then pipetted to flask 2 through 6 respectively. A sufficient amount of 0.10 M nitric acid was then added to each flask to make each a total volume of 50.00ml. Hint M1V1=M2V2 a)what would be the concentration of Fe(NO3)3 in 0.10M HNO3? b)what would be the concentration of NaSCN in 0.10M HNO3?
The standard addition method is used to analyze a sample of a river water for mercury. Solution A is made by pipetting 5.00 mL of undiluted sample in to a 10 mL volumetric flask and filling to the mark with DI water. Solution B is made by pipetting 5.00 mL of undiluted sample and 3.00 mL of 15.0 ppb of Hg standard into same 10.0 mL volumetric flask and filling to the mark with DI. Solution A and B are analyzed using atomic absorption spectroscopy and give a percent transmittance values of 56 % and 33 % respectively (not blank corrected). A blank has a transmittance of 96%. What is the corrected absorbance of both solution A and B? A. Solution A: 0.123 Solution B: 0.463 B. Solution A: 0.463 Solution B: 0.234 C. Solution A: 0.123 Solution B: 0.234 D. Solution A: 0.234 Solution B: 0.463
Drug: C20H22ClN (Flexeril also known as iCyclobenzaprine HCl Using unit analysis, clearly show the set-ups for your calculations. You wish to prepare 50.0 mL of 2.30 x 10–2 M solution of your drug. (hint-how many grams will you need of your drug?) Describe how to prepare this solution from the pure drug and deionized water. Analytical balances and volumetric flasks are available to you. (Assume that your drug dissolves in water, at least to the extent necessary for this problem.) Use complete sentences in your description of the solution preparation process. A patient is given 2.0mL of a 3.00% (m/v) solution of your drug, how many milligrams of the drug did they receive? What is the molarity of a 3.00% (m/v) solution of your drug?
Consider the titration illustrated in Figure 8.] Anhydrous sodium carbonate (Na₂CO₃) is a primary standard. When 0.364 grams of the substance is placed in a conical flask, then 20.00 cm³ of sulphuric acid (H₂SO₄) solution is required to reach the end point of the titration. What is the concentration in mol·dm⁻³ of the sulphuric acid solution? [Give the answer to 3 decimal places. Do not type in the unit. Use a decimal point.] *
The first goal is to make the oxalic acid standard solution. You measure 1.5232 g of oxalic acid on an analytical balance, add it to a 250-mL volumetric flask and add deionized H2O to a final volume of 250.0 mL. Molar mass of H2C2O4•2H2O = 126.07 g/mol Mass of H2C2O4•2H2O = 1.5232g what is the Number of moles of H2C2O4•2H2O?
A chemist attempts to prepare some very pure crystals of borax by dissolving 100g of Na 2 B 4 O 7 in200 grams of boiling water. He then cools the solution slowly until some borax crystallizes out.Calculate the grams of borax recovered in the crystals per 100 grams of initial solution (Na 2 B 4 O 7plus water), if the residual solution at 55 0 C after the crystals are removed contains 12.4%Na 2 B 4 O 7 . What is the percent yield or percent recovery of Na 2 B 4 O 7 . (MW: Na =23, O =16, B=10.8,H =1) round off up to 4 decimal places
1. Give the molar concentration of HCl with a specific gravity of 1.18 and 37.0% (w/w) purity (MM=36.5g/mol) 2. A solution made by adding 1.63 g of K2S (MM=110.3 g/mol) to 10.0 mL of H2O has a volume at 20oC of 11.1 mL. Find the molarity and normality of the solution.
Mass solute needed to prepare 0.500L of 0.2 M NaCO3 from a solid NaCO3 with a purity of 92.0wt%
The % purity of a powdered crude sample of Na^2CO^3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. Write the balanced chemical equation of the reaction in your solutions sheet. What is the sum of all the coefficients of the balanced chemical equation? Determine the pressure of the trapped gas inside the eudiometer in mmHg. Determine the partial pressure of the collected CO^2 in mm Hg. How many millimoles of CO^2 was collected? What is the % purity of the sample to the nearest whole number?
The % purity of a powdered crude sample of Na^2CO^3 containing only inert impurities is to be determined by reacting 225.0 mg of the crude sample to 10.0 mL of 3.00 M HCl solution, and bubbling the resulting CO2(g) product in water that is at exactly 29 °C. After the reaction has completed, the level of the liquid inside the eudiometer rests 4.30 cm above the water level in the beaker. The graduation on the eudiometer indicates that the trapped gas is 44.37 mL. The experiment was done under a barometric pressure of 755.2 torr. What is the % purity of the sample to the nearest whole number?
Prepare the following solutions: 100.0 mL 0.0500 M stock Ca2+ solution 50.0 mL 0.0050 M working standard Ca2+ solution from 0.0500 M Ca2+