Answered: s Cu(TPP) active in UV-Vis AND why?…

s Cu(TPP) active in UV-Vis AND why? EXPLAIN YOUR REASON. If you replace Cu2+ with Zn2+ and you have Zn(TPP), what will happen to the UV-vis spectra? EXPLAIN your answer

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter10: Atomic Emission Spectrometry

Section: Chapter Questions

Problem 10.8QAP

See similar textbooks

Related questions

Q: What photon energy and wavelength would you need to send on a compound having an energy gap (Eg) of…

A: Given, energy gap, Eg = 2.7 eV The energy of photon needed to be send to the compound should be…

Q: ow does fluorescence work in bulk semiconductors?

A: The term bulk semiconductor refers to the semiconductors which have large preservation of atoms and…

Q: What are the molecular processes that occur when (a) infrared, (b) x-ray, and (c) ultraviolet…

Q: Suitable analysis wavelengths for caesium (Cs) and zinc (Zn) are 852nm and 214nm respectively.…

A: Wavelength is the distance between the any of the two consecutive crust and trough of a wave. It is…

Q: Analytical Chemistry II Compare between the advantages and disadvantages of atomic emission…

A: Atomic emission spectroscopy: An Atomic spectra occurs when valence electrons from highest-energy…

Q: Q15: If you want a high-resolution gamma detector for 1 MeV gammas, which of these is best? a) A…

A: In electromagnetic radiation, Gamma rays are the highest-energy form as compared to other forms of…

Q: The peak widths if the spectra of atomic UV-vis are different from the molecular UV-vis spectra.…

A: The peak width of the atomic UV-vis is narrow while the peak width of the Molecular UV-vis spectra…

Q: 14.8) The resolution of visible and UV spectra can usually be improved by recording the spectra at…

A: UV-Visible spectra are obtained due to electronic transitions between different values.

Q: When analyzing for titanium (Ti) using ICP-OES, I find the 323.452 nm emission band of Ti that I…

A: "Since there are multiple sub-parts in this question and it is not mentioned that which one has to…

Q: Identify the maximum intrabeam permissible exposure (MPE) for the eye: a. CO2 laser for 10 seconds…

A: MPE (Maximum Permissible exposure ) is the maximum level of laser radiation to which a person may be…

Q: -Describe the principle of optical rotation method and refraction method. Which one is better for…

A: 1. Answer - optical rotation method - Optical rotation, also known as polarization rotation or…

Q: Which of the following describes molar extinction coefficient (ε)? I. ε is an intrinsic property…

Q: Do the wavelengths (at the highest % transmittance) match to the color of the solution in the…

A: In the highest transmittance, the weave length of the light does not math with color with solutions…

Q: Which of the following describes molar extinction coefficient (ɛ)? I. ɛ is an intrinsic property II.…

A: Ans. Molar extinction coeffient(ε): The molar attenuation coefficient(ε ) is a measurement of how…

Q: How would the position of a spectral line change as the distance L between the grating and the…

A: The distance between the center of the pattern and mth spectral line can be calculated using the…

Q: Which is NOT an appropriate detector for a spectrophotometer? photodiode array photomultiplier tube…

Q: what is the relationship between absorbance and transmittance? kindly explain it briefly

A: Incident light can be defined as the light that strikes on a solution.

Q: Copper was determined in an alloy sample by UV-visible spectrophotometry. The standard addition…

Q: Question 13 Particles are adsorbed onto a stationary phase is a step in Atomic Absorption…

Q: ___________Beer's Law can be applied to what spectroscopic techniques? All choices are correct…

A: Beers law states that the absorbance (A) is proportional to the concentration (C) and path length…

Q: Many ions form colored solutions when dissolved in water. For example, aqueous Cu2+ solutions are…

Q: The disadvantages of graphite furnace atomic absorption spectroscopy over flame atomic absorption…

A: Two important techniques for sample atomization are flame atomization and graphite furnace…

Q: Spectrophotometric Determination of Nitrate in Seawaters Explain the relationship between…

A: Since you have posted multiple questions, I will solve only first question for you. If you want any…

Q: When the concentration of a solution is doubled, the absorbance is doubled. If a 0.010 0 M solution…

A: The relation between absorbance and percent transmittance is: A = 2 - log(%T)

Q: solution needed to neutralize 500.0 mL of 0.30 M Ca(OH)2? 2.20 g NaOH are dissolved in-water 500 mL.…

A: Electronic configuration is defined as arrangement of electrons in shell , subshell and orbitals in…

Q: 2. (a) An atomic absorption spectrometer requires a very different light source than does an…

A: Part-a In atomic spectroscopy there is transition of electrons between electronic energy level in…

Q: Type of UV transition

A: Type of UV transitions

Q: Lambert–Beer law A transparent solution will have a transmittance of _____ (100% / 0% / 50%) . A…

A: According to this law the absorbance of a solution is directly proportional to the concentration of…

Q: The electron density maps (gray envelopes) derived from diffraction data obtained for the same small…

Q: Draw simple atomic energy level diagrams showing the following processes: Atomic Absorption Atomic…

Q: a- Draw the electromagnetic (EM) spectrum from γ-rays to radio indicating radiation wavelengths…

A: with increase in frequency the energy is increase AND WITH INCREASE IN WAVELENGTH IT SHOULD…

Q: 1. Using the graphs of the food dyes created from your data, use the Imax to determine the amount of…

A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: What absorbance value corresponds to 49.1% T? A = A 0.0179 M solution of a certain analyte exhibits…

A: Given : % T = 49.1 %

Q: Describe the basic design difference between a spectrometer for absorption measurements and one for…

A: The spectrometer is a device that measures and analyzes the spectral components of physical…

Q: The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of…

Q: o measure the absorbance of Fe(SCN)2+, write a procedure (detailed in steps) to accurately determine…

A: The wavelength and intensity of electromagnetic radiation is determine by the colorimetry.

Q: What are the advantages to using a near-IR excitation source, such as a diode laser (830 nm),…

A: Ans: Near IR Excitation source, the amount of Rayleigh scattering decrease.

Q: Why must solutions with high concentrations be diluted prior to analysis via Beer's Law? A. The…

A: Answer= option 1 (the relation between absorbance and concentration not linear at high…

Q: Beer’s law plot is prepared by plotting absorbance vs molar concentration of the absorbing species.…

A: The units for the above given as

Q: What value of absorbance corresponds to 45.0% T? If a 0.010 M solution exhibits 45.0% T at some…

A: We have to calculate the value is absorbance , also the percentage transmission.

Q: Which of the following is not a step in Atomic Absorption Spectroscopy (AAS)? A. Atoms absorb…

A: Answer:- (D) particles are absorbed onto to a stationary phase. Atomic absorption spectroscopy is…

Q: what is the relationship between a.)concentration and absorbance b.) concentration and…

A: Relationship between, a)concentration and absorbance, b) concentration and transmittance. (beer's…

Q: A 0.1 cm cuvette containing sample solution is irradiated with monochromatic light of intensity lo.…

Q: Which of the following is the purpose of beam splitter in double beam photometer or colorimeter? O…

A: Double beam spectrophotometer is used to compare the light intensity of light of reference sample…

Q: The fluorescence lifetime of a compound is 10 ns and a quantum yield of 10% was measured. Calculate…

A: The relation between quantum yield (ϕ) and fluorescence lifetime (τ) is: φ = kFτ Given: ϕ = 10% =…

Q: What happens to the result of a thick sample subjected to Micro X-ray Fluorescence? cannot map…

Q: Describe a practical that shows black surfaces are better emitters than white ones.

A: The black material performs as a perfect absorber of electromagnetic radiation on exposure to it.…

Q: Food dye spectroscopy 2. At what wavelengths should the readings be taken? What instrumentation…

A: Dyes are coloured substances so they are generally analysed in the visible region (400 nm to 800…

Q: Which of the following is the correct order in which light passes through a UV-Vis spectrometer? O…

Q: How would the position of a spectral line change as the separation d between the lines of the…

A: The relation between the position of a spectral line from the central maximum and the separation…

Question

100%

Is Cu(TPP) active in UV-Vis AND why? EXPLAIN YOUR REASON. If you replace Cu2+ with Zn2+ and you have Zn(TPP), what will happen to the UV-vis spectra? EXPLAIN your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

what is the dn electron configuration of Cu(II) ion which peaks on a UV-visible spectrum are d-d transitions and which are charge transfers
[FeF6]3− is almost colourless whereas [CoF6]3−is coloured (and has only 1 band in the visible region ofthe spectrum). why? No handwritten answers please. Thank you!
The absorption spectra of solutions containing Br2 are solvent dependent. When elemental bromine is dissolved in nonpolar solvents such as hexane, a single absorption band in the visible spectrum is observed near 500 nm. When Br2 is dissolved in methanol, however, this absorption band shifts and a new band is formed. Account for the appearance of the new band. Is the 500 nm band likely to shift to a longer or shorter wavelength in methanol? Why?
How does Square Wave Stripping Voltammetry work and why is it important?
What would be the magnetic susceptibility of [Mn(CN)6]4- assuming the spin-only formula applies? (μ = (n(n + 2))0.5) a) 5.92 b) 0.0 c) 1.73 d) 4.90
What would be a reasonable guess for the wavelength of maximum absorbance for FD&C Orange 2?
If you are measuring manganese (Mn) absorption using AAS, which hollow cathode lamp would you select as your source and why?
explain why the intensity of the colours of the three complexes, which can be measured by their extinction coefficients, decreases in the order [CoBr4]^2->[Co(NH3)6]^2+>[Fe(NH3)6]^3+
A solution of compound Z absorbs light of wavelength 256 nm, and for this absorption, log ε=3.3. What is the concentration of a solution of Z (in an optical cell of path length 1 cm) that gives the absorbance reading is 0.21?
What is the major limitation of IR regarding the materials that can be used for instrumental components.
Compute the ionization potential for five-times ionized (Mg11+) and also compute the wavelength of the transition from n=2 to n=1 for that species
Calculate the energy separations in joules, kilojoules per mole, and electronvolts, and as a wavenumber, between the levels (a) n = 3 and n = 1, (b) n = 7 and n = 6 of an electron in a one-dimensional nanoparticle modelled by a box of length 1.5 nm.