The disadvantages of graphite furnace atomic absorption spectroscopy over flame atomic absorption spectroscopy are A. analysis of solutions, slurries and solid samples B. smaller quantities of sample C. low precision D. much more efficient atomization E. greater sensitivity

The disadvantages of graphite furnace atomic absorption spectroscopy over flame atomic absorption spectroscopy are A. analysis of solutions, slurries and solid samples B. smaller quantities of sample C. low precision D. much more efficient atomization E. greater sensitivity

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter31: Introduction To Analytical Separations

Section: Chapter Questions

Problem 31.26QAP

See similar textbooks

Related questions

Q: A student measures the absorbence of an unknown after placing a sample in a cuvette which contained…

A: Given scenario is, A student measures the absorbence of an unknown after placing a sample in a…

Q: how the principle of spectrophotometric experiments? Explain plz thank you

A: Spectrophotometry is a method to measure how much a chemical substance absorbs light by measuring…

Q: A student prepares a solution of his dye and measures its absorbance using a 1 cm cuvette. The…

A: Given: Length of cuvette = 1 cm Absorbance = 0.45 Concentration of the solution = 4.2×10-5 M

Q: Why ATR spectroscopy is superior over FT-IR spectroscopy? Please shortly answer at your own words.…

Q: The purpose of the flame in the atomic emission spectroscopy is for I. Vaporization II. Excitation…

A: There is more than one question,and all are different and as per answering guidelines I can answer…

Q: a forensic toxicologist, you have been given a task on determining amount of cadmium, mercury,…

A: The concept of flame and electro thermal atomic absorption spectroscopy is given as follows-…

Q: Using the trendline from your plot, calculate the absorption of a solution with a concentration of…

A: Equation of the trendline is y = 16.88x - 0.0054 where y is absorbance and x is concentration.

Q: A sample of an alum was analysed by atomic spectroscopy and gravimetrically to determine its…

A: Given data :- A 0.1000 g of the sample when treated with BaCl₂ produced 0.0984 g of a white solid…

Q: How can you use Uv-visible spectroscopy in qualitative and quantitive analysis of drugs? Please…

A: Ans: In that question we have to use Uv visible spectroscopy in qualitative and quantitative…

Q: Flame test is an example of whatb type of atomic spectroscopy? Emmsion Absorption Fluorescence…

Q: Explain why the information from an XPS chemical shift must also be contained in an X-ray absorption…

A: The technique that helps in determination of any matter's electronic structure or geometry is termed…

Q: Draw the fragmented molecular ion for the compound shown above for peaks 127,144 and 159. Thank you.

Q: Why mass spectrometry is called so not as spetroscopy?

Q: All of the following are TRUE about molecular fluorescence spectroscopy, except: A. the sensitivity…

A: Molecular fluorescence spectroscopy is a type of electromagnetic spectroscopy that analyzes…

Q: sources

A: Mössbauer spectrometer is a device that performs Mössbauer spectroscopy, or a device that uses the…

Q: Two solutions of the same UV-absorbing molecule were analyzed by UV-vis spectroscopy on the same…

A: Given the path length of the cell, b = 1 cm Since the two solutions, A and B have the same…

Q: Explain IR spectroscopy as a characterization technique.

A: IR spectroscopy is an supportive technique used for the structure elucidation. The principle of IR…

Q: Part II Data Analytical Wavelength read from the spectra (nm): Absorbance at the analytical…

A: In the quantitative analysis, the concentration of the specific compound that is analyte is…

Q: List three factors that influence the intensity of an IR absorption band.

A: The three factors that influence the intensity of an IR absorption band are: (1) In a bond, there…

Q: Atomic absorption spectroscopy results are highly reproducible but have low sensitivity and…

A: Introduction: The absorption of radiation by free atoms is measured using AAS. The total amount of…

Q: Volume in ml of 2.00 × 10³ M Fe(NO₂) 5 5 5 5 5 Known 1.239 A Test tube # 1 2 3 4 5 2 3 4 5 Test tube…

Q: Using words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can…

A: Atomic Absorption Spectroscopy is a technique used for the quantitative determination of different…

Q: n 1963 javan and townee attained a short term frequency stability of roughly S parts per 10 with a…

A: frequency = S parts per 10 with He-He gas laser therefore variation in frequency…

Q: Question 13 Particles are adsorbed onto a stationary phase is a step in Atomic Absorption…

Q: To improve the accuracy of our linear fit between absorbance and concentration, O a. add an extra…

Q: Explain the Jablonski Diagram of the emission spectroscopy. ‏(Note, I want to get the solution by…

A: The electron is excited by light or heat energy. Electrons absorb the energy and jump to the higher…

Q: Indicate the functional group present for each band in the FTIR spectra. Use the table for the…

A: The chemical formula of ethanol is CH3CH2OH. All the relevant functional groups are listed in the…

Q: Which method, AES or XPS, is better for resolving chemical shifts and

Q: Spectroscopy: Determination of Concentration Using Beer's Law

A: As per the graph, the equation for line is given to be: A=1.9246 (concentration)-0.0151

Q: (a) (i) Illustrate the instrumentation of atomic absorption spectrometry in a flow diagram. (ii)…

A: Atomic absorption spectroscopy is that where the analyte solution is analysis bassed on the amount…

Q: Based on the picture i) Calculate the limit of detection (LOD) and limit of quantitation (LOQ) for…

A: # (i): Given standard deviation, s = 0.0050 Slope of the calibration curve, m = 0.0693 Detection…

Q: What is the concentration of a sample that transmits 70% signal at a certain wavelength upon…

Q: Compare the advantages and disadvantages of the inductively coupled plasma and flames in atomic…

A: The advantages and disadvantages of the inductively coupled plasma and flames in atomic spectroscopy…

Q: What are the processes of concentrate samples analysis in Uv-visible spectroscopy? Please shortly…

A: The absorbance spectra of a compound in solution or as a solid are obtained by Uv-visible…

Q: Sample and Treatment Li (ug/mL) Calibration Method Flame Type 1. None 25.1 standard curve air/CH2 2.…

Q: Why can't we use continuous spectrum source and select necessary wavelengths using monochromator and…

Q: molar absorption has dye coefficient of 1.8 x 105 L mol-1 cm-1 at a wavelength of 606 Find the…

A: This problem can be solved using Lambert Beer Law According to this law A = ε. c. l where , A =…

Q: A 5.020 g sample of dried spinach leaves was digested in 50 mL of 6 mol L-¹ nitric acid. The…

A: Iron content of spinach can be calculated from the calibration curve linear equation.

Q: Why is it important to acquire a reference spectrum and subtract it from the sample’s spectrum?…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Spectrophotomeric Data: (for standard Beer's Law graph) These are Calculated Values mL primary mL…

A: A table of spectroscopic data

Q: True or False a. UV-Vis spectroscopy normally reports data in the from of bands rather than single…

A: a) UV-Vis spectroscopy normally reports data in the from of bands rather than single peaks because…

Q: Flame test is an example of whatb type of atomic spectroscopy? Emmsion Absorption…

Q: how molecular spectroscopy works? what are its advantage and disadvantages

A: Spectroscopy is based on the interaction between light and matter.

Q: Name of Experiment: Flame atomic Absorption spectroscopy (FAAS): Determination of Lead in…

Q: a) Explain the processes occurring during the atomization by Atomic Absorption Spectroscopy. b)Why…

A: The study of interaction of electromagnetic radiation with matter is termed as spectroscopy.

Q: What are advantages to using a furnace instead of a flame in atomic absorption? O higher sensitivity…

A: The correct options are:

Q: Why are instrumental techniques (e.g. UV-vis spectrometry) considered as comparative techniques?

A: Instrumental techniques gives more accurate results for quantitative analysis than conventional…

Q: sing words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can…

A: The flame atomic absorption spectrophotometry is a technique to estimate the amount of metal in the…

Q: Provide one advantage of the additional alternative Infrared (IR) Spectroscopy method over the IR…

Q: Explain why the count rate from the detector straight on from the source is much greater than the…

A: Rutherford conducted alpha particle scattering experiment in which most of the alpha rays passed…

Concept explainers

Spectroanalytical Methods

Spectroanalytical methods measure the wavelength and intensity of radiations that are either emitted or absorbed by a molecular or atomic species. These methods are useful for evaluating the electronic or atomic arrangement of the molecules of a given analyte.

Question

The disadvantages of graphite furnace atomic absorption spectroscopy over flame atomic absorption
spectroscopy are
A. analysis of solutions, slurries and solid samples
B. smaller quantities of sample
C. low precision
D. much more efficient atomization
E. greater sensitivity

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Use the data in Figure 4.8 to estimate the ratio of radiation intensity at 10,000 Å (infrared) to that at 5000 Å (visible) from a blackbody at 5000 K. How will this ratio change with increasing temperature? Explain how this change occurs.
What is laser ablation and how can it he used to sample solids for ICPMS?
Peak or band broadening is more likely to occur in: gradient elution or isocratic elution?
i) Find the differences between the AES and XPS in terms of principle and information obtained from the spectra. ii) Why AFM is mostly utilized microscopic method for the determination of the thickness of the film?
2. a. State TWO (2) advantages of Inductively coupled plasma-optical emissionspectroscopy (ICP-OES) over Flame atomic absorption spectrosocpy (FAAS). b. What are the TWO (2) advantages of graphite furnace AAS (GFAAS)over flame AAS (FAAS)? c.
Derive an expression relating absorbance to the concentrations of standard and unknown ( c subscript s and c subscript x) and the volumes of the standards and unknown ( V subscript s and V subscript x ) as well as the volume to which the solutions were diluted (V subscript t). Derive expressions for the slope and the intercept of the straight line obtained in (a) in terms of the variables listed above.
Discuss and explain the differences that you observe when calibrating with both techniques (AAS and ICP-AES).