The following consolidation test data were obtained from an undisturbed clay specimen. Pressure (kPa) Void ratio 20 0.958 40 0.948 80 0.938 160 0.92 320 0.878 640 0.789 1280 0.691 320 0.719 80 0.754 20 0.791 1 0.89 (a) Plot the void ratio vs. the consolidation pressure curve on semilogarithmic graph paper, and estimate the pre-consolidation pressure o. (b) Determine the compression index C, for the virgin compression and the rebound index C, for the unloading starting at 1280 kPa. (c) Calculate the coefficient of volume compressibility m, for the virgin compression.

The following consolidation test data were obtained from an undisturbed clay specimen. Pressure (kPa) Void ratio 20 0.958 40 0.948 80 0.938 160 0.92 320 0.878 640 0.789 1280 0.691 320 0.719 80 0.754 20 0.791 1 0.89 (a) Plot the void ratio vs. the consolidation pressure curve on semilogarithmic graph paper, and estimate the pre-consolidation pressure o. (b) Determine the compression index C, for the virgin compression and the rebound index C, for the unloading starting at 1280 kPa. (c) Calculate the coefficient of volume compressibility m, for the virgin compression.

Principles of Geotechnical Engineering (MindTap Course List)

9th Edition

ISBN:9781305970939

Author:Braja M. Das, Khaled Sobhan

Publisher:Braja M. Das, Khaled Sobhan

Chapter11: Compressibility Of Soil

Section: Chapter Questions

Problem 11.4P

See similar textbooks

Similar questions

Experimental data for clay specimen obtained initial values of e1 = 1.12 and P1 = 90 kPa, and final values of e2 = 0.90 and P2 = 460 kPa Solve for the compression index
Data from an oedometer test using a clay specimen are plotted in the graph shown below. If the compression index is equal to 0.6, calculate the void ratio (e2) missing at Point C, which is associated with a vertical effective stress equal to 105 kPa
The figure below shows the soil profile at a site where you plan to lower the water table. You have results from two consolidation tests, one from the upper 12 ft thick overconsolidated crust, and another from the lower 40 ft thick normally consolidated zone. You plan to lower the water table from its current 12 ft depth to 25 ft below ground surface. The consolidation properties for each layer are shown. (Assume that changes in GWT do not affect γt of clay). a. Compute the σ′v in the middle of each layer before and after the water table is lowered b. Determine the total settlement that will result from lowering the water table
Example 9.2: A clay soil, tested in a consolidometer, showed a decrease in void res •m 1.20 to 1.10 when the presure was increased from 0.25 to 0.50 kgflem?. Calculate to. efficient of compressibility (a) and the coefficient of volume compressibility (m). If t •ficient of consolidation (c,) determined in the test for the given stress increment u m?/year, calculate the coefficient of permeability in cm/s. If the sample tested at the site was taken from a clay layer 3.0 m in thickness, determin consolidation settlement resulting from the given stress increment. lution:
The following figure show the relationship between the voids ratio and effective stress for a soil sample collected from the mid depth of a 6 m thick clay layer. The Cc and Cr values have been determined to be 0.3 and 0.04 respectively. For the given information: If the current effective stress at the mid depth is 70 kPa, calculate the ultimate consolidation settlement when the effective stress at mid depth increases by 10 kPa due to an applied load. If the coefficient of consolidation is 0.555 m2/s and the clay layer is single drained, calculate the time taken to reach 45% consolidation.
A specimen of normally consolidated clay was consolidated under a chamber confining pressure of 280kpa for a drained test by how much does the axial stress have to be reduced to cause failure by axial extension?
The figure below shows a 20 m thick layer of normally consolidated clay (ϒt = 18.6 kN/m3) that is one-dimensionally loaded by Δσv = 60 kPa. The clay layer is below a 5 m thick layer of granular fill (ϒt = 19.6 kN/m3), and a dense, compacted glacial till underlies the clay. The water table is located at the top of the clay layer. A 1-D consolidation test is performed on a 3.00 cm thick, doubly drained specimen from the middle of the clay layer. When the stress conditions from the field (including the Δσv = 60 kPa) are applied to this specimen, it takes 1.5 minutes for 60% average consolidation to occur.a. From the lab test data, determine cv for the soil.b. Compute pore water pressure at 20 m depth 7 years after the Δσv is applied to the clay layer. c. Compute the average degree of consolidation 7 years after Δσv application.
A saturated clay sample in an oedometer is under vertical pressure of 120 kPa and is at a normally consolidated state. The void ratio and the sample height at this stage are 1.21 and 18.40 mm respectively. When the vertical stress was increased to 240 kPa at the end of the consolidation, the thickness of the sample was reduced to 16.80 mm. When the vertical pressure was reduced to the original value of 120 kPa, the sample heaved to a thickness of 16.95 mm. Estimate both the compression index and recompression index of the clay. What would be the reduction in thickness from now if the vertical pressure was increased by 200 kPa? What is the average coefficient volume compressibility during this pressure increment?
The figure below shows a 24 m thick layer of normally consolidated clay (ϒt = 18.6 kN/m3) that is one-dimensionally loaded by Δσv = 100 kPa. The clay layer is below a 4 m thick layer of granular fill (ϒt = 19.6 kN/m3), and a dense, compacted glacial till underlies the clay. The water table is located at the top of the clay layer. A 1-D consolidation test is performed on a 2.50 cm thick, doubly drained specimen from the middle of the clay layer. When the stress conditions from the field (including Δσv = 100 kPa) are applied to this specimen, it takes 6 min for 90% average consolidation to occur.a. From the lab test data, determine cv for the soil.b. Compute the pore pressure at depth 22 m before and immediately after the 100 kPa stress is applied.c. At depth 22 m, compute the pore pressure 8.5 years after the 100 kPa is applied.
For a given consolidated clay: Gs= 2.71; LL= 45; In situ average effective overburden pressure = 120 kPa; In situ void ratio= 0.80 ; Thickness of clay layer = 4m ; average increase of effective stress on clay layer= 40 kPa; Effective pressure at the mid-height of clay layer= 60 kPa; Swell Index (Cs)= 1/5 Cc. Compute the pre-consolidation pressure in kPa. Show free body diagram a.92.9 b.100.5 c.49 d.87.64
17. The results of a consolidated drained test for a normally consolidated clay were as follows: chamber confining pressure = 300 Kpa and deviator stress = 400 KPa a. Compute the angle of friction of the clay sample b. Compute the shear stress at failure plane c. Compute the normal stress on the plane of maximum shear.
A 75 mm diameter clay specimen was consolidated in an oedometer under 200 kPa. At the end of consolidation, the void ratio is 0.863 and the specimen thickness is 18.51 mm. When the stress increment of 200 was added to the current vertical stress of 200 kPa, the specimen consolidated to a thickness of 17.56 mm. Assuming that the clay was normally consolidated under the vertical stress of 200 kPa, find the a) coefficient of volume compressibility in (MPa)^-1 and rounded to the 3rd decimal place.b) and the compression index of the clay rounded to the 2nd decimal place.