Task 1: Sentinel controlled loop Write a program that asks the user for a char input and prints whether the entered character is a vowel or a consonant. The program should keep on asking the user until the user enters a negative value (the negative value is our sentinel value in this case). Sample Interaction: Enter a character: A It is a vowel! Enter a character: F It is a consonant! Enter a character: e It is a vowel! Enter a character: -1 That is my sentinel! Hint: What does all negative values have in common?

Lab 6: Multiplication Table Write a program that will continually ask the user to enter a positive number from standard input and print out the multiplication number table until user enters an alphabet (non number) to quit. Once user enters 'Q' or anything other than a number, the program will print out “Have a nice day" and then exit the program. After reading the user's input the positive number, the program will print out the multiplication table of the inputted number. For example, if user enters 5, the table should be: Multiplication table for 5 is: 2 3 4 5 4 6 8 10 9 12 15 8 12 16 20 5 10 15 20 25 Your program needs continuously ask the user to enter the a positive number until the user enters Q or q to exit the program. Your program must print out your names and lab info as you did in previous lab similar to the following: Program written by: Ron Sha Course info: Cs-102 Lab 6 - Multiplication Table Date: Wed Oct 14 11:35:18 2020 Activate un 1.2345

Customized step counter   Learning Objectives In this lab, you will Create a function to match the specifications Use floating-point value division Instructions A pedometer treats walking 2,000 steps as walking 1 mile. It assumes that one step is a bit over 18 inches (1 mile = 36630 inches, so the pedometers assume that one step should be 18.315 inches). Let's customize this calculation to account for the size of our stride. Write a program whose input is the number of steps and the length of the step in inches, and whose output is the miles walked. Output each floating-point value with two digits after the decimal point, which can be achieved as follows: print(f'{your_value:.2f}') Ex: If the input is: 5345 18.315 the output is: You walked 5345 steps which are about 2.67 miles. Your program must define and call the following function. The function should return the number of miles walked.def steps_to_miles(user_steps, step_length)         # Define your function here  if __name__…

Problem Statement for High and Low Design a program that lets the user enter a series of numbers. The user should enter -99 to signal the end of the series. After all the numbers have been entered, the program should display the highest and lowest number in the series. Part 1. Understand the Problem The program will use a while loop to get the numbers from the user. It is not necessary for the individual numbers to be saved;each number can be evaluated as it is read in. To find the highest and lowest number in the series, use two variables. The variables are initialized by getting the first number from the user and assigning it to both the highest and lowest variables. The assumption is, that if there is only one number in the series it is both the highest and lowest numbers. Inside the loop, each number should be compared to the value stored in the highest variable and its value should replace the value in highest variable if it is greater than the number already there. The same can…