) tecnoAl CAMERANitrogen in organic Compunds is tested by theaddition of few drops of Saturated ironCii) SulphaeSolution to a Small Portion of Sodiem filein filtrate.Dilute hydregen tetmoxosulphate(v) is albso added tothe lator Solution Leading to a formatiīon oF prusienblue colour or preaipitate Signalling the presenca Ofnitrogen. Shaw these steps Using equations and nameyour find product

Answered: Image /qna-images/answer/5fd6e551-aa71-495a-9e6f-df5bbcf23b85.jpg

Nitrogen in organic Compunds is tested by the addition of few dops of Saturated iron Cici) Sulphae Solution to a Small portion oF Sodien fulbrin filtrate. Dilute hydregen tetmorosulphate(v) is also added to the lator Solution leading to a formation OF pasien blue colour or preaipitate Signalling the presenca Of nitrogen. Shaw these steps using egruations and name your find product

Nitrogen in organic Compunds is tested by the addition of few dops of Saturated iron Cici) Sulphae Solution to a Small portion oF Sodien fulbrin filtrate. Dilute hydregen tetmorosulphate(v) is also added to the lator Solution leading to a formation OF pasien blue colour or preaipitate Signalling the presenca Of nitrogen. Shaw these steps using egruations and name your find product

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.13QAP

See similar textbooks

Similar questions

A sample of feldspar weighing 1.500g is decomposed, and eventually there is obtained a mixture of KCl and NaCl weighing 0.1801 g. These chlorides are dissolved in H2O, a 50-mL pipetful of 0.08333 N AGNO3 is added, and the precipitate is filtered off. The filtrate requires 16.47 mL of 0.1000N KCNS, with ferric alum as indicator. Calculate the percentage of K2O in the silicate.
Six iron tablets containing FeSO4.7H2O were dissolved in 100-ml of 0.1M HNO3 with gentle heating. All of the Fe2+ is converted to Fe3+ by the strong oxidizing conditions. After the solution had cooled to room temperature , 2.5-ml of 35wt% NH4OH was added. The precipitate Fe2O3-xH2O that was filtered weighed 0.345g. Thermogravimetric analysis of the crude product showed a 10.5% weight loss . A. How many waters of hydration were in the precipitate B. How much iron is present in each tablet
A 50 mL sample solution containing 8-hydroxyquinoline (MW: 145) was analyzed by adding 25 ml, 0.1 M KBrO3, excess KBr and acidified. The mixture was left for 10 minutes in dark place. After this time KI in excess was added followed by titration with 27.9 mL, 0.05 M thiosulfate standard solution. Write balance equations? What is the percent w/v 8-hydroxyquinoline in sample?
Hexanoic acid was added to an immiscible biphasic solvent sysem, water and CCl4 at 20.0OC and the equilibrium concentrations of hexanoic acid were determined to be 3.66 g/L in H2O and 67.0 g/L in CCl4. Caluclate the distrubution coeffiecent (D1) of hexanoic acid in CCl4 with respect to water.
One gram of sodium hydroxide (NaOH) is used to adjust the pH of an aqueous solution (200 gallons) thatcontains 10 lbs of finely ground rhodochrosite (MnCO3) ore. Does the NaOH raise or lower the solutionpH? What is the amount of NaOH added in lbs/ton? What is the molarity (mol/l) of the system? Assumingthe NaOH is completely soluble and the system is at room temperature, what is the solid-to-liquid ratio(wt%) of the system?
In the development o f an analytical method for the quantitative analysis o f iron using Atomic Absorption spectrophotometry (AAS), a linear calibration curve for standards o f 0.00, 5.00, 10.00, 15.00 and 20.00 ppm was prepared. An iron ore sample with an expected iron content o f 40-60% w/w is to be analysed by this method. An approximately 0.5-g sample is taken, dissolved in a minimum amount o f concentrated HC1 and diluted to 1 L in a volumetric flask using distilled water. A 5.00-mL aliquot is removed with a pipette. With explanation, to what volume (10, 25, 50, 100, 250 500 or 1000 mL) should the 5.00 mL aliquot be diluted, to minimize the uncertainty in the analysis?
A sample of steel (0.506 g) was digested in acid and the solution made up to 100 cm3 with deionised water. Aliquots (25.0 cm3) of this solution were transferred into two volumetric flasks (100 cm3) labelled A and B. Flask A was made up to volume with deionised water. To flask B was added 10.0 cm3 of a 260 ppm standard solution of Mn2+ which was then also made up to volume with deionised water. The following absorbance results were obtained: Solution A = 0.356, Solution B = 0.578. Use these results to calculate the percentage (% w/w) of manganese in the steel sample.
Solution for 0.105g of the K3[Fe(C2O4)3] (MW= 437.2 g/ mol) were dissolved in sulfuric acid and got rated with 9 mL of 0.028M KMn04. What is the experimental weight percent of oxalate in the sample?
A sample of iron ore weighing 800 mg was treated with HNO3 , boiled to dryness and redissolved in dilute HCl. After filtration and removal of undissolved silica, the liquid was passed through a Walden reductor. The collected sample was titrated with 0.0210 M KMnO4 , requiring 12.0 mL to reach the end point. Calc %Fe (55.845) in the ore.
The concentration of CO in the air can be determined by passing a known volume of air through a tube containing I2O5, resulting in the formation of CO2 and I2. I2 is removed from the tube by distillation and collected in a solution containing excess KI, producing I3-. I3- is titrated with a standard solution of Na2S2O3. A 4.79 L air sample was sampled as described here, requiring 7.17 ml of 0.00329 M Na2S2O3 to reach the endpoint in a typical analysis. If the density of the air is 1.23×10^-3 g/ml, what is the amount of CO in the air in ppm? (CO: 28 g/ml)
A 100 g soil containing 20% smectitie mineral matter was mixed with 150 mL solution containing 0.10 M Pb. CEC of pure smectitie is 110 emol(+)/kg. CEC of the soil (cmol(+)/kg) is:
Thank you very much, Would you please answer this accordingly in the question as it mentioned? D) Finally show how an understanding of limiting reagents in the process of electrolysis of brine solution is important in optimizing this process. E) provide at least Two reference URL legitimate sources