Part 1: Process Diagram for Open-Loop Control Systems An open-loop control system can process an input condition to produce an output. Fill in the controller and the plant for each process shown below. Input > Controller Control Output Plant Light On Control. Light On Toasted Bread Toasted Control Bread

Nuclear Instrumentation and Control A proportional controller has a proportional band value of 50%.  What is its gain?  The controller experiences a 2 volt change at its measurement input.  After the controller returns the process to stable operation, what will the controller output voltage be?

Q1. a) Draw the general diagrams for open-loop control and closed-loop control. b) Draw the flowchart of the process for designing a control system.

QIA MCQ 1- The three basic operations that must be presented in every control system are: a- Measurement, Decision, Action b- control, observe, apply c- control, convert, communication d- convert, transmission, control 2- process variable or measurement are also used to refer to the -------- a- Controlled variable b- measured variable c- manipulated variable d-converted variable. 3- variable that causes the controlled variable to deviate away from the set point is defined as a ------ variable a- Upset b- manipulated c- converted d- measured 4- A -----------, is often necessary to change one type of signal into another type. a- Controller b- sensor c- filter d- transducer 5- The objective of feedforward control is to measure the --------and compensate for it. a- Output b- disturbances c- states d- set point 6- The level control process is almost --------- process a-Self-regulating b- Stable c- Integrating d- Complicated 7- The ---------is related to the speed of response of the process.…