The absorbance values observed during the determination of the complex stoichiometry with the Job method using the spectroscopic method were plotted and the following correct equations were obtained. What is the n value of the compound formed by Fe + 3 and SCN- ions? 1. Line equation: y = 2.6188x + 0.1608 2. Line equation: y = -2.5963x + 2.7203 a) 1 b) 3 c) 0.5 d) 2 e) 5

The absorbance values observed during the determination of the complex stoichiometry with the Job method using the spectroscopic method were plotted and the following correct equations were obtained. What is the n value of the compound formed by Fe + 3 and SCN- ions? 1. Line equation: y = 2.6188x + 0.1608 2. Line equation: y = -2.5963x + 2.7203 a) 1 b) 3 c) 0.5 d) 2 e) 5

Appl Of Ms Excel In Analytical Chemistry

2nd Edition

ISBN:9781285686691

Author:Crouch

Publisher:Crouch

Chapter12: Spectrochemical Methods

Section: Chapter Questions

Problem 16P

See similar textbooks

Similar questions

The absorbance values observed during the determination of the complex stoichiometry with the Job method using the spectroscopic method were plotted and the following correct equations were obtained. According to this, what is the n value of the compound formed by Fe + 3 and SCN- ions?1. Line equation: y = 2.6188x + 0.1608 2. Line equation: y = -2.5963x + 2.7203
The absorbance values observed during the determination of the complex stoichiometry with the Job method using the spectroscopic method were plotted and the following correct equations were obtained. What is the n value of the compound formed by Fe + 3 and SCN- ions? 1. Line equation: y = 2.6188x + 0.16082. Line equation: y = -2.5963x + 2.7203
The molar absorptivity (ε) of the FeSCN2+ complex ion is 4700 M-1 · cm-1 at a wavelength of 450 nm. Using a 1-cm sample tube, you measure the absorbance as (2.0x10-1). What is the concentration of FeSCN2+?
(i) The detection of Mn by graphite furnace atomic absorption spectrometry (GFAAS) is sensitive to the presence of aluminium ions Al3+ which may form refractory compounds such as MnAl2O4. Comment on the possible impact of this compound on the measurements and what action may be taken to minimize this. (ii) Write a brief note on the best practice for the preparation of a calibration curve. (iii) Atomic absorption spectroscopy (AAS) is a powerful technique for the analysis of trace amounts of metals. Describe the two common atomic absorption methods used in the lab with reference to their comparative strengths and weaknesses.
A dual beam UV-visible spectroscopy was used to determine the levels of Fe(II) in the run-off water of a local mine using the ferrozine assay (i) During a check of the instrument a step-like feature at 360 nm was observed in spectrum of the standard. Suggest what may give rise to this with reference to the instrument configuration and comment on how it may be remedied. (ii) The molar absorptivity of the [Fe(Ferrozine)3]2+ complex is 27900 cm−1 M−1 at 562 nm in aqueous solution (pH 5.5). If the EU maximum contaminant level for Fe is 200 ug /L and the contract required detection limit is 100 ug/L, comment on the suitability of the assay for the detection of iron. (iii) Determine the sample range, in terms of concentration and ppm, of Fe(II) that can be confidently analysed by UV-visible spectroscopy using a 1 cm cuvette. Explain with reference to an appropriate equation and solution phenomena, the origin of the limitations that define this range
The absorbance of a 0.1 M solution of a complex was 0.15 at max. What is the value of molar absorptivity for this complex? What is the geometry of this complex?
A. Consider three possible ways in which Cu2+ could sorb to a hematite surface: (1) outer-sphere sorption, (2) inner-sphere sorption, and (3) precipitation as a Cu(II)-hydroxide. Describe the differences in the coordination environment - i.e. identify of the nearest atomic neighbours and interatomic distance within 0.5 nm (5 Å) of a given Cu(II) ion - of each sorption process. You are welcome to draw a schematic illustration to help clarify your text.
Scott test is one of the methods used for screening for Cocaine in Forensic Chemistry. The multi step method consists of a) reacting the sample drug with cobaltous thiocyanate b) dissolving of the formed precipitate by adding HCl and c) extraction of coordination compound with Chloroform d) measurement of absorbance of extracted coordination compound at 627 nm All the reactions in this multistep method are not fully understood. However, it was determined that there are 2 moles of cocaine in coordination compound measured in last step. If coordination compound is represented as “Scott” coordination compound, which of the following is correct “stoichiometric” factor to get mass of cocaine from mass of measured complex ? a.g (Scott coordination cpd) * MM (Scott coordination cpd) MM (cocaine) b.g (Scott coordination cpd) * 2 *MM (Scott coordination cpd) MM…
An absorbance versus concentration data for the thiocyanatoiron(III) complex at 510 nm and makes a Beer's law plot.Based on the plot, what [Fe(SCN)2+] would the student report for a solution that has an absorbance of 0.300 at 510 nm? Also select all below closely matches the procedures to be followed in this experiment and why they are being carried out. 1) A Beer's law plot will be used as a means to determine the equilibrium concentration of the thiocyanatoiron(III) complex. 2)A Beer's law plot will be used to confirm known values of the equilibrium constant for the formation of the thiocyanatoiron(III) complex. 3)To make the Beer's law calibration graph, the formation equilibrium for the thiocyanatoiron(III) complex will be flooded with a large excess of thiocyanate ion. 4)To make the Beer's law calibration graph, the formation equilibrium for the thiocyanatoiron(III) complex will be flooded with a large excess of iron(III) ion.
A metal complex with a Molecular mass of 820 g mol−1 was dissolved and the solution made up to 25 mL in a volumetric flask. 1 mL was withdrawn, placed in a 100 mL volumetric flask and diluted to the mark. The absorbance (at 457 nm) of this solution (in a 1 cm cuvette) was 0.245. The extinction coefficient for this compound at 457 nm (ε530) = 11715 M-1cm-1.(a) calculate the concentration of the compound in the cuvette.(b) calculate the concentration of the compound in the 25mL volumetric flask(c) determine the mass of compound used to make the 25mL solution
The molar absorptivity (ε) of the FeSCN2+ complex ion is 4700 M-1 · cm-1 at a wavelength of 450 nm. Using a 1-cm sample tube, you measure the absorbance as (2.0x10-1). What is the concentration of FeSCN2+? What is your answer? _____________x10^_____
Predict whether the following complexes would show Jahn-Teller distortion: Ammonium pentachlorooxidochromate(V), meff = 1.8 mB Potassium hexaiodidomanganate(IV), meff = 3.8 mB Potassium hexachoridocuprate(II), meff = 1.8 mB Hexaaquamanganese(II) chloride, meff = 6.0 mB